How To Program Rca Rcrn04gr To Dish Network

Turn on your TV and aim the RCA universal remote control at the TV's sensor.

Hold down the "TV" key, which causes the "On/Off" key to illuminate after a few seconds.

Hold down the "On/Off" key without releasing the "TV" key. The "On/Off" key will turn off, but it turns back on after three seconds. Release both keys.

Enter the brand code key using the keypad, which causes the "On/Off" key to blink once. The brand code can be found in the RCA universal remote control's instruction manual.

Press the "On/Off" key every four seconds until the TV turns off.

Press the "Stop" key to save your code.

Turn on your TV and point the remote at the TV's sensor.

Hold down the "TV" key.

Enter the four-digit code for your TV while still holding the "TV" key. The four-digit code is found in the remote's instruction manual. The "On/Off" key will illuminate after entering the fourth digit.

Release the "TV" key. If the "On/Off" key turns off, the code was accepted. If it blinks four times, the code was not accepted; repeat the procedure using a different code.

Turn on your TV and aim the remote at the TV's sensor.

Hold down the "TV" key, which causes the "On/Off" key to illuminate.

Hold down the "On/Off" key while still holding down the "TV" key. The "On/Off" key will turn off, but it turns back on after three seconds. Release both keys.

Press the "On/Off" key every four seconds until the TV turns off, which tells you the correct code was found.

Press the "Stop" key to save the code.

Turn on your TV and point the remote at the TV's sensor.

Hold down the "TV" key, which causes the "On/Off" key to illuminate after a few seconds.

Hold down the "On/Off" key while still holding the "TV" key. The "On/Off" key will turn off, but it illuminates again after three seconds. Release both keys.

Press the "Play" key every five seconds until the TV turns off. Unlike the Manual Entry Method, this does not mean the code is found. The Automatic Code Search Method sends blocks of 10 codes to the TV, so when the TV turns off, the code is somewhere in the last 10 codes sent. Therefore, you need to back up and try each of the last 10 codes.

Press the "Reverse" key every two seconds until the TV turns on again. If you pressed the "Reverse" key too many times, press the "Forward" key until the TV turns off again.

Press the "Stop" key to save the code.

• Keep the remote pointed at the TV during the entire programming procedure.
• After entering the code, thoroughly test the TV by performing various actions using the remote control.
• The RCA universal remote works with most entertainment devices, such as TVs, DVD players and cable boxes, and allows you to separately program different codes for multiple devices.