Pyle PLCD3MR Support Question
Pyle PLCD3MR Support Question
Find answers below for this question about Pyle PLCD3MR.Need a Pyle PLCD3MR manual? We have 1 online manual for this item!
Question posted by chrisproulx98 on June 11th, 2015
I Cannot Get Very Much Volume From My Unit. Any Ideas?
it is about ten to 13 years old. I just fixed the fuses. The volume knob does not work smoothly. The reading jumps all around during adjustment. It works better when the loud setting is used
Current Answers
Answer #1: Posted by TechSupport101 on June 11th, 2015 9:09 PM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,305
Member since:
May 24th, 2013 Points: 12,171,305
Volume knobs are easily replace and doing so should potentially resolve your issue. I do not think the volume resistor itself is amongst the culprits.
Related Pyle PLCD3MR Manual Pages
PLCD3MR Manual 1 - Page 2
... DIN Front-Mount (Method A 3
Installing the unit 3 Removing the unit 4 DIN Rear-Mount (Method B 5 Wiring Connection 6 Operation 7 Location of keys 7 Switching on/off the unit 8 Sound adjustment 8 Loudness 8 Equalization 8 Subwoofer 8 Display 8 Remote sensor ...operation 12 Supported MP3/WMA decoding modes 13 Disc notes 13 Remote control 14 Specification 15 Trouble shooting 16
2
PLCD3MR Manual 1 - Page 3
...-mount installation, utilizing threaded screw holes at the middle left and right sides of the unit. The two supplied keys release tabs inside the unit's sleeve so you test all connected up properly and the system works properly.
• Use only the parts included with the notches facing up) into the appropriate slots at...
PLCD3MR Manual 1 - Page 4
... the slots at the middle left and right sides of the unit, then pull the unit out of the unit in place. Then use the
supplied metal strap to secure the sleeve in place. Reconnect...
5. Mount the sleeve by inserting it into the sleeve until it .
4. To further secure the unit, use the supplied hardware (Tapping Screw (5x25mm) and Plain Washer) to attach the other long threading terminal to...
PLCD3MR Manual 1 - Page 5
... not used for method B installation.
5 Use the screw... holes marked T (Toyota), N (Nissan) located on each side.
INSTALLATION
DIN REAR-MOUNT (Method B) If your vehicle. Side view showing Screw Holes marked T, N
Factory Radio Mounting Bracket
Screw
Screw
Dashboard or Console
To fasten the unit to the factory radio mounting brackets supplied with the screw holes on the unit...
PLCD3MR Manual 1 - Page 6
WIRING CONNECTION
MAIN UNIT
ANTENNA CONNECTOR
IGNITION
RED
SWITCH (ACC+)
MEMORY BACK-UP (B+)
GROUND (B-)
YELLOW BLACK
FUSE FUSE
POWER ANTENNA
FRONT Lch SPEAKER
BLUE
WHITE WHITE/BLACK
REAR Lch SPEAKER
GREEN GREEN/BLACK
SUBWOOFER CABLE (GREEN)
RCA CABLE
(GREY) Rch RED
Lch WHITE
GREY GREY/BLACK
VIOLET VIOLET/BLACK
FRONT Rch SPEAKER
REAR Rch SPEAKER
6
PLCD3MR Manual 1 - Page 7
SEL 3. BAND ( LOU) 12. MOD 13. DSP 21. MONO 22. MUTE 24. AS/PS 26. DISC SLOT 4. SHF 16. USB interface
7 OPERATION
LOCATION OF KEYS
12
3
4
56 7 8 9
25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 26
1. POWER 2. AUX IN 9. 1>> 10. 1>> 11. M6
14. DISPLAY 5. EQ 6. EJECT 8. RPT 17. 1 to 6 18. PAU 20. RESET 25. LOC 23. IR REMOTE 7. SCN 19. M5 15.
PLCD3MR Manual 1 - Page 8
...VOL
BAS
TRE
BAL
FAD
(Volume) (Bass) (Treble) (Balance) (Fader)
By rotating the audio knob (2) clockwise or counter-clockwise...work, please use a cotton swab soaked in the following reasons: -
LOUDNESS Press BND/LOU/ENT button (11) for (1 sec). EQUALIZATION Press EQ button (5) to turn off the unit.
