Stihl BT 130 Support Question

Find answers below for this question about Stihl BT 130.
Need a Stihl BT 130 manual? We have 1 online manual for this item!

Stihl Overview Questions Manuals Reviews Videos Research

Question posted by kennethsimmons on August 25th, 2023

Cut Off At Full Throttle

replaced the carb. with new Stihl carb. but same problem cut off at full throttle

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by INIMITABLE on August 25th, 2023 10:45 AM

This answer was accepted by the poster of the original question.

INIMITABLE

Member since:
April 3rd, 2020

Points: 2,085,520

1,100
points

our leaf blower's carburetor controls the mixture of fuel and air that enters your engine. If the carburetor is clogged, it may not allow fuel into the engine, which will cause the engine to run, but die when the throttle is engaged.

Visit https://www.ereplacementparts.com/repair-center/lawn-equipment/blower/engine-will-idle-but-dies-at-full-throttle/ for general guide for repair

I hope this is helpful? PLEASE "ACCEPT" and mark it "HELPFUL" to complement my little effort. Hope to bring you more detailed answers

-INIMITABLE

Related Stihl BT 130 Manual Pages

Instruction Manual - Page 3

... hightorque, gasoline-powered tool, some special safety precautions...Replacing the Air Filter 18 Engine Management 18 Adjusting the Carburetor 18 Spark Plug 19 Engine Running Behavior 20 Lubricating the Gearbox 20 Storing the Machine 21 Inspections and Maintenance by copyright. KG, 2016 0458-429-8621-A. VA0.G16. 0000006500_006_GB { BT 130... your STIHL dealer or the STIHL distributor ...

Instruction Manual - Page 4

... manual may contain paragraphs that you how to operate your power tool. It is to continually improve all applicable federal, state and local...STIHL dealer show you read, fully understand and observe the following pictograms may be covered in this manual. WARNING Indicates a hazardous situation which, if not avoided, could result in a counterclockwise direction 2 BT 130...

Instruction Manual - Page 5

...cut injuries. If you have different parts and controls. not in soil (with earth auger attachments) or ice (with your body, it is in serious injury. Do not operate this power tool. All factors which might be hazardous. Working with your doctor before operating this power tool. BT 130...it for drilling holes in use of all STIHL earth augers. Different models may be aggravated...

Instruction Manual - Page 6

... safety hard hat to reduce the risk of injury to hear warnings (shouts, alarms, etc.) is a danger of a very low intensity. WARNING Never modify this tool. Although certain unauthorized attachments, drills and 4 BT 130 Take frequent breaks. If any way. English Most STIHL power tools are available with the specific...

Instruction Manual - Page 7

... and safety devices are useable with STIHL power tools, their use , shut it off any spilled fuel before continuing work. Note that it is not in the tank to reduce the risk of the machine (e.g., gearbox) away from the fuel system. In order to release slowly. BT 130 5 augers are working properly. Do not...

Instruction Manual - Page 8

... loose boot may damage the starter mechanism. 6 BT 130 Keep the handles clean and dry at starting throttle, engine speed will be started , immediately blip the throttle trigger, which is particularly important to keep them...not completely or securely assembled. For specific starting . Place the power tool on firm ground or 9912BA013 KN other persons in injury to idle speed. Once the...

Instruction Manual - Page 9

... use your instruction manual. Keep your power tool and make proper adjustments and repairs. Watch for hidden obstacles such as tree stumps, roots and ditches to cause respiratory problems, cancer, birth defects, or other reproductive harm. For better footing, clear away fallen branches, scrub and cuttings. Work carefully. 9912BA000 KN English WARNING As...

Instruction Manual - Page 10

...remove the auger from reactive forces, never operate your earth auger without canting. Keep throttle feed pressure to the ground. Your earth auger model is not insulated. If reactive... machine strikes a wire, it cannot drill through the 8 BT 130 If the auger becomes trapped in slow steps frequently clearing tool. Striking something it will cause electrical shock and serious injury...

Instruction Manual - Page 11

...of tool changes... tool if...cut injuries, use or operate gasoline-powered tools on auger drilling tools. WARNING Drilling tool blades and point are always clean and in effective working order. Cover and clearly mark boreholes to use caution when operating and handling. To reduce the risk of this manual. WARNING Use only identical STIHL replacement parts for properly maintaining the BT 130...

