2008 Subaru Forester Support Question
2008 Subaru Forester Support Question
Find answers below for this question about 2008 Subaru Forester.Need a 2008 Subaru Forester manual? We have 1 online manual for this item!
Question posted by nightbra on February 5th, 2014
How To Remove Headlight Light Assembly 2008 Subaru Forester
The person who posted this question about this Subaru automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 4
... come with a brief table of fourteen chapters. and sold at retail by an authorized SUBARU dealer in this manual. For that chapter contains the information you how to remove HID headlights before vehicle disposal. Anti-Corrosion Warranty . Vehicle without HID headlights
How to use the instruments and other switches.
- CONTINUED -
CAUTION
This vehicle does...
Owner's Manual - Page 6
... outlets Instrument panel outlets and foot outlets Instrument panel outlets Fan speed Illumination brightness Headlight beam leveler Name Mark Seat heater Child restraint top tether anchorages Name Mark Name Parking lights, tail lights, license plate light and instrument panel illumination Headlights
3
Vehicle symbols
There are some of the symbols you may see on your vehicle...
Owner's Manual - Page 13
10
Illustrated index
& Exterior
1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 11) Headlight switch (page 3-20) Replacing bulbs (page 11-46) Engine hood (page 11-4) Wiper switch (page 3-25) Roof rails (page 8-13) Door locks (page 2-4) Tire pressure (page 11-33) Flat tires (page 9-4) Tire chains (page 8-10) Front fog light button (page 3-24) Tie-down/Towing hooks (page 9-12)
Owner's Manual - Page 18
... (page 3-26) Rear window wiper and washer switch (page 3-26) 6) Wiper control lever (page 3-25) 7) Illumination brightness control (page 3-23) 8) Light control lever (page 3-20) 9) Headlight ON/OFF (page 3-20) 10) Headlight flasher High/Low beam change (page 3-21) 11) Turn signal (for lane change) (page 3-22) 12) Turn signal (page 3-22)
- CONTINUED -
Owner's Manual - Page 41
...is still not fastened 6 seconds later, the warning light will flash for 15 seconds. When the child restraint system is removed, make sure that the seatbelt is running. between...'s seatbelt is flashing. For instructions on your SUBARU dealer.
& Fastening the seatbelt
WARNING
. Alternate flashing and steady illumination of the warning lights and sounding of sliding under the seatbelt in ...
Owner's Manual - Page 50
...an operating noise will be replaced.
WARNING
. Do not modify, remove or strike the front seatbelt retractor assemblies or surrounding area. Once the seatbelt pretensioner has been activated, the ... this chapter. . Pretensioners are normal and not harmful. When replacing seatbelt retractor assemblies, use only genuine SUBARU parts. . When you sell your vehicle, we urge you to explain to ...
Owner's Manual - Page 71
...the Subaru advanced frontal airbag system. Have the system inspected by the Subaru advanced frontal airbag system.
1) U.S.-spec. If your SUBARU dealer immediately if the SRS airbag system warning light comes... switch is spilled, wipe it after each use front seats with the head restraint removed. . Do not remove or disassemble the front passenger's seat. . Do not use . (Refer to ...
Owner's Manual - Page 98
...Be careful not to synchronize the unit.
& Replacing lost transmitters
2. Keys and doors
2-9
5. The turn signal lights will begin to four can be programmed), you lose a transmitter or want to indicate completion of the transmitter case ... While still holding down the "UNLOCK" side of your SUBARU dealer.
1)
Negative (−) side facing up
1. Remove the old battery from Step 1.
Owner's Manual - Page 102
... sound for deactivation yourself or have it done by your SUBARU dealer. Opening a door or the rear gate. . Disarm...the remote transmitter. . The alarm is inserted into your vehicle. Remove the key from the "LOCK" to "ON" position 3 times ... and the rear gate. 3. The horn sounds and the turn signal lights will give the following operations: . To arm the system using remote ...
Owner's Manual - Page 116
... "Acc" positions. Take your vehicle to the nearest SUBARU dealer immediately to the "LOCK" position even when the selector lever is removed from the ignition switch.
Instruments and controls
3-5
contains ...in the dark, the ignition switch light comes on when the driver's door is near or touching another transmitter. After closing the door, the light remains lit for 5 seconds and then...
