Ridgid WD4070 Support Question
Find answers below for this question about Ridgid WD4070.Need a Ridgid WD4070 manual? We have 1 online manual for this item!
Question posted by jlstarks on February 5th, 2021
Cage How To Remove & Replace Cage On Ridgid Wd40700
Current Answers
Answer #1: Posted by waelsaidani1 on February 7th, 2021 6:56 AM
replaced, follow the instructions below for
proper assembly:
1. Grasp the drum latches on both the right and left side of the power head.
Slowly pull the drum latches away from the drum. Lift the power head off the
drum. Place the lid assembly of the vac upside down.
2. Remove the filter nut and the filter.
3. Use a flat blade screwdriver and insert the blade near one of the tabs between
the filter cage and the center ring of the lid. Pry the tab out of the slot. Tilt the cage and lift away from the lid.
WARNING: For your own safety,
never connect plug to power source
outlet until all assembly steps are
complete and you have read and
understood the safety and operation
instructions. Do not operate vac
with any parts damaged or missing.
4. Place the float in the center of the lid, covering the opening.
5. Line up filter cage tabs with the slots in the center ring of the lid assembly. Push on the filter cage until the tabs snap into the slots for a secure fit.
Related Ridgid WD4070 Manual Pages
Similar Questions
Hi, m'y vacuum stopped while performing to clean m'y saw bench after 10 minutes of working. I plan t...
sounds bumb but how do you replace the filter cage
Can the storage compartment that has the spindals on for the rear wheels be replaced?