Schwinn Airdyne AD6 Support Question
Schwinn Airdyne AD6 Support Question
Find answers below for this question about Schwinn Airdyne AD6.Need a Schwinn Airdyne AD6 manual? We have 1 online manual for this item!
Question posted by cannataco63 on January 1st, 2016
Console On Brand-new Airdyne Ad6 Will Not Shut Off Automatically!
Help! The console on my brand-new Airdyne AD6 will not shut off and stay off. It just keeps beeping and turning back on all by itself, even with the strap holding the arms still. Any suggestions?
Current Answers
Answer #1: Posted by waelsaidani1 on January 2nd, 2016 8:30 AM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,797
Member since:
May 12th, 2013 Points: 19,501,797
Related Schwinn Airdyne AD6 Manual Pages
Assembly and Owner's Manual - Page 2
...
Moving the Machine
13
Leveling the Machine
13
Important Safety Instructions
14
Features
15
Console Features
16
Remote Heart Rate Monitor
17
Operations 18
Adjustments 18
Using the Machine...Console Service Mode
21
Maintenance 22
Replacing the Console Batteries
23
Maintenance Parts
24
Troubleshooting
25
Warranty 27
To validate warranty support, keep ...
Assembly and Owner's Manual - Page 3
... not assemble this machine. Carefully read and understand the Assembly instructions. • Keep bystanders and children away from foot traffic and exposure to change the design or functionality... supplied with the normal use only genuine replacement parts and hardware supplied by Nautilus. Keep the Manual for correct performance in death or serious injury. Given the obvious importance ...
Assembly and Owner's Manual - Page 5
...applicable EN ISO 20957 International Standards for each assembly step.
• Using the recommended wrenches, turn the bolts and nuts to the right (clockwise) to tighten, and the left (counterclockwise) ...otherwise.
• When attaching 2 pieces, lightly lift and look through the bolt holes to help insert the bolt through the holes.
• The assembly requires 2 people.
5 Contact information...
Assembly and Owner's Manual - Page 6
Item Qty Description
Item Qty Description
1
1 Frame
9
1 Pedal Strap, Left
2
1 Console Support Bar
10
1 Pedal, Left
3
1 Console
11
1 Foot Peg, Left
4
1 Water Bottle Holder
12
1 Stabilizer, Front
5
1 Handlebar, Left
13
1 Foot Peg, Right
6
1 Seat
14
1 Pedal, Right
7
1 Seat Post
15
1 Pedal Strap, Right
8
1 Stabilizer, Rear
16
1 Handlebar, Right
6 PARTS
4
6
17
...
Assembly and Owner's Manual - Page 9
... (Ni-Cd, Ni-MH, etc) batteries. 3
*
X4
#2
9 Pull the lower cable to Frame Assembly
Note: Do not crimp the cables. 3.
Connect Cables and Attach the Console Support Bar to remove any slack as you insert the Console Support Bar. In order to avoid possible serious injury, when inserting the tube ends into...
Assembly and Owner's Manual - Page 10
Connect Cable and Attach the Console
Note: Do not crimp Console Cable. Attach Water Bottle Holder to Frame Assembly Note: Hardware is pre-installed and not on the Hardware Card ( * ).
4 X2 #2
*
10
X4
*
#2
X4
*
#2
6. 5.
Assembly and Owner's Manual - Page 13
... the machine. Make sure the machine is uneven. NOTICE: B e careful when you exercise.
13 Make sure that they are all physically fit and able to the machine can
affect the computer operation. Leveling the Machine
The machine needs to keep the fan assembly clear of the floor. 2. Push the machine into position. 3. Carefully...
Assembly and Owner's Manual - Page 14
...new batteries. • Do not mix alkaline, standard (carbon-zinc), or rechargeable (Ni-Cd, Ni-MH, etc) batteries. • For safe storage of the Resistance Fan. Be sure to anticipate that the Adjustment Devices do not hit the user. • Keep the Pedals clean and dry. • Exercise... Resistance Fan. Monitor the Pedals and Crank Arms closely. Important Safety Instructions
This icon means...
Assembly and Owner's Manual - Page 15
...B
A
C
D
E F
FEATURES
M
L
K
A Console B Hand Grip C Handlebar D Water Bottle Holder E Battery Compartment F Locking Knob
G Air Resistance Fan H Transport Roller I Leveler J Stabilizer, Front K Foot Peg L Pedal
G
H I J
M Stabilizer, Rear N Foot Step Pad O Seat Post Adjustment Knob P Seat
R
Q
S
Accessories
Q AirDyne® Reading Rack
R AirDyne® Wind Screen
To order, go to www...
Assembly and Owner's Manual - Page 16
...per minute (BPM) from a telemetric heart rate strap. Watts The WATTS display field shows the power that you have burned during the exercise. Pulse The PULSE display shows the heart rate in... The maximum display is 99.9.
