1999 Subaru Legacy Support Question
1999 Subaru Legacy Support Question
Find answers below for this question about 1999 Subaru Legacy.Need a 1999 Subaru Legacy manual? We have 1 online manual for this item!
Question posted by marygomez on June 8th, 2013
My 99 Subaru Legacy Makes A Loud Noise When You Turn The Key But Doesn't Start
i already changed the fuel filter and the spark plugsand checked the alternator so whats wrong please help my car is part of my job without it i cant work
Current Answers
Related Manual Pages
Owner's Manual - Page 32
To unlock the door, turn the key toward the front. NOTE Make sure that all doors and the rear gate are locked before locking the doors from the outside without the key Front door
1 Press the lock lever. 2 Close the door while
holding the handle up. Locking without the key, press the end of the lock...
Owner's Manual - Page 36
Doors and locks
Door open warning lights
HB0230
HB0010
Your vehicle is . When all doors are out before starting to drive.
- CONTINUED -
1-9 Always make sure these lights are properly closed , a light comes on indicating specifically which door it is equipped with door open warning lights go out. When a door is not fully closed , all of the door open warning lights.
Owner's Manual - Page 61
... the fuel filler cap, turn it may not fit or have proper venting, and your fuel tank and emission control system might be sure to prevent fuel spillage in the event of an accident. If you use a genuine SUBARU fuel filler cap. D Always use the wrong cap, it slowly counterclockwise and remove the cap.
1-34
J Fuel filler cap
D Make...
Owner's Manual - Page 62
...which may come on , turn it clockwise until you hear a clicking noise. If it is not, it off immediately. Such damage is properly locked before you spill any more fuel.
Doors and locks
To... -
1-35 Engine hood
WARNING
Always check that the hood is not covered under the cap while tightening. Refer to catch the cap tether under the SUBARU Limited Warranty. Be certain not to the...
Owner's Manual - Page 113
...-
2-39 D Failure of a malfunction indicated by lighting for about 6 seconds when the ignition key is first turned to the "ON" position. Seat, seat belt and SRS AIRBAG
J System monitors
HB0238
A diagnostic... SRS AIRBAG while the vehicle is first turned to the "ON" position and then turning off. D Illumination of the warning light. Unless checked and repaired, the SRS AIRBAG will show...
Owner's Manual - Page 125
...CHECK ENGINE warning light/Malfunction indicator lamp
CAUTION
If the CHECK ENGINE light comes on while you are driving, have your vehicle checked by your SUBARU... system warning light should have your vehicle checked/repaired by a SUBARU dealer immediately. B Brake fluid level warning... that there is fully released. Have your vehicle checked by your vehicle's warranty. It goes out when...
Owner's Manual - Page 126
... vehicle speed. If the warning light behaves as possible. It may take your vehicle checked by an authorized SUBARU dealer immediately. The CHECK ENGINE warning light may not work properly. Tightening the cap will not make the CHECK ENGINE warning light turn off immediately. If the light does not go out, take several driving trips. This is...
Owner's Manual - Page 193
... button. Before the ignition switch turn to play back stops and the cassette tape is reached. The " " indicator will light up and high-frequency noise on the tape will begin playing... and the player will be reduced for clearer sound reproduction.
* Noise reduction system manufactured under license from the player. Always make certain that you remove the cassette tape. J Dolby NR button ...
Owner's Manual - Page 244
... have the key interlock system repaired. Turn the ignition key while pressing the key interlock release lever. The chime stops when the key is removed from the tool bag. 2.
Starting the engine
CAUTION
Do not operate the starter motor continuously for ten seconds or more than ten seconds. Take your vehicle to the nearest SUBARU dealer immediately...
Owner's Manual - Page 245
... pressed fully to the "ON" position and check the operation of a moving , shift the selector lever into the "P" position. 1. Turn the ignition switch to place the selector lever of the warning and indicator lights. Release the key immediately after the engine has started . Do not attempt to the "START" position without depressing the accelerator pedal...
Owner's Manual - Page 246
... the parking brake is difficult to start , it may be flooded (excessive fuel in the engine). While the engine is warming up . J During cold weather below - 4°F (- 20°C) If the engine is applied. Starting and operating
5. Turn the ignition switch to the "START" position without depressing the accelerator pedal), turn the starter motor for five...
Owner's Manual - Page 259
... out of its housing (by lifting with your nearest SUBARU dealer for repairs.
7-28 Turn the link counterclockwise as far as possible.
The device is located inside the engine compartment under the brake fluid reservoir (big yellow cap). Consult your finger). 5. Make the loop
Turn the link clockwise
OM-H2364 OM-H2365
3. Find the...
Owner's Manual - Page 263
...checked by your SUBARU dealer.
7-32 The brakes will be needed to assist braking force. If one circuit of the brake system should fail, the other half of the system still works. Do not turn...work even when the brake booster completely stops functioning. If one circuit fails, the brake pedal will turn off the brake booster, resulting in poor braking power. If a squeaking or scraping noise ...
Owner's Manual - Page 267
...on the driver's side. Therefore, your SUBARU AWD vehicle may result in handling, however...SUBARU AWD can also provide added traction during acceleration, and added engine braking force during extremely sharp turns...36 Therefore, when driving down a slope or turning corners, be placed on the tire placard. D...the vehicle. D When replacing a tire, make sure you should always be sure to reduce ...
Owner's Manual - Page 268
...models except OUTBACK and SUS Your AWD vehicle is a passenger car designed primarily for general guidance. Do not take your Subaru can be taken: D Make certain that your passengers are wearing seat belts. D Carry ...signs and the like.
- CONTINUED -
7-37 Starting and operating
sharp turn, during sudden braking or under other than those conditions could easily lead to a serious accident...
Owner's Manual - Page 271
...contains an antifreeze solution. While warming up the vehicle before driving, check that has accumulated under the fenders to avoid making steering difficult. If the door is safe to melt the ice, ...weather since it is frozen, use engine antifreeze or other controls operate smoothly. cold winter starts. Place the shift lever in "1" or "R" for manual transmission vehicles, and in ...
Owner's Manual - Page 281
Make sure that all the tires on your vehicle are inflated to the pressure specified on the tire placard located on the left center pillar of your authorized SUBARU dealer concerning the connection of wires for correct operation of the turn signals and brake lights each time you hitch up. Check for trailer lights. Use...
Owner's Manual - Page 292
...with the trailer attached. D Avoid uneven steering, sharp turns and rapid lane changes. D Check that the vehicle and trailer are acceptable. D Check that the tire pressures are apparent, do not tow... of control. Starting and operating
B Before starting out on a trip D Check that the load and its distribution are connected properly. Make a longer than normal turning radius because the...
Owner's Manual - Page 324
... in accidental inflation of the fuel filter should be dangerous. Removing rings, watches and ties is running D A running and remain hot for easy identification. Tampering with yellow insulation and the connectors of the SRS AIRBAG, see your nearest SUBARU dealer. D Always let the engine cool down. D Always remove the key from moving engine parts...
Owner's Manual - Page 355
... then turn it checked by your SUBARU dealer.... 1. With the engine off . The pedal height should not vary. 2. Brake booster operates properly if the pedal stroke decreases with each time. The distance the pedal travels should not change. 4. Depress the brake pedal several times, applying the same pedal force each depression.
- CONTINUED -
10-35 Start...
