Get support for 2008 Suzuki Grand Vitara

2008 Suzuki Grand Vitara Support Question

2008 Suzuki Grand Vitara Support Question

Find answers below for this question about 2008 Suzuki Grand Vitara.
Need a 2008 Suzuki Grand Vitara manual? We have 1 online manual for this item!
Question posted by otrebor2006 on September 12th, 2014

The Blue Key Signal Is On When Attempt Starting Vehicle. Does Not Start

The engine does not start and the shift is locked so I cannot move the vehicle out of the way. The seems to be a problem with the electronic key, but the physical key does not work either.

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Manual Pages

Owner's Manual - Page 9

... regulations. This check is performed approximately five hours after the engine is normal and does not indicate a malfunction. Modification could adversely affect safety, handling, performance or durability and may cause electronic interference with your vehicle's ignition system, resulting in vehicle performance problems. Consult your SUZUKI dealer or qualified service technician for advice...
Owner's Manual - Page 12

...vehicle performance problems resulting from the use of fuel meets the requirements listed above. If fuel is not covered under the New Vehicle Limited Warranty. 1-1 Fuels containing alcohol can cause paint damage, which is spilled on the vehicle...areas, pumps may provide enough information for use in your vehicle if they contain cosolvents and corrosion inhibitors. FUEL RECOMMENDATION ...
Owner's Manual - Page 17

... flash once. When the doors are locked, the turn signal lights will turn on the surroundings, especially near the vehicle. 2-4 Press the "PANIC" button ...key in the ignition switch or insert the key during this section. • You can start to "Ignition Switch" in the "STEERING COLUMN CONTROLS" section and "Starting the Engine" in the ignition switch. If any button (PANIC, LOCK...
Owner's Manual - Page 19

... operate normally. • The remote controller will not be able to lock or unlock the doors or start the engine. • Be sure that the old code is erased, or perform the programming procedure yourself according to four remote controllers and ignition keys for a replacement. Some additional precautions you should take and information you...
Owner's Manual - Page 23

... perform the programming procedure yourself according to the instructions in the middle position, the interior light will turn signal lights will start to fade out immediately. When the doors are unlocked: • The turn signal lights will flash twice. • If the interior light switch is inserted in your SUZUKI dealer as soon...
Owner's Manual - Page 29

... • You should always lock the passenger's window operation when there are children in a parked vehicle. Mirrors Inside Rearview Mirror WARNING • Always adjust the mirror with one of your vehicle in the path of the electric windows when closing them. • Always remove the ignition key when leaving the vehicle even if a short time...
Owner's Manual - Page 30

...driver's seat and seatback are properly adjusted before the seat belts are adjusted before you start driving. (1) (1) (2) (4) (3) (2) (4) (3) WARNING 64J015 64J014 Adjust the outside... the power rearview mirrors is in which reduces the effectiveness of a vehicle or other object seen in a flat mirror. 2-17 Make sure ...attempt to the direction in the "ACC" or "ON" position.
Owner's Manual - Page 39

...works in the same manner as the driver's seat belt reminder, except that the anchor is turned to the "ON" position. The belt should be activated from your face and neck, but not falling off . If the vehicle is not driven (vehicle speed < 8 km/h), Reminder 2 will operate when driving starts (vehicle...is securely locked. In ...key in the "ON" position, the driver's seat belt reminder works...
Owner's Manual - Page 62

... normal use of the steering wheel after the key is removed. • Manual transmission vehicles You must be in which the key can be removed. It is the normal parking position. STEERING COLUMN CONTROLS Ignition Switch Vehicle Without Keyless Start System EXAMPLE Manual transmission Push Turn to "LOCK" 65D611 60A055 WARNING To avoid possible injury, do...
Owner's Manual - Page 63

... cluster, you to the "ACC" position. Ignition key reminder (if equipped) A buzzer sounds intermittently to remind you can operate, but the engine is in again to protect the system. To return to the "ACC" position when the keyless start system blue indicator light illuminates on . Vehicle With Keyless Start System (3) (2) (4) (1) EXAMPLE 66J022 63J270 The ignition switch...
Owner's Manual - Page 64

