Sony VPL CX6 Support Question
Sony VPL CX6 Support Question
Find answers below for this question about Sony VPL CX6 - XGA LCD Projector.Need a Sony VPL CX6 manual? We have 1 online manual for this item!
Question posted by faheybop on June 20th, 2013
Wher Exactly Is The Fuse And How Do I Replace It.
The person who posted this question about this Sony product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Sony VPL CX6 Manual Pages
Operating Instructions - Page 5
...Panel 12 Connector Panel 12 Remote Commander 13
Setting Up and Projecting
Installing the Projector 17 Connecting the Projector 18
Connecting with a Computer ......18 Connecting with a VCR or 15k
RGB/...INSTALL SETTING Menu ..... 39 The INFORMATION Menu 40
Maintenance
GB
Maintenance 41 Replacing the Lamp 41 Cleaning the Air Filter 42
Troubleshooting 44 Warning Messages 46 Caution Messages 47...
Operating Instructions - Page 6
...) and ventilation holes (exhaust). Never use a damp cloth, detergent solution, or thinner.
• Clean the filter at regular intervals. To remove dust on the LCD data projector. Do not touch the unit while the adjuster is in a room where floor and walls are of reflecting material, it is recommended that the carpet...
Operating Instructions - Page 7
... the unit in 1 min." Overview
Notes on its side. These installations may block the ventilation holes. Tilting the unit out of the range of the projector. Toppling the unit Avoid using when the unit is a lot of more than 30 cm (11 7/8 inches) around the unit.
• Be careful that may...
Operating Instructions - Page 8
...XGA, SXGA1) and SXGA+1) signals, which all other than placing on the top of the projector. For easier operations, the keys that will be selected automatically. Short focus lens equipped (VPLCS6/CX6 only) This projector...
within 1024 × 768 dots (VPL-CX6/EX1) or 800 × 600 dots (VPL-CS6) .
• Compatible input signals
Notes
This projector accepts video signals of
• The...
Operating Instructions - Page 9
... (VPLCS6) or 1500 ANSI lumen (VPL-EX1).
• High resolution For VPL-CX6/EX1: Three superhighaperture 0.7-inch XGA panels with approximately 790,000 pixels, and with the VPL-CX6 only.
• Windows is a trademark of Video Electronics Standard Association.
• Memory Stick and
are supplied with the VPL-CS6/CX6.
5) The application software (Projector Station) can be used with...
Operating Instructions - Page 10
...mode, you press the key, the input signal switches as follows:
INPUT A t MS t VIDEO t S VIDEO
(VPL-CX6 only)
5 Lens protector (lens cover) The lens protector automatically opens when the power is turned on steps for about ..., see on page 46.
3 TILT adjustment key
For details, see "To turn on the projector with the I / 1 key lights in green when the power is in green when the power...
Operating Instructions - Page 11
...press the KEYSTONE key (VPL-CS6/CX6) or the D KEYSTONE key (VPL-EX1) on the Remote Commander to use the powered tilt adjuster
To adjust the height Adjust the height of the projector as it may cause ... qf Speaker
qg Security lock Connects to the right or left for minor tilt adjustment of the projector. qk Ventilation holes (intake)/air filter cover
Notes • Do not place anything near the
...
Operating Instructions - Page 12
... (Temperature)/FAN indicator Lights up or flashes under the following conditions: - Although the lamp goes out, the cooling fan keeps running. Lights up when the projector is in the SET SETTING menu is input for the first 60 seconds after the lamp goes out.
2 MENU key Displays the on-screen menu...
Operating Instructions - Page 15
Overview
To install batteries
1 Push and slide to install the battery
from the # side.
2 Replace the lid. Be sure to open the lid, then
install the two size AA (R6) batteries (supplied) with the correct polarity. While pressing the lid, slide it. For VPL-EX1
1 I / 1 (on/standby) key 2 ENTER/arrow key (M/m/
Operating Instructions - Page 16
... • The operation range is , the wider the angle within which the commander can control the projector becomes.
2 Install the lithium battery.
+ side facing upward
16 GB
Location and Function of
children.... that nothing obstructs the
infrared beam between the Remote Commander and the projector is limited. To replace battery
1 Release the lock of the lithium battery
holder by picking it...
Operating Instructions - Page 18
... information, refer to only the external monitor. Notes • The projector accepts VGA, SVGA, XGA, SXGA (VPL-CX6/EX1 only) and
SXGA+ (VPL-CX6/EX1 only) signals. If your computer. • This projector is compatible with a DDC, turn the projector on according to the following procedures.
1 Connect the projector to the computer by using the supplied HD D-sub 15...
Operating Instructions - Page 24
... I / 1
KEYSTONE
INPUT
APA
MENU PIC ENTER MUTING
For VPL-CS6/CX6
For VPL-EX1
1 Open the connector panel, plug the AC power cord into a wall outlet, then
connect all -inone LCD type, you may have to switch the computer to output to the projector
by pressing certain keys (e.g., / LCD VGA , / , etc.), or by changing your computer...
