2003 Subaru Legacy Support Question
2003 Subaru Legacy Support Question
Find answers below for this question about 2003 Subaru Legacy.Need a 2003 Subaru Legacy manual? We have 1 online manual for this item!
Question posted by p90x on June 23rd, 2013
2003 Subaru Legacy Started Then Died And Now Won't Start
This morning my subaru started and then died before I could even change gears. It's been running fine until now. Couldn't even jump start it with my other car or push start. Radio not turning on, park lights working but dim. Slight clicking noise when I turn the key but engine not turning over at all.There's fuel in the car. Hazard lights work and inside lights plus dashboard light up when key is turned. Does anyone know what the problem could be?Thanks in advance
Current Answers
Answer #1: Posted by TexasDeviL on March 10th, 2014 10:48 PM
TexasDeviL
Member since:
December 27th, 2012 Points: 960,825
Member since:
December 27th, 2012 Points: 960,825
Related Manual Pages
Owner's Manual - Page 103
....
2
NOTE
With the valet mode selected, the security system does not operate and the parking lights do not flash when the remote transmitter is triggered by: D Opening a door, the rear... alarm indications when triggered: D The turn signal lights flash if someone attempts to prevent starting the vehicle without a key. The horn sounds and the turn signal lights will flash and the horn will not...
Owner's Manual - Page 104
...(and the trunk lid) are not properly closed , an electronic chirp sounds five times, the turn signal lights will automatically lock.
2-14 Open the doors and get out of the doors, (rear gate ... time, the turn signal lights flash five times to alert you close the door, the system will automatically arm and doors will flash one time and the indicator light starts flashing slowly (approximately...
Owner's Manual - Page 105
Remove the key from the ignition switch. 3. Push the power door locking switch forward ("LOCK" side) to inform you that the system ...will sound two times, the turn signal lights will flash one time and the indicator light will go off. An electronic chirp will sound one time, the turn signal lights will flash two times and the indicator light will start flashing slowly (approximately once every ...
Owner's Manual - Page 109
... indications. Keys and doors
the transmitter. The number of times the indicator light flashes indicates what sensor caused the alarm condition. Flashing four times: The ignition switch has been turned on or the battery has been disconnected.
2
NOTE
The battery must be reconnected before the indicator light will start flashing. The indicator light will flash.
Owner's Manual - Page 128
... is the normal operating position after the engine is started.
3-4 B ACC In this position the electrical accessories (radio, accessory power socket, etc.) can be used. n Manual transmission vehicles
OM-H0144
The key can be turned from "ACC" to "LOCK" only when the key is pushed in the "P" position. n Automatic transmission vehicles
HB4016BA
HB2032CA
The...
Owner's Manual - Page 139
...
- CONTINUED -
3-15 D The VDC warning light does not come on after the engine has started and stays lit even when the vehicle speed reaches about 8 mph (12 km/h). D The VDC warning light remains on when the ignition switch is running. D The warning light comes on while the vehicle is turned to the low battery voltage and...
Owner's Manual - Page 145
... the headlights are not turned on at reduced brightness when the engine has started, under the following conditions: D The parking brake is fully released. To switch back to low beam, pull the lever back to high beam, push the turn signal lever forward. Instruments and controls
B High/low beam change (dimmer) To change from low beam to...
Owner's Manual - Page 155
... not complete when you restart your vehicle, you start driving. The indicator light located on the windshield wiper deicer, remove any snow from headlights.
- CONTINUED -
3-31 Push it off. The windshield wiper deicer will automatically shut off when the ignition switch is operating. It also turns off after about 15 minutes. The night position...
Owner's Manual - Page 202
... "p" or "w" positions. B FM/AM selection button (FM/AM) Push the "FM/AM" button 4 when the radio is in the following order:
5-18 To change in the volume control.) Fader (FADER) Balance (BALANCE) Volume (VOLUME)
n Display illumination dimness cancellation (BRIGHT) The brightness of the radio display dims when the light switch is off to the "p" or "w" position makes...
Owner's Manual - Page 212
...VOL)
n Display illumination dimness cancellation (BRIGHT) The brightness of the "FAD/BAL" button 6 changes control modes in the following sequence starting from fader control mode. (When the radio is turned on , the control ... 7 again for each mode by turning the volume control dial. To change control modes: Each brief press of the radio display dims when the light switch is in the "p" or ...
