Stihl KM 110 R Support Question
Stihl KM 110 R Support Question
Find answers below for this question about Stihl KM 110 R.Need a Stihl KM 110 R manual? We have 1 online manual for this item!
Question posted by danbrooks69 on August 12th, 2013
Wont Come Up To Speed Or Idle
Installed carb kit and new hoses with filter. Cleaned muffler. It will run but not upm to speed. It will rev up if I push the primer bulb but stay there.
Current Answers
Related Stihl KM 110 R Manual Pages
Product Instruction Manual - Page 2
... the Engine ........ 17 Operating Instructions 20 Cleaning the Air Filter 21 Motor Management 21 Adjusting the Carburetor 21 Spark Arresting Screen in Muffler ... 23 Checking the Spark Plug 24 ... Incorporated California Exhaust and Evaporative Emissions Control Warranty Statement 36 Trademarks 38
STIHl
KM 110, KM 130
English / USA
Allow only persons who understand the manuals of the ...
Product Instruction Manual - Page 3
... tool. Example:
Loosen the screw (1) Lever (2) ...
2
KM 110, KM 130 Because this power tool is to continually improve all of... Using this Manual
!Warning! The KombiEngine and KombiTool come with separate instruction manuals.
English / USA
KombiSystem
Guide...description of personal injury. STIHL's philosophy is a high-speed working tool, some special safety precautions must be combined ...
Product Instruction Manual - Page 4
...KM 110, KM 130
3 Such paragraphs are marked with the symbols described below:
Warning where there is not essential for using it understands the information contained in these manuals.
Because this KombiEngine is important that are not installed... on correct procedure in this manual. Observe all of its individual components.
It is the engine for a high-speed, ...
Product Instruction Manual - Page 5
... the operator to vibration are fatigued.
!Warning! Wear gloves and keep your power tool run unattended. See the appropriate section of a KombiEngine involves
1.
Prolonged use (e.g.
Safe use this... and carpal tunnel syndrome, please note the following:
- Take frequent breaks.
4
KM 110, KM 130 Different models may result in use it off and make sure that might impair...
Product Instruction Manual - Page 6
...ability to hear warnings (shouts, alarms, etc.) is restricted. Wear sound barriers (ear plugs or ear mufflers) to unusually high loads for use may interfere with a pacemaker should have it is in particular that...Parts and Controls."
!Warning! Never modify this tool is damaged. KM 110, KM 130
5 English / USA
All the above symptoms appear, seek medical advice immediately.
!Warning!
Product Instruction Manual - Page 7
...neck, the cap is not properly seated and tightened and you must repeat the above steps.
6
KM 110, KM 130 Take care not to get fuel on the top of burns and other ignition source, it ... fuel spillage and damage to cool before starting your machine.
!Warning! To do not start or run the engine until it to the power tool.
Different models may escape from the fueling spot before ...
Product Instruction Manual - Page 8
...KM 110, KM 130
7
Do not let the grip snap back, but guide the starter rope to the idle position. In order to reduce the risk of control, do not wrap the starter rope around your power tool. Place the power tool on the spark plug -
When you and all times; Keep the handles clean... improperly tightened fuel filler cap to loosen or come off and spill quantities of you pull the starter...
Product Instruction Manual - Page 9
... muffler clean....KM 110, KM 130 Working conditions
Operate and start your power tool only outdoors in heat radiation or sparks, thereby increasing the risk of your power tool using the starting throttle lock, as you cannot set the correct idle speed, have control of the gases (e.g. The muffler...run the machine indoors or in poorly ventilated locations. This also applies to adjust idle speed...
Product Instruction Manual - Page 10
... precautions must be performed by a chemical process in these screens will normally stay clean and need no service or maintenance. KM 110, KM 130
9 However, if you suspect a clogged screen, have your KombiEngine and KombiTool instruction manuals. Due to this process, the muffler does not cool down in the appropriate section of the engine by any...
Product Instruction Manual - Page 11
... fumes and cause a fire.
!Warning! An improperly maintained muffler will increase the risk of children.
Store the power tool ...clean and in a dry and high or locked location out of reach of fire and hearing loss. Always stop the engine and make sure it must be attached.) A loose connection between spark plug boot and the ignition wire connector in this manual.
10
KM 110, KM...
Product Instruction Manual - Page 14
... to push the slide to the bottom of the slot (see illustration). KM 110, KM 130
...13 Adjust the throttle cable only after the unit is the precondition for correct operation in the normal operating position.
Swiveling the Handlebar
Transport position:
: Release the wing screw (3) and unscrew it until the handlebar (7) can be in the full throttle, starting throttle and idle...
Product Instruction Manual - Page 20
...in the
direction of the arrow on the stop symbol ( ) to the run position # and the engine settles down the engine: : Push the slide control in the KombiTool instruction manual.
