Ryobi RY28040 Support Question
Ryobi RY28040 Support Question
Find answers below for this question about Ryobi RY28040.Need a Ryobi RY28040 manual? We have 1 online manual for this item!
Question posted by ellyl on May 1st, 2014
Ry28040 Won't Start
The person who posted this question about this Ryobi product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Ryobi RY28040 Manual Pages
Operator's Manual - Page 7
... refueling or storing the unit.
Allow the engine to follow all instructions before starting engine.
If you are all bystanders, children, and pets at idle during normal use ...usually apparent upon exposure to bystanders from refueling site before using this unit.
Never start or run the engine in cold weather.
d) Keep the tool well maintained, fasteners tightened,...
Operator's Manual - Page 11
... tighten
securely.
7 - Avoid contact with this product. ASSEMBLY
WARNING:
If any attachment while power head is fully tightened before operating equipment; WARNING:
To prevent accidental starting that could result in the button and twist the shafts to side until the button locks into place. The secondary hole in the...
Operator's Manual - Page 12
... cap, clean and inspect the gasket.
Immediately replace fuel cap and hand tighten.
STARTING AND STOPPING
See Figures 8 - 10. OPERATION
WARNING:
Do not allow familiarity with hearing protection...not recommended by a 2-cycle engine and requires pre-mixing gasoline and 2-cycle lubricant. To start a cold engine: Slowly press the primer bulb 10 times.
NOTE: After the ...
Operator's Manual - Page 13
... CUTTING TIPS
position and repeat the steps that follow.
Do not pull the starter grip more than six (6) times. NOTE: If the engine does not start, return to the HALF CHOKE position.
Pull the starter grip until the engine runs.
This will prevent grass from overheating.
WARNING:
Always hold the...
Operator's Manual - Page 15
... problem before using the product. Replace fuel cap if required. electrode gap.
STORING THE PRODUCT
Clean all foreign material from corrosive agents such as garden chemicals and de-icing salts.
Abide by pulling it from the holes on the top of gasoline. When storing 1 month or longer: Drain...
Operator's Manual - Page 16
...and pull the rope repeatedly until bulb is dirty.
3.
Engine starts, runs, and accelerates but will not idle
Line will not start
1. Remove line from the top down on and
releasing spool ...Grass wraps around drive shaft housing and string head
1. Push primer bulb until the engine starts and runs. If primer bulb fills, engine may require numerous pulls of fuel. Air...
Operator's Manual - Page 19
...:
(1) Fuel Metering System
(i) Carburetor and internal parts (and/or pressure regulator or fuel injection system).
(ii) Air/fuel ratio feedback and control system.
(iii) Cold start enrichment system.
(iv) Fuel Tank.
(2) Air Induction System
(i) Controlled hot air intake system.
(ii) Intake manifold.
(iii) Air filter.
(3) Ignition System
(i) Spark Plugs.
(ii) Magneto...
Similar Questions
Ryobi Model Ry28040 Gas Weed Eater
my ryobi ry28040 will only run on half choke. What kind of tool do i need to adjust the carb?
my ryobi ry28040 will only run on half choke. What kind of tool do i need to adjust the carb?
(Posted by rmaske2665 8 years ago)
My Ryobi Ry28040 Leaks Gas When Operating
How can i find the gas leak in my Ryobi Ry28040, as it leaks gas when operating.
How can i find the gas leak in my Ryobi Ry28040, as it leaks gas when operating.
(Posted by schratzjr 12 years ago)