Sony SA-WM40 Support Question
Sony SA-WM40 Support Question
Find answers below for this question about Sony SA-WM40.Need a Sony SA-WM40 manual? We have 2 online manuals for this item!
Question posted by novelist48 on March 17th, 2013
Where Can I Get My Unit Fixed?
i need to get my subwoofer repaired. i live in columbus ohio.P
Current Answers
Related Sony SA-WM40 Manual Pages
Operating Instructions - Page 1
4-228-525-21 (1)
Active Subwoofer
Operating Instructions
GB
Mode d'emploi
FR
SA-WM40
© 2000 Sony Corporation
Operating Instructions - Page 2
Do not install the appliance in a confined space, such as a bookcase or built-in Canada
CAUTION TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS POLARIZED AC PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
2GB For the customers in cabinet.
WARNING
To prevent fire or shock hazard, do not expose the unit to rain or moisture.
Operating Instructions - Page 3
Welcome! Thank you for future reference.
Before operating this woofer, please read this manual thoroughly and retain it for purchasing the Sony Active Subwoofer. TABLE OF CONTENTS
Getting Started
Unpacking 4 Installation 4 Hooking Up the System 5
Basic Operations
Listening to the Sound 8 Adjusting the Sound 9
Additional Information
Precautions 10 Troubleshooting ...
Operating Instructions - Page 4
.... You can obtain an even more effective heavy bass reproduction. Getting Started
Unpacking
Check that you received the following items: • Audio connecting cord (1) • Speaker cords (2)
Installation
Since the human ear cannot detect the direction and position where the bass sound being reproduced by a woofer (below 170 Hz) comes from...
Operating Instructions - Page 5
SUBWOOFER output jack(s) - If there are supplied to the respective equipment. MONO OUT jack - SUPER WOOFER output jack...Logic modes. Getting Started
(continued)
5GB
Hooking Up the System
Overview
Use the LINE IN jacks or the SPEAKER IN terminals of the woofer when you need to purchase some optional audio connecting cords.
• Be sure to make the necessary connections, you connect ...
Operating Instructions - Page 6
... sound will be distorted and will I need ? l: signal flow
Amplifier
SPEAKER
Twist the stripped ends of the cord about 2/3 inch (15 mm). Connect the SPEAKER IN terminals of the woofer to the amplifier's speaker terminals (B) using the double (A+B) sets of speakers, make sure that the speaker cord marked with the speaker cords.
What cords will lack bass...
Operating Instructions - Page 7
... off before you plug in or unplug any power cord.
7GB What cords will I need? In this case, connect the speaker terminals of the amplifier directly to the SPEAKER IN terminals of those jacks. When using two or more subwoofers
Amplifier MONO OUT
This woofer
LINE
IN
OUT
Another woofer
LINE
IN
OUT
Connecting...
Operating Instructions - Page 8
... musical instrument, pop noise of using normally, adjust the subwoofer level. Adjust the VOLUME so that sound from the woofer... turntable, sound with abnormally enhanced bass, etc.) in this unit. Basic Operations
Listening to the Sound
POWER
POWER (?/1) POWER indicator...distorted, the sound from the front speakers is played, noise may cause damage to the speakers. While in a high level to...
Operating Instructions - Page 9
... prefer when listening in certain listening environments (depending on the bass reinforcement from your front speakers. Turn the volume for your normal listening position.
1 Adjust the cut -off frequency)....more than before. It may provide better bass reproduction in your preference. You don't need to adjust the woofer settings when you desire, use the VOLUME control on the ...
Operating Instructions - Page 10
... input signal is imperfect. , The input signal level is essential to open the enclosure or remold speaker
units and networks.
Connect the cords properly. Move the audio system away from the TV set once,... input power. • Do not attempt to prevent internal heat build-up . , Select SPEAKER or LINE with water. If color irregularity is observed again... To disconnect the cord, pull ...
Operating Instructions - Page 11
Additional Information
Specifications
System
Type
Active Subwoofer (magnetically shielded design)
Speaker unit Woofer: 30 cm dia. (12 in.), cone type
Continuous RMS output Canadian model (0.8%) 120 W European model (DIN) 120 W Other models (0.8%) 100 W
Reproduction frequency range 20 ...
Marketing Specifications - Page 1
SA-WM40
Active Subwoofer
KEY FEATURES
v Built-in Amplifier with 120 Watts into 8 ohms from 20 - 200Hz at 0.8% THD
❒ Advanced SAW (Super Acoustically Loaded) Bass Reflex Design
v 12" Long-Throw Driver
ADDITIONAL FEATURES
v Auto Power On/Off ❒ Level Control ❒ Variable High-Cut Frequency, 50 - 170Hz ❒ Line-Level & Speaker-Level Inputs ❒...
Similar Questions
Sony Subwoofer Fuse Replacement
Where is the fuse located on the SONY SW-WM40 located.??
Where is the fuse located on the SONY SW-WM40 located.??
(Posted by albarred 2 years ago)
Does My Sony Sa-wmsp68 Active Subwoofer Magnetically Shielded Type Have To Have
Does my Sony SA-WMSP68 ACTIVE SUBWOOFER magnetically Shielded Type have to have a be hooked up to a ...
Does my Sony SA-WMSP68 ACTIVE SUBWOOFER magnetically Shielded Type have to have a be hooked up to a ...
(Posted by joecampos973 2 years ago)
Subwoofer And Speakers Ss-ws31
I have subwoofer and speakers SS-WS31 and I need to purchase suitable receiver or blue ray to match ...
I have subwoofer and speakers SS-WS31 and I need to purchase suitable receiver or blue ray to match ...
(Posted by aalhammadi 3 years ago)
Input And Conection Plug To Board
Does Any One Have Or Know Where To Find For Sa-wg99 Sony Subwoofer Input And Harness W/plug At Board...
Does Any One Have Or Know Where To Find For Sa-wg99 Sony Subwoofer Input And Harness W/plug At Board...
(Posted by Opalblakemore 6 years ago)