Trouble Shooting My Pyle Chopper Series Amplifier

how do i get it out of protective mode

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by akanetuk1 on March 30th, 2022 2:46 PM

This answer was accepted by the poster of the original question.

akanetuk1

Member since:
February 6th, 2022

Points: 176,800

1,100
points

The built-in protection circuitry in the Pyle amplifiers will disable the amplifier if it senses Series an input overload, a speaker short circuit, or extreme temperature conditions. When the protection circuit is activated by any of these conditions, the Protection LED will be illuminated. If this occurs, carefully inspect the system to determine the source of the problem.

R26; If the shutdown was a result of a thermal overload

condition, allow the amplifier to cool down before

attempting to restart it.

R26; If the shutdown was a result of an input overload,

or speaker short circuit, be sure to correct the

condition before restarting.

The amplifier can be restarted by turning the remote

power OFF and then ON again

Answer #2: Posted by SonuKumar on March 31st, 2022 7:28 AM

SonuKumar

Member since:
May 9th, 2021

Points: 16,653,150

100
points

https://www.manualslib.com/manual/312162/Pyle-Pla2200.html?page=24#manual

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.

Regards,
Sonu
Your search handyman for all e-support needs!!