Sony RM-YD103 Support Question
Find answers below for this question about Sony RM-YD103.Question posted by Anonymous-171151 on April 24th, 2022
Tv Will Not Respond To Any Buttons But The Power
Current Answers
Answer #1: Posted by Odin on April 24th, 2022 6:23 PM
If the issue persists or if you require further advice, you may want to consult the company: use the contact information at https://www.contacthelp.com/sony.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Answer #2: Posted by SonuKumar on April 24th, 2022 9:01 PM
How do I reset my Sony remote control?
For Android TVs released in 2015 or later, symptoms may improve by updating the software of the remote control.
...
Reset the remote control.
Open the battery compartment cover and remove the batteries.
Press and hold the Power button for three seconds.
Insert the batteries again and close the battery compartment cover.
and
How do I force my Sony TV to factory reset?
1 Factory Reset
Unplug the TV and leave it unplugged for one minute.
Plug the TV back in. ...
On the remote control, press and hold the UP ARROW button.
While holding down the UP ARROW button, press and release the POWER button on the television. ...
Depending on the model, RESET may flash on the screen.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Similar Questions
How do I program a RM-YD103 remote to a Sony 43 " Bravia tv
purchased a new rm-yd103 tv remote how to program it to my sony tv
Out of the package it could not control a kgl48w 600b Sony TV. I programmed a Comcast remote to the ...
The control keeps on emitting infra red signal. It cannot be stopped.
Message on TV screen says - no signal. Check external input or select another input. How do I change...