Owner's Manual - Page 256
... painted surface, rinse it clockwise until you spill any more fuel. 4. If you hear a clicking noise. Close the fuel filler lid completely. Put the cap back on the right side of the vehicle. 7-6 Remove the fuel filler cap by turning it slowly counterclockwise. 3. NOTE
HG3016AA
D You will see the "FUEL DOOR p" sign in...
Owner's Manual - Page 257
... inspection or service station in advance not to the "Warning and indicator lights" section located in uncontrolled vehicle movement and may come on a single two-wheel dynamometer. Starting and operating
D If the fuel filler cap is not tightened until it clicks or if the tether is caught under the cap, the CHECK ENGINE...
Owner's Manual - Page 263
To change gears, fully depress the clutch pedal, move the shift lever, and gradually let up on the shift lever knob. ...the following table. When shifting from 5th gear to reverse gear, first return the shift lever to 5th mph (km/h) 15 (24) 25 (40) 40 (65) 45 (73)
7
- CONTINUED -
7-13 If it is difficult to shift into reverse gear.
Starting and operating
OM-H2241
The shift pattern is...
Owner's Manual - Page 285
... switch is jump started, the ABS warning light may not be considered normal. When driving with an insufficient battery voltage such as when the engine is turned to operate normally. Starting and operating
This is an indication that the ABS system is as described below, the ABS system may be working properly. D The warning light remains on...
Owner's Manual - Page 287
...light. NOTE
D Slight twitching of the brake pedal may be noticed in this situation. These are normal characteristics of the VDC operation indicator light. Activation of this function is normal.
This noise...of activation of the brakes, certain situations may occur just after starting the engine, a shortlived operation noise may be noticed coming from the engine compartment. D In the...
Owner's Manual - Page 290
... be operating normally. NOTE
When the VDC warning light turns on when a problem occurs with care and have an authorized SUBARU dealer carry out an inspection of those systems at the first available opportunity. D Although turning on after the engine has been started and does not turn on and off either when the engine is being...
Owner's Manual - Page 334
...failure of the spare tire and/or less stability of the turn signals, the brake lights and parking lights each time you carry a regular size spare tire in ...electrical system requires modifications to the vehicle's lighting circuit to increase its capacity and accommodate wiring changes. To ensure the trailer lights are properly inflated. The temporary spare tire... lights to your SUBARU dealer.
Owner's Manual - Page 335
... employ extra caution when towing a trailer and you should also keep the following tips in mind: n Before starting out on hot days. You should never speed. D Check that the trailer's turn signal lights flash when the vehicle's turn signal lever is tipped sharply up .
D When towing a trailer, steering, stability, stopping distance and braking performance...
Owner's Manual - Page 405
Start the engine again and run for 30 seconds. The distance the pedal travels should move slightly down to check the..., stop the engine and keep the pedal depressed for about one minute then turn it checked by your SUBARU dealer. 1. Brake booster operates properly if the pedal stroke decreases with each ...brake pedal depressed, start the engine. The pedal height should not change. 4.
Owner's Manual - Page 409
... N, 15 kg].) 3. Repeat this , be selected for the parking brake to lock. Check the parking brake stroke. With the parking brake release button pushed in this condition. 4. Wait 5 to 10 minutes for break-in the "Warranty and Maintenance Booklet". If the parking brake lever stroke is fully applied by turning the adjusting nut located on the...
Similar Questions
Why Are My Parking Lights Never Going Off On My 94 Subaru Subaru Legacy Wagon
(Posted by riptidebm907 1 year ago)
Where Is Fuse For Rear View Mirror - Lighter - Back Up Mirror
The lighter/power adapter of my 2003 legacy wagon shorted out and now the outlet, my rear view mirro...
The lighter/power adapter of my 2003 legacy wagon shorted out and now the outlet, my rear view mirro...
(Posted by valdezsr 8 years ago)
2000 Subaru Legacy Starts To Run Hot When Driving Not In Idle
(Posted by aclk 10 years ago)
Subaru Legacy Gt Wagon 2003 How To Replace Tail Light
(Posted by MiColum 10 years ago)