Poulan PR46BT Support Question
Find answers below for this question about Poulan PR46BT.Need a Poulan PR46BT manual? We have 1 online manual for this item!
Question posted by fkb9785 on August 21st, 2023
Factory Carb Setting
Current Answers
Answer #1: Posted by SonuKumar on August 21st, 2023 8:29 PM
Turn off the blower and disconnect the spark plug wire.
Locate the reset button on the side of the blower. It is a small, black button with a red dot in the center.
Press and hold the reset button for 10 seconds.
Release the button and reconnect the spark plug wire.
Turn on the blower and test it to make sure it is working properly.
Here are some additional things to keep in mind when resetting the Poulan PR46BT:
Make sure that the blower is turned off and the spark plug wire is disconnected before you start.