• SOUND ADJUSTMENT Press SEL button (2) shortly to select the desired adjustment...
PLCD3MR Manual 1 - Page 9
... reception of strong stations, and a distant setting for several seconds, the radio searches from the current frequency and checks the signal strength until it beeps) to assign the current station to the ...
PLCD3MR Manual 1 - Page 10
...does not contain any directory, there is playing, press M5 button (14) or M6 button (13), the unit will search the disc again and start to play all tracks on the current disc. Press it ...play all tracks on display.
• SELECTING DIRECTORY UP/DOWN Press M5 button (14) or M6 button (13) to pause MP3 player. Hold button (10) or button (9) to continuously repeat the same track. Track ...
PLCD3MR Manual 1 - Page 11
...select the title. -
Searching Directory or File Name Press AS/PS (D-AUD) button twice. The unit searches files and directories that have the same character which is inputted by pressing BND/LOU (ENT)...be pressed. It enters into "Searching Directory or File Name" in MP3 operation. The unit searches the track selected by using TUNE/SEEK/TRACK UP/DOWN buttons and BND/LOU (ENT) button (24) to ...
PLCD3MR Manual 1 - Page 12
... USB driver through this way, you can only support the
AUDIO KNOB & TUNE/SEEK/ TRACK UP/DOWN buttons:
standard USB-memory disc. • USB MP3 player...MP3 files, press M5 button (14) or M6 button (13), it jumps to play the CD tracks again. USB PLAY OPERATION
TUNE/SEEK/ TRACK DOWN
V, W, X, 8
On the front panel of unit, there is the same with the MP3 operation described as ...
PLCD3MR Manual 1 - Page 13
... also press MODE button (11) to select SD/MMC
conditions of the disc and the equipment used for the unit to play:
CAUTION:
When there are important files in the card and start to 4x
mode.... label side or the recording side of folder: 8 layers 4. If in the USB device, do not connect it .
13 Standard
MPEG1 Audio Layer 3 (44.1kHz) Windows Media Audio (44.1kHz)
Bit Rate (kbps)
32, 48, 64...
PLCD3MR Manual 1 - Page 14
...
Display Button
3. VOL
Volume Down Button
6. MODE
Mode Button
8. PAU
Pause Button
13. Mute
Mute Button
14 M1 - REMOTE CONTROL HANDSET
1 743
8
9
6
5
13
2
12
14
11
...10
15
16
FUNCTION KEYS & CONTROL
1. BND (LOU)
Band Select Button (When pressed momentarily)
Loudness...
PLCD3MR Manual 1 - Page 16
...fuse is more than 30 degrees.
Compact disc is extremely Clean the disc or try to play a new one.
The installation angle is blown.
The operation keys The built-in a new one . do not work . into its place. The radio station automatic selection does not work...Adjust volume to normal.
Insert the compact disc with the label facing upward. Wiring is not properly fixed...
Similar Questions
Cd Repeats
When playing a CD , it will play 4 songs, then go back to the first song played??????
When playing a CD , it will play 4 songs, then go back to the first song played??????
(Posted by pndltnnthny 4 years ago)
Pyle Plcd6mrkt Trouble Shooting
Good afternoon,I have the Pyle PLCD6MRKT, this past Sunday none of the buttons were responding corre...
Good afternoon,I have the Pyle PLCD6MRKT, this past Sunday none of the buttons were responding corre...
(Posted by chr01108 5 years ago)
How To Turn Off Amplifier
Manual states that when volume control is turned all the way down on a model 4A the amplifier will t...
Manual states that when volume control is turned all the way down on a model 4A the amplifier will t...
(Posted by darrylsiss1 9 years ago)
Problem With A Tone Appearing In The Output When At Low To No Volume
with volume at low to no volume a squeal is present. At higher volume it goes away but returns withi...
with volume at low to no volume a squeal is present. At higher volume it goes away but returns withi...
(Posted by atkindavis 10 years ago)
No Power.
I instol Lyle PLCD3MR,and work's fine. Never used after thad. Three monds later I finde the battery ...
I instol Lyle PLCD3MR,and work's fine. Never used after thad. Three monds later I finde the battery ...
(Posted by marino65774 10 years ago)