Sharp CV10NH Support Question
Sharp CV10NH Support Question
Find answers below for this question about Sharp CV10NH - 10,000 BTU Portable Air Conditioner.Need a Sharp CV10NH manual? We have 1 online manual for this item!
Question posted by a09ro on September 12th, 2013
How To Remove Cover Of Sharp Air Conditioner
The person who posted this question about this Sharp product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Sharp CV10NH Manual Pages
CV-10NH Operation Manual - Page 3
... the proper use of your new air conditioner. This manual should be kept in a safe place for handy reference.
CONTENTS
• FOR CUSTOMER ASSISTANCE E-2 • CONSUMER LIMITED WARRANTY E-3 • PRECAUTIONS E-4 • LOCATION E-7 • INCLUDED E-7 • PART NAMES E-8 • INSTALL WINDOW PANEL E-10 • INSTALLATION AND REMOVAL OF EXHAUST HOSE .........E-14 •...
CV-10NH Operation Manual - Page 4
... call for service or for your Authorized Parts Distributor) ACCESSORIES ADDITIONAL CUSTOMER INFORMATION
TO WRITE: For service problems, warranty information, missing items and other assistance:
Sharp Electronics Corporation Customer Assistance Center 1300 Naperville Drive Romeoville, IL 60446-1091 TO ACCESS THE INTERNET: www.sharpusa.com
Please provide the following information when...
CV-10NH Operation Manual - Page 5
... and/or commercial purposes.
The limited warranty described herein is necessary to remove the Product, the Servicer will come to you. ALL IMPLIED WARRANTIES INCLUDING...Sharp Authorized Servicer, call Sharp Toll Free at no event shall Sharp be liable or in any way responsible, for this information available when you . In no charge to Obtain Service:
CV-10NH
Portable Air Conditioner...
CV-10NH Operation Manual - Page 6
...receiving antenna. • Increase the separation between the room air conditioner and radio/TV receiver. • Connect the room air conditioner into an outlet on a circuit different from the product manufacturer... AC socket rated 125V, 60Hz, and 15 amps or more of this room air conditioner should cause interference to radio or television reception, try to correct the interference by...
CV-10NH Operation Manual - Page 7
...The plug must have no kinks or be performed whenever moving the air conditioner. (See Page 26)
If any circumstances cut or remove the round grounding pin from this plug.
Screw
Grounding adapter
Grounding...in the tank, it may be plugged into the room. • Do not block the exhaust air outlet with a cord that is properly grounded. If a grounding adapter is used . ent level ...
CV-10NH Operation Manual - Page 8
... off for three minutes for the compressor to restart cooling. If you turn the air conditioner off . Setting the unit to a higher temperature will be operated within the unit. (See page 26)
OPERATING CONDITIONS
• The air conditioner must remove the heat produced by the unit outside through any lights or appliances that keeps the...
CV-10NH Operation Manual - Page 9
... reach of a properly rated grounded socket.
• Never place any obstacles around the air inlet or outlet of space from the wall for direct installation.)
E-7 Do not attempt to...cient air-conditioning. Knife or scissors 4. MIN.12" (30cm)
INCLUDED
MIN.12" (30cm)
SUGGESTED TOOLS FOR WINDOW PANEL INSTALLATION 1. Tape measure or ruler 3. ENGLISH
LOCATION
• The air conditioner ...
CV-10NH Operation Manual - Page 10
... signal receiver
4
window
5
5 POWER Button
6
6 OPERATION Lamp (red)
7 7 TIMER Lamp (orange)
8
9
8 MEGA COOL Lamp (green)
9
9 Air inlet
9
REAR VIEW
0
0 Exhaust air outlet
q
q Window exhaust adapter
w
w Exhaust hose
e
e Remote control hook
r
t
r Air filters
y
t Drainage nozzle and stopcock
y Power supply cord hooks
u Drainpipe nozzle and stopcock
u
i Power supply...
CV-10NH Operation Manual - Page 12
... now be at the top, as you will now be unable to shut the exhaust cover.
(1) Remove the adjustment panel from the window panel, and cut the window panel to the window... panel cannot be installed in windows less than 22" (559mm) wide, as indicated
in the diagram.
E-10
Cut
Window panel Window stool Hole
Insert all three projections on the window stool
(3) Secure the window panel to...
CV-10NH Operation Manual - Page 14
...less than 22" (559mm) high, as you will now be unable to shut the exhaust cover.
(1) Remove the adjustment panel from the window panel, and cut the window panel to the window frame...seal A (adhesive type)
Cut
22"~24"
INSTALL WINDOW PANEL
Installation in a sliding sash window
(See page 10 for installation in a double-hung window.)