Owner's Manual - Page 123
... the cap will not make the CHECK ENGINE warning light turn off immediately. Reduce the amount of the cap. Reduce vehicle speed. . Remove the cap and retighten it until it may damage ...have your vehicle checked by an authorized SUBARU dealer immediately.
& Charge warning light
If this light comes on .
You should do the following. . If the light comes on while driving or does ...
Owner's Manual - Page 135
...tank is dry. CAUTION
The front fog lights operate only when the headlights are on a dry windshield or rear ...SUBARU Windshield Washer Fluid or the equivalent. However, the front fog lights turn the front fog lights on the wiper. . In freezing weather, be damaged but also the wiper motor to the window glass could burn out even if the wiper switch is turned off when the headlights...
Owner's Manual - Page 194
...of the ashtray and pull it to stick and overheat, creating a potential fire hazard. To remove the ashtray for cleaning, hold the right and left sides of the ashtray's inner lid. ... reduce residual smoke. This could cause a fire. To open the ashtray, push lightly on ashtray, which is available from your SUBARU dealer. Interior equipment
6-11
power a plug-in the front pocket. The ashtray...
Owner's Manual - Page 221
...vehicle is equipped with Vehicle Dynamics Control, have an authorized SUBARU dealer perform an inspection of the same size, type, ... Vehicle Dynamics Control operation indicator light. . Furthermore, the amount of the Vehicle Dynamics ...Always use the utmost care in driving - overconfidence because you are removed from a vehicle equipped with Vehicle Dynamics Control, winter tires or...
Owner's Manual - Page 278
...or polish when the painted surface is always best to clean the wheels. Always polish in removing the paint layer and exposing the undercoat. Keep a good distance of the surface. If ... . Never use soap containing grit to contact your SUBARU dealer or an auto paint specialist. clean of any kind of wax be restored, lightly polish the surface with a fine-grained compound.
After...
Owner's Manual - Page 325
...the circuit for repairs. Check the main fuses if any lights, accessories or other fuses are designed to melt during .... 2.
Determine which fuse may be replaced. Contact your nearest SUBARU dealer. Inspect the fuse. A melted main fuse must be blown... and electrical equipment. The back side of the same rating. 6. Remove the cover. 3.
Main fuse box
The main fuses are good. If...
Owner's Manual - Page 329
... (low-beam and highbeam), removal and installation of the headlight assemblies, and removal of the headlight aim. . If you attempt to break. These HID bulbs use . Neither should not attempt to replace the bulbs. Low beam light bulbs
NOTE
. Remove the bulb cover, by turning it counterclockwise.
& Headlights (Vehicle without HID headlights)
CAUTION
Halogen headlight bulbs become very hot...
Owner's Manual - Page 330
Maintenance and service
11-49
securely. 5. Install the bulb cover. ! High beam light bulbs
2. Remove the bulb from the bulb.
3. At this time, use care not to the headlight assembly, turn it clockwise until it counterclockwise. 3. Reconnect the electrical connector. Remove the retainer spring, then pull out the bulb and electrical connector unit.
1. To install the...
Owner's Manual - Page 331
... Set the bulb holder into the rear combination light assembly and turn signal light Tail/stop light
2. Pull the bulb out of the socket. Tighten the mounting screws. 11-50
Maintenance and service
& Rear combination lights
& License plate light
1. Remove the cover and lens. 3. Reinstall the rear combination light assembly.
1. Install a new bulb. 4. Then, slide the rear combination...
Owner's Manual - Page 332
Reinstall the cover. 4. Have your SUBARU dealer replace these bulbs if necessary.
1.
Install a new bulb. 3. Pull the bulb from the socket. Remove the mounting screws using a Phillips screwdriver and then remove the high mount stop light
Dome light
1. Map light
NOTE
Other bulbs may be difficult to replace. Pull the bulb out of the lens with a flat...
Similar Questions
How To Remove The Rear Combination Light Assembly From The 2008 Subaru Forester
(Posted by tolzphil 9 years ago)
How To Remove Head Light Assemble On 2007 Subaru Forester
(Posted by rebergii 10 years ago)
How Do You Change A Low Beam Headlight On A 2008 Subaru Forester
(Posted by mylesbar 10 years ago)