Pyle PS900 Support Question
Find answers below for this question about Pyle PS900.Need a Pyle PS900 manual? We have 1 online manual for this item!
Question posted by andrewnoblit on April 26th, 2021
My New Pyle Ps900 Voltage Meter Needs Calibrated.
My new Pyle PS900 voltage meter needs calibrated. It reads 169 volts on a 120 volt system.
Current Answers
Answer #1: Posted by techyagent on April 26th, 2021 12:48 PM
How to Calibrate a Digital Multimeter
Thanks
- Set the multimeter to the highest resistance range by turning the dial to the highest "ohm" setting.
- Touch the test probes of your digital multimeter together. ...
- Press the calibration knob until the display reads "0" on the digital multimeter if you don't see "0 ohms" initially.
Thanks
Techygirl
Related Pyle PS900 Manual Pages
Similar Questions
How Do I Get It Out Of No Disk Mode
how do I get out it being stuck in no disk mode
how do I get out it being stuck in no disk mode
(Posted by Vickerybrody3 11 months ago)
.microphone Is Not Recognized.
For some reason this device is not recognized my condense microphone any more. It was working well 2...
For some reason this device is not recognized my condense microphone any more. It was working well 2...
(Posted by julioturino 3 years ago)
Need New Fuse
my fuse went out on my 3808 and I need new fuse. what kind of fuse do I need and where can I get it?...
my fuse went out on my 3808 and I need new fuse. what kind of fuse do I need and where can I get it?...
(Posted by gregoryrozwalka 4 years ago)
I Assigning Channel 1 And 2 Lines To Crossfader
<I need to know how to assign line 1 and line 2 to crossfader separate channels.
<I need to know how to assign line 1 and line 2 to crossfader separate channels.
(Posted by algentryag2 6 years ago)
When I Connect To Pc With Usb Cable It Says ''a Usb Device Needs More Power''!?
There is new battery and plug with power cord to electric outlet . Device works but it can not to co...
There is new battery and plug with power cord to electric outlet . Device works but it can not to co...
(Posted by chervat 7 years ago)