Contact your workout on the display screen. LCD Display Data The console display shows each workout value. During the initial power-up , this display will show altitude (...
Assembly and Owner's Manual - Page 17
...straps such as highly trained runners may be several beats higher or lower than by age 60. It is more fat your individual target heart rate zone.
Note: A s with this range for your body will not work with all exercises and fitness...
Target Heart Rate Zone (keep within this equipment.)
If ... a brief guideline, describing the generally suggested target heart rates based on age. ...
Assembly and Owner's Manual - Page 18
...machine using the Foot Step Pad if necessary. Lower Body Workout: Slowly pedal with your arms relaxed at the knee. 2. If your leg is fully engaged and fully tighten ... Adjustment Knob on the Seat Post.
4. Pedal straps can be reached. Operations
What to move the seat
downward. Seat Adjustment Correct seat placement encourages exercise efficiency and comfort, while reducing the risk of injury...
Assembly and Owner's Manual - Page 19
... To disengage the Locking Pin: 1. Turn a full 90 degrees and release the .... Place the machine in your arms, alter your feet on the ...Console will enter Power-Up / Idle Mode if any of the machine. Note: The Console will automatically shut...Shut-Off (Sleep Mode) If the Console does not receive any input in approximately 5 minutes, it receives a signal from the RPM sensor as you pedal, keeping...
Assembly and Owner's Manual - Page 20
... the last custom time value. With the Console in Idle Mode, push and hold down for 3 seconds to
end the workout.
The Console will go back to start pedaling.
To stop the workout, push and hold down the START/STOP button for 5 seconds. 2. When paused, the Console display will flash the current workout values of...
Assembly and Owner's Manual - Page 21
... is installed in the Idle Mode to change the value. 9. To fully exit the Console Service Mode push and hold down the Increase button and Decrease button together for 3 seconds. The Console will display which version of Firmware is installed. 1. Hold down the START/STOP button for 3 seconds while in the Speed display field...
Assembly and Owner's Manual - Page 22
.... After each use, examine the exercise machine for Indoor Cycling and can be used in this condition. Note: Avoid excessive moisture on the Console. Tighten as necessary.
Worn or damaged...damp cloth to maintain and repair the equipment. Check pedals, crank arms and handlebars. Be sure to keep the Console free of silicone lube to maintain maximum user safety and performance.
...
Assembly and Owner's Manual - Page 23
direction shown in the +/-
Do not mix old and new batteries. When replacing the batteries, make sure the batteries point in the battery bay. Note: The console uses AA size batteries (LR6). Replacing the Console Batteries The Console will display "Lbatt" for ten seconds when the batteries are around 10% of their rated power during...
Assembly and Owner's Manual - Page 24
...P
Q R S
T
A Foot Peg, Right B Handlebar, Right C Handlebar, Left D Foot Peg, Left E Water Bottle Holder F Console G Locking Knob H Spring, Knob I Console Cable, Upper J Console Support Bar K Seat L Seat Post M Foot Step Pad
24
N Seat Adjustment Knob O Frame P Stabilizer, Rear Q Shroud, Left R Crank Arm, Left S Center Plate T Pedal, Left U Pulley, Crank V Speed Sensor Magnet W Crank Belt X Pulley...
Assembly and Owner's Manual - Page 25
...Strap
Console shuts off (enters sleep mode) while in place. If any damage to the sensor or the connecting wire.
All wires in cable should line up and snap into place. Small latch on connector should be intact. Be sure cable is connected to the back of new...Console and the main frame assembly. Realign sensor if necessary. Troubleshooting
Condition/Problem
Console will not power up/ turn...
Assembly and Owner's Manual - Page 27
... products warranty coverage. Shipping of any warranty replacement parts will repair any WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, are the sole and exclusive express warranties made by Nautilus,...from state to state. When Nautilus determines replacement is not responsible for warranty support. brand Product, at the time of ownership. Service For products purchased from Nautilus, Inc...
Similar Questions
Ad6 Adjustment For Use By A Short Person.
How can the AD6 be adapted for use by a shorter person? Using the handlebars requires an exaggerated...
How can the AD6 be adapted for use by a shorter person? Using the handlebars requires an exaggerated...
(Posted by kazmirrg 1 year ago)
How To Change Console Setup On Schwinn 530
How do I change the console setup on schwinn 530. I missed it when I turned it on
How do I change the console setup on schwinn 530. I missed it when I turned it on
(Posted by georgechristinson 6 years ago)
Schwinn 225 Recumbent Bike
I Want To Purchase A New Seat And Front Panel(just The Front Blk Rubber Part
I Want To Purchase A New Seat And Front Panel(just The Front Blk Rubber Part
(Posted by pappastedted 7 years ago)
Schwinn Ad6 Parts List
I have had the AD6 bike since Feb 2014 and the small belt broke already. How do I replace it?
I have had the AD6 bike since Feb 2014 and the small belt broke already. How do I replace it?
(Posted by allisonyoung44 9 years ago)