Instruction Manual - Page 12

... bolts and screws except the carburetor adjustment screws after each use. Do not clean your power tool in a dry and locked location out of reach of the machine. Store your machine with the... Fit the padding 3 N Hook the padding (1) with a pressure washer. do not jam the throttle cable 10 BT 130 Contact your local fire agency or forest service for auger brake 3 12 3 N Insert the activating...

Instruction Manual - Page 13

... two-cycle engines. At correct idle speed, the cutting tool should not be avoided by always using fuel with a certain ethanol content to ...problems or even damage the engine. If your power tool shows an incorrect idle adjustment, have your STIHL dealer check your vehicle and place the BT 130 11 Fuel with various ethanol contents. English Adjusting the Throttle Cable The correct throttle...

Instruction Manual - Page 15

...Activating the auger brake Releasing the auger brake English BT 130 A 9912BA008 KN 9912BA009 KN B N Set ...the auger brake for a brief period (max. 3 seconds) - STIHL recommends the STIHL dealer. 13 WARNING After fueling, tighten down the filler cap by... N When idling, activate the auger brake and open the throttle wide for proper functioning The auger brake is triggered. g. on roots...

Instruction Manual - Page 16

... down the spring clip of the retaining pin so that it there. N Now release the throttle trigger, slide control and trigger lockout in that order. This is the starting throttle position. 9912BA010 KN 9912BA008 KN 9912BA011 KN 14 BT 130 English Fitting the Auger N Switch off the motor and activate the auger brake - N Move...

Instruction Manual - Page 17

... your right hand until the engine runs. N Continue cranking. or the clutch might otherwise break. As soon as the engine runs BT 130 N Place the unit on the handle frame. N Blip the throttle trigger (2) - N Do not let the starter grip snap back. also use this posi- English When engine begins to fire N Set...

Instruction Manual - Page 18

... fuel. N Set the choke knob to e and N Set the slide control, trigger lockout and throttle trigger to disengage the starting throttle position. N Start the engine by moving the activating lever to clear the combustion chamber. N Refit ... be necessary. N Now start the engine. 16 BT 130 N Set the choke knob to STOP-0. Stopping the Engine N Move the slide control to e -

Instruction Manual - Page 19

... the engine immediately N Set the slide control to STOP-0 A After a long period of the hole. BT 130 17 As all accessible screws and nuts (not adjusting screws) at chest height and cannot be controlled properly... Operating Instructions During break-in period A factory-new machine should not be run for a short while at high revs (full throttle off load) for the engine to cool down.

Instruction Manual - Page 20

9912BA017 KN 9912BA018 KN English Replacing the Air Filter Engine Management Adjusting the Carburetor If there is secured ...Turn the idle speed adjusting screw (LA) slowly clockwise until the auger stops turning 18 BT 130 Setting the idle speed 1 N Unscrew the screw (1) and remove the filter cover (2) - replace if soiled or damaged N Fit the air filter (3) N Fit the filter cover ...

Instruction Manual - Page 21

...problems which may result in trouble in operation. unfavorable running conditions (mostly at part throttle... etc.) affect the condition of the spark plug. Wrong fuel mix (too much oil in fuel mix, - too much engine oil in the gasoline), a dirty air filter and unfavorable running conditions, e.g. Fit a new... boot (1) N Unscrew spark plug BT 130 19 N Use only resistor type ...

Instruction Manual - Page 28

...STIHL parts symbol K. spindle speed: Max. Warranty claims following repairs can be performed only by the Federal Emission Control Warranty provided elsewhere in this manual. 26 BT 130 Except for brushcutters Weight Dry, without drilling 365 mm tool... STIHL servicing dealer using genuine STIHL replacement parts. STIHL recommends that other repair work be identified by the STIHL ...

Instruction Manual - Page 30

... effect of two years. Any manufacturer-approved or equivalent replacement part may be warranted for regular inspection to the owner. STIHL Incorporated is scheduled only for the warranty period. Choke (Cold Start Enrichment System) (if applicable) - Throttle Housing (if applicable) - Fasteners 28 BT 130 The following list specifically defines the emission-related warranted parts...