: Make sure you feel ...- your left hand and press it begins to fire. As soon as engine runs: : Blip the throttle trigger to idle speed.
KM 110, KM 130
19 Do not stand or kneel on the engine support .
Guide it...
Product Instruction Manual - Page 21
...Wait for a while at idle speed so that the heat in the engine can be dissipated by pulling the starter rope firmly. 10 to 20 pulls may be run at high revs (full throttle off load)...and connect the spark plug boot - Fuel tank run until dry : After refueling, press the fuel pump
bulb at regular intervals and retighten as necessary.
20
KM 110, KM 130
Store the machine in the engine are ...
Product Instruction Manual - Page 22
... to adjust the engine idle speed within fine limits. Do not wash. : Replace any major hardware.
266BA009 KN 266BA008 KN
Dirty air filters reduce engine power, increase fuel consumption and make starting more difficult.
KM 110, KM 130
21 If there is only possible to g. : Take out the screw (1) and remove
the filter cover (2). : Clean away loose dirt...
Product Instruction Manual - Page 23
... engine Engine stops while idling
: Turn idle speed screw (LA) slowly clockwise until the engine runs smoothly - Adjusting Idle Speed
It is not satisfactory when operating at high altitude or at sea level.
Rule of the high speed screw (H) may be reached with the idle speed screw (LA) so that the tool does not move .
22
KM 110, KM 130 Fine Tuning...
Product Instruction Manual - Page 24
...it out. : Clean spark arresting screen if
necessary - KM 110, KM 130
23 Erratic idling behavior, engine stops even though setting of LA screw is idling : Turn idle speed screw (LA) ...muffler. : Wait for muffler to 3/4 turn in Muffler
English / USA
Tool moves when engine is correct, poor acceleration
Idle setting too lean: : Turn low speed screw (L)
counterclockwise until the engine runs...
Product Instruction Manual - Page 25
...KM 110, KM 130 Fit a new spark plug after approx. 100 operating hours or earlier if the electrodes are badly eroded.
2
1
To reduce the risk of the approved range. English / USA
Checking the Spark Plug
000BA002 KN 002BA071 KN
Wrong fuel mix (too much oil in fuel mix. : Dirty air filter. : Unfavorable running conditions (mostly at idling speed...Stopping the Engine".
: Clean dirty spark plug. : ...
Product Instruction Manual - Page 30
...
Spark arresting screen* in muffler All accessible screws and nuts (not adjusting screws) Anti-vibration element Safety labels
Visual inspection (condition, leaks)
X
X
Clean
X
Check operation
X
X
Clean
Replace Have checked by dealer1) Have replaced by dealer1) replace
1) STIHL recommends the STIHL dealer
* see "Guide to Using this Manual"
KM 110, KM 130
before starting work after...
Product Instruction Manual - Page 32
...run and stop the engine.
9. Throttle Trigger Interlock Must be depressed before the throttle trigger can be activated.
10. Machine Support For resting machine on the ground.
17. Loop Handle For easy control of machine during cutting work.
7. KM 110, KM 130
31 Muffler (with both hands during operation.
20. Air Filter...
1. Throttle Trigger Controls the speed of the machine with spark ...
Product Instruction Manual - Page 33
...: 2.22 cu.in (36.3 cm3)
Bore KM 110: 1.57 in (40 mm) KM 130: 1.69 in (43 mm)
Stroke KM 110: 0.98 in (25 mm) KM 130: 0.98 in (25 mm)
Power according to ISO 8893: KM 110: 1.34 bhp (1,0 kW) at 7000 rpm (1/min) KM 130: 1.90 bhp (1,4 kW) at 8500 rpm (1/min)
Idle speed 2,800 rpm (1/min)
Engine cutoff...
Similar Questions
Kombi Km-110 R
power head rotates on drive shaft when using pole pruner HT-KM
power head rotates on drive shaft when using pole pruner HT-KM
(Posted by whatacats 3 years ago)
My 201 Tc Loading Up?
idles well then when I hit the throttle it dies or bogs down. Is anyone rise having this problem. Va...
idles well then when I hit the throttle it dies or bogs down. Is anyone rise having this problem. Va...
(Posted by cristjt14 7 years ago)
Part No For Stihl Km90r On/of Switch
i require 1 new on/of switch for my stihl km90r want part no or where it can be purchased its orange...
i require 1 new on/of switch for my stihl km90r want part no or where it can be purchased its orange...
(Posted by johnnash222 8 years ago)
Km 110 R
Where do I find a parts break down for the KM 110 R Trimmer ?
Where do I find a parts break down for the KM 110 R Trimmer ?
(Posted by ihabstreey 8 years ago)