1 Connect the rain guards to the window frame with 2 screws. ...
CV-10NH Operation Manual - Page 16
...two holes on the unit, and firmly attach them to each other.
3 Slide and open the exhaust cover on the window panel, and attach the window exhaust adapter. Surface of window exhaust adapter marked "TOP" should... and turn it is installed in a double-hung sash window. INSTALLATION AND REMOVAL OF EXHAUST HOSE
The exhaust hose must not be twisted or bent. three times) until it must be installed...
CV-10NH Operation Manual - Page 17
Pull out and remove the window exhaust adapter by pushing down two "PUSH" markings, and slide and close the exhaust cover in the window panel.
2 Remove the exhaust hose adapter from the unit. "PUSH" Projection
E-15 ENGLISH
Removal of the exhaust hose
1 Remove the window exhaust adapter.
Lift up and remove the exhaust hose adapter from the unit by pushing down on the two projections.
CV-10NH Operation Manual - Page 18
LOADING BATTERIES Use two AAA (R03) batteries.
1 Remove the battery cover at the same time,
and make sure they are properly installed.
3 Reattach the battery cover.
4 Press the RESET button using the unit for service.
PRE-OPERATION CHECKS
POWER PLUG CHECK
This air conditioner uses a fused power plug. You will hear a CLICK if the circuit breaker...
CV-10NH Operation Manual - Page 19
... the remote control up to direct sunlight or near a heater.
This may be affected by signals emitted from being misplaced, hook it . When attached, to remove the remote control from moisture and shock which can discolor or damage it to direct sunlight. A beep will sound when the unit receives the signal...
CV-10NH Operation Manual - Page 20
... the range of 64°F to 86°F.
1 4
4 Press the FAN button to select COOL mode. E-18 Stopcock Drainpipe nozzle
Ensure that the stopcock is covered with the stopcock.
COOL MODE
Drainage nozzle
"CLOSE" position
Stopcock
Install the exhaust hose (See Page14), turn off.
CV-10NH Operation Manual - Page 21
...Set the hose sloping downwards for more than when operating dehumidification with container
1 Remove the exhaust hose (See Page 15) 2 Turn the drainage nozzle to be
changed.... with container, the unit generates heat during operation. In this mode, the air conditioner dehumidifies the room. In this procedure with the stopcock. Drain water...covered with the unit turned off .
CV-10NH Operation Manual - Page 22
... the MODE button to select FAN mode.
VENTILATION MODE
In this mode, the air conditioner simply circulates the air without cooling it.
COOL DEHUM FAN
VENT
2
2 Press the POWER button to...the desired fan speed. Ensure that the stopcock is covered with the stopcock. E-20 FAN MODE
In this mode, the air conditioner ventilates the air to the CLOSE position, and check the drainage ...
CV-10NH Operation Manual - Page 24
... hour at extra high speed with a setting temperature of 59°F.
1 Press the MEGA COOL button during operation. MEGA COOL OPERATION
In this operation, the air conditioner fan works at the formerly set , the unit will automatically turn off after one hour.
CV-10NH Operation Manual - Page 29
... damage the electrical insulation. Periodically remove the window exhaust adapter from the wall socket before reinstalling them with detergent and rinse carefully with a mild soap. Doing so may be reduced or stop completely if the insect guard net becomes clogged with dust. Insect guard net
MAINTENANCE AFTER AIR CONDITIONER SEASON
1 Perform drainage to...
CV-10NH Operation Manual - Page 30
...This is sound of the refrigerant flowing inside the unit.
• This air conditioner evaporates water condensed during operation. Cooling does not take place in the remote control....be heard when the unit is the circuit breaker tripped? • Did you restarted the air conditioner, a protective device may be malfunctioning, check the following points before calling for a service. ...
Similar Questions
Replacement Window Exhaust Unit For Sharp Portable Air Conditioner Model Cv-10nh
Do you have a replacement window exhaust kit available for sharp portable air conditioner model cv-1...
Do you have a replacement window exhaust kit available for sharp portable air conditioner model cv-1...
(Posted by jnohner18 2 years ago)
Where Can I Buy The Window Panel Kit For Sharp 10,000 Btu Portable Air
conditioner
conditioner
(Posted by buEdna 10 years ago)
Sharp Portable Air Conditioner Manual Cv 10nh How To Open
(Posted by riocoas 10 years ago)
How To Drain Water From 10,000 Btu Sharp Portable Air Conditioner
(Posted by DBIBLEto 10 years ago)
How Do You Easily Drain A Sharp Portable Air Conditioner, Model # Cv-10nh?
I am having issues with my Sharp air conitioner, Model # CV-10 NH. I've misplaced the manual and can...
I am having issues with my Sharp air conitioner, Model # CV-10 NH. I've misplaced the manual and can...
(Posted by kashka 13 years ago)