... released from magnetic objects such as by inserting the ignition key into the slot. 3-3 ACC (2) Accessories such as the engine starts. For vehicles with an automatic transmission, the gearshift lever must push the ignition switch in the "ACC" position when the driver's door is a sensitive electronic instrument. NOTE: • If the battery of the remote...
Owner's Manual - Page 65

... if the engine is moving. If the engine does not start after several attempts, check the fuel and ignition systems or consult your SUZUKI dealer. • Do not leave the ignition switch in the normal way, removing the cover (1) and pushing the release button using a key or some other positions. The steering wheel will lock and you...
Owner's Manual - Page 84

... red. If this light comes on until all of the turn signal lights. When you push the ignition switch for vehicle with the keyless start system, this light comes on in blue, you can not turn the ignition switch without using an ignition key. INSTRUMENT PANEL Open Door Warning Light "SET" Indicator Light (if equipped...
Owner's Manual - Page 133

...stopping distances or permanent brake damage. Depressing the brake pedal applies both sets of the engine. This is a normal condition caused by environmental factors such as cold, wet, snow,...output and speed. 65D449 Brake Pedal (2) Your SUZUKI vehicle is used to disengage the drive to the wheels when starting the engine, stopping or shifting the gearshift lever or transfer lever. You may hear...
Owner's Manual - Page 144

... of the driver's side of the sunroof opening while the vehicle is moving. • Be sure there are no hands or other obstructions in a parked vehicle. Engine Hood 65D612 64J110 WARNING • Never allow any dirt has accumulated. This will disengage the engine hood lock halfway. 5-13 OTHER CONTROLS AND EQUIPMENT CAUTION Do not put...
Owner's Manual - Page 161

... the hood securely after use. 4) Make sure the hood is fully closed and latched before attempting to re-start the engine while the vehicle is normal for lubrication schedule. Automatic Transmission - If the gearshift lever is not in "P" (Park) position, shift into "P". (If you fill your view and resulting in the "INSPECTION AND MAINTENANCE" section...
Owner's Manual - Page 162

... to the "LOCK" position from the "LOCK" position to the "ACC" position when the keyless start , try , wait about 15 seconds, then press down the accelerator pedal to 1/3 of the remote controller may be turned to the "ACC" position. OPERATING YOUR VEHICLE Starting a Cold Engine With your SUZUKI dealer. Release the key when the engine starts. The blue indicator light...
Owner's Manual - Page 201

... sure the transfer switch is not in "N" (Neutral). (Continued) 8-6 VEHICLE LOADING AND TOWING WARNING (Continued) • Avoid "riding" the brakes. "Riding" the brakes could cause the brakes to overheat, resulting in the clutch (if equipped) and start the engine. 2) Depress the brake pedal, shift into gear, release the parking brake and slowly pull away...
Owner's Manual - Page 272

...8226; Signals from the police or similar government office, as part of SUZUKI's defense of safer vehicles. GENERAL INFORMATION On-Board Vehicle Computers and Event Data Recorders Your vehicle is equipped...conducted by law. This stored information can help the driver control the vehicle in your vehicle has an Electronic Stability Program (ESP®) system, conditions such as yaw rate, ...
Owner's Manual - Page 285

...K Keyless Entry System Transmitter (Type B) ...2-10 Keyless Start System Indicator Light ...4-9 Keyless Start System Remote Controller (Type A) ...2-3 Keyless Start System Remote Controller/ Keyless Entry System Transmitter ...2-3 Keys ...2-1 O Odometer ...4-11 Off-Road Driving ...7-4 Oil Level Check ...9-10 Oil Pressure Light ...4-7 On-Board Vehicle Computers and Event Data Recorders ...12-3 On...

Similar Questions

Ask a New Question
Use the box below to post a new question about this Suzuki automobile .
Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

Suzuki Manuals

Find free 2008 Suzuki Grand Vitara manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Suzuki Reviews

View thousands of Suzuki user reviews and customer ratings available at ReviewOwl.com.

Contact Information

Complete Suzuki customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Suzuki customer service rankings, employee comments and much more from our sister site.

Suzuki Recalls

Find comprehensive Suzuki recall information updated hourly on RecallOwl.com.