Taking Apart Sony Ss-ts500 Speakers

i just want to know how to take apart Sony SS-TS500 speakers

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by SonuKumar on March 25th, 2023 9:30 PM

This answer was accepted by the poster of the original question.

SonuKumar

Member since:
May 9th, 2021

Points: 16,653,150

1,100
points

https://www.youtube.com/watch?v=eoXnYKoXdnA

https://www.youtube.com/watch?v=7FRU252PiHU&vl=en

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.

Regards,
Sonu
Your search handyman for all e-support needs!!

Answer #2: Posted by shlokuprit on March 25th, 2023 6:57 PM

shlokuprit

Member since:
November 28th, 2020

Points: 35,590

100
points

To take apart Sony SS-TS500 speakers, follow these steps:

1. Remove the speaker grills: Gently pry the grills off with a flathead screwdriver or your fingers. Be careful not to damage the grills or the speakers.

2. Remove the speaker wires: Unscrew the terminals on the back of the speakers to release the wires. If the wires are soldered onto the speakers, desolder them using a soldering iron.

3. Remove the drivers: The drivers are the actual speakers inside the cabinets. Depending on the speaker design, they may be attached to the cabinet with screws, bolts, or adhesive. Use the appropriate tools to remove them.

4. Disassemble the cabinet: If you need to access the internal components of the cabinet, you may need to disassemble it. Look for screws or bolts holding the cabinet together and remove them. Gently pry the cabinet apart, being careful not to damage the internal components.

5. Remove the crossover: The crossover is the circuit board or component that separates the audio signal into different frequency ranges and sends them to the appropriate drivers. It may be attached to the back of the speaker or inside the cabinet. Unscrew or unclip it to remove it.

6. Replace or repair components: Once you have access to the internal components, you can replace or repair them as needed. Be sure to use appropriate replacement parts and follow proper safety precautions when working with electrical components.

7. Reassemble the speaker: Reverse the steps above to reassemble the speaker. Test the speaker to make sure it is working properly before replacing the grills.

Hope this will help you solve your problem!!