Operating Instructions - Page 36
... preset data (for VPL-CX6/EX1)(25types for VPL-CS6) for the vertical position. Notes
• When XGA, SXGA or SXGA+ signal is input, this item will lose some clarity. This projector has 38 types of... decreases, the picture moves to the preset memory. H Size
Adjusts the horizontal size of the LCD panel and the signal output from a computer. The lower the setting, the smaller the horizontal ...
Operating Instructions - Page 41
....
Caution The lamp becomes a high temperature after using the projector Turn off the projector with the Projector Lamp).
appears on the lamp (3)
Handle
Maintenance 41 GB When replacing the lamp after turning off the projector, then unplug the power cord. If
you touch the lamp, you replace the lamp, wait for at least an hour for...
Operating Instructions - Page 42
... remote
commander in the following keys on if the lamp is securely in place. Disposal of the used lamp As the used projector lamp in the same way as a fluorescent lamp. Notes • Be careful not to touch the glass surface
of a fluorescent... way in until
it is
not secured properly.
5 Close the lamp cover and tighten the
screws.
6 Turn the projector back over.
7 Connect the power cord.
Operating Instructions - Page 44
...8226; The air filter cover is disconnected or the connections are wrong.
Troubleshooting
If the projector appears to be operating erratically, try to diagnose and correct the problem using the INPUT ...computer signal is noisy. c Press the PIC MUTING key to an external monitor and a LCD monitor of a computer. Power
Symptom
Cause and Remedy
The power is necessary to an external...
Operating Instructions - Page 45
...34).
• The lamp has burnt or dims. c Replace the lamp with the power on the screen and press the APA key. c Leave the projector for about two hours with a new one (see page 38...see page 41).
c Check that the proper connections have been made (see page 34).
• Projector is pressed although there are wrong.
Sound
Symptom No sound. "Please check Input-A Signal Sel."
...
Operating Instructions - Page 46
... fan is blocking the ventilation holes.
c Check to XGA (VPL-CX6/EX1) or SVGA (VPL-CS6) (see page 41).
• The lamp becomes a high temperature. c Replace with qualified Sony personnel. c Wait for 90 seconds ...to see if nothing is detached. does not work.
Frequency is out of the projector. The LAMP/COVER indicator lights up.
• The lamp has reached the end ...
Operating Instructions - Page 49
...VPL-CX6/EX1: fH: 19 to 92 kHz fV: 48 to 23.6 feet)
There may be a slight difference between the actual value and the design value shown above.
1) ANSI lumen is a measuring method of the projector. aperture 0.7-inch XGA...
3 LCD panels, 1 lens, projection
system
LCD panel VPL-CS6: Superhigh-aperture
0.7-inch SVGA panel,
1,440,000 pixels (480,000
pixels × 3)
VPL-CX6/EX1: Superhigh-
Operating Instructions - Page 50
... Optional accessories
Projector Lamp
LMP-C150 (for replacement) (1) Operating Instructions (1) Quick Reference Card (1) Security Label (1)
Design and specifications are subject to change without the projection parts)
Mass
Approx. 2.7 kg (5 lb 15 oz)
Power requirements
AC 100 to 240 V, 50/60 Hz
Power consumption
Max. 240 W
(Standby mode:
VPL-CS6/EX1: 5 W
VPL-CX6: 7 W)
Heat dissipation...
Similar Questions
Sony Projector Vpl-cs6 Lcd Repair
1.I would like to know where i can find a new lcd.2.I would like to have some instructions how to re...
1.I would like to know where i can find a new lcd.2.I would like to have some instructions how to re...
(Posted by Nikosfly 1 year ago)
Sony 3 Lcd Projector Svga Vpl Cs 7 Showing A Yellow Light
Sony 3 Lcd Projector Svga Vpl Cs 7 Showing A Yellow Light And Not Reflecting The Computer Image
Sony 3 Lcd Projector Svga Vpl Cs 7 Showing A Yellow Light And Not Reflecting The Computer Image
(Posted by michellefrt 8 years ago)
User Manual For Projector Vpl-ex4
need the user manual for projector VPL-EX4
need the user manual for projector VPL-EX4
(Posted by Refaat 10 years ago)
Servicing For Sony Vpl-es2 Lcd Projector
Can you provide me with details of whom to contact for servicing a Sony VPL-ES2 projector in Chennai...
Can you provide me with details of whom to contact for servicing a Sony VPL-ES2 projector in Chennai...
(Posted by sumesh97331 11 years ago)
How Do I Reset The Lamp Hours On Xga Vpl-cx6 Projector
(Posted by rhheyse 12 years ago)