Pyle PLMR19W Support Question
Pyle PLMR19W Support Question
Find answers below for this question about Pyle PLMR19W.Need a Pyle PLMR19W manual? We have 1 online manual for this item!
Question posted by eztorres7 on June 16th, 2014
Pyle Plmr19w Help
I removed the cables from my boat battery and did not see the plmr19w was not trun off. Now the radio comes on but i have no sound playing comimg out of the unit. is I tryed to reset buttom no change? Help the boat suck without music. Thank you
Current Answers
Related Pyle PLMR19W Manual Pages
PLMR19W Manual 1 - Page 1
PLMR19W
OWNER'S MANUAL
Mobile Audio System
• PLL Synthesizer Stereo Radio • Automatic Memory Storing • Preset Equalization • USB Interface • Auxiliary Input Function • Remote Control
www.pyleaudio.com
PLMR19W Manual 1 - Page 2
... DIN Front-Mount (Method A 3
Installing the unit 3 Removing the unit 4 DIN Rear-Mount (Method B 5 Wiring Connection 6 Operation 7 Location of keys 7 Switching on/off the unit 8 Sound adjustment 8 Loudness 8 Display 8 Mute 8 Equalization 8 Remote sensor 8 Reset function 8 Radio operation 8 Switching to radio mode 8 Selecting the frequency band ...........8 Selecting station...
PLMR19W Manual 1 - Page 3
... the outer trim ring then pull it out to remove it . Then slide the sleeve off ,
and then disconnect the cable from the vehicle battery's negative (-) terminal. 2.
Press the release button on the front panel and remove the control panel (see the steps of the unit.
3 Insert the keys as far as show below:
53...
PLMR19W Manual 1 - Page 4
...unit's front panel. (see the steps of
the unit. This strap
also helps ensure proper electrical grounding of the unit (if attached).
Removing the unit
1. Insert both of the supplied keys into the opening of the unit... disconnect the cable from the vehicle battery's negative (-) terminal.
2. Remove the metal strap attached the back of the unit.
4 To further secure the unit, use the...
PLMR19W Manual 1 - Page 5
... then tighten the screws (5x5mm) on each side. Align the screw holes on both sides of the unit to fasten the unit to the factory radio mounting brackets. Note: the outer trim ring, sleeve and the metal strap are not used for method B installation.
5 Use the screw holes marked T (Toyota), N (Nissan) ...
PLMR19W Manual 1 - Page 6
WIRING CONNECTION
MAIN UNIT
ANTENNA CONNECTOR
IGNITION
RED
SWITCH (ACC+)
MEMORY BACK-UP (B+)
GROUND (B-)
YELLOW BLACK
FUSE FUSE
POWER ANTENNA
FRONT Lch SPEAKER
REAR Lch SPEAKER
BLUE
WHITE WHITE/BLACK
GREEN GREEN/BLACK
RCA CABLE
(GREY) Rch RED
Lch WHITE
GREY GREY/BLACK
VIOLET VIOLET/BLACK
FRONT Rch SPEAKER
REAR Rch SPEAKER
6
PLMR19W Manual 1 - Page 8
...change in
the following reasons:
several
seconds, the radio searches from the
• REMOTE SENSOR Point the remote cantrol handset to the remote sensor IR (5). Press it for several seconds,
• EQUALIZATION Press EQ button (7) to turn off the unit.
• SOUND...Note: If press RESET button (25), the unit can be activated
strength level is on the unit by pressing any button...
PLMR19W Manual 1 - Page 9
... (until 2ND beeps come out), current station is... radio mode, then press BND button (4) to change the... band to select CH1~CH6 directly.
You can also press M1~M6 buttons (18) shortly to weather band. If in the current directory. Press and hold SCN button (20) to intro the tracks stored in other mode, you can connect an USB driver through the interface, the unit will play...
PLMR19W Manual 1 - Page 10
...cause battery burst. • When in a sequence. The current directory name and the currently playing file
10 Each time when you press M6 button (15) or M5 button (16), you should remove the battery from...will list all songs under this directory and select the title. Note: • The main unit can also use the volume knob (3) to fast select the track number. OPERATION
• ...
PLMR19W Manual 1 - Page 11
.../MMC mode. The operation is no responsibility for this. When there are important files in the USB interface, you can support: 1. Depth of the unit. And don't play MP3 files or WMA files automatically. And our company assumes no USB driver in the USB device, do not connect it to the main...
PLMR19W Manual 1 - Page 12
... : 15 Ampere (max.)
CD PLAYER Signal to Noise Ratio Channel Separation Frequency Response
: More than 55 dB : More than 45 dB : 40 Hz - 18 KHz
RADIO
Frequency Coverage IF Sensitivity (S/N = 30 dB) Stereo Separation
Frequency Coverage IF Sensitivity (S/N = 20 dB)
FM : 87.5 to 107.9 MHz : 10.7 MHz : 4 μV : > 25 dB
AM...
PLMR19W Manual 1 - Page 13
.... Wiring is in microcomputer Press the RESET button.
No sound. The operation keys The built-in minimum.
The signals are too weak. If the power supply is connected to noise.
Check wiring connection. The radio does not work . The radio station automatic selection does not work .
Insert the antenna cable firmly. do not work. into...
Similar Questions
Marine Amp
Hooked up my new 2 channel marine Amp and I get nothing when trying to play the radio . The booth to...
Hooked up my new 2 channel marine Amp and I get nothing when trying to play the radio . The booth to...
(Posted by jamesstambaugh58 10 months ago)
Cd Repeats
When playing a CD , it will play 4 songs, then go back to the first song played??????
When playing a CD , it will play 4 songs, then go back to the first song played??????
(Posted by pndltnnthny 4 years ago)
Fuse
what size of inline fuse to use in plmrkit 102. Keeps blowing fuse at 3amp
what size of inline fuse to use in plmrkit 102. Keeps blowing fuse at 3amp
(Posted by Robperry22 9 years ago)
When Any Disc Inserted Just Goes To Pause And Wont Play
Hi i have the pyle touchscreen, this is the second one i have returned one already because when i pu...
Hi i have the pyle touchscreen, this is the second one i have returned one already because when i pu...
(Posted by andygoodlead 10 years ago)
I Am Hooking It Up To My Golf Cart But It Is Not Working .need Help Please
(Posted by cleve12777 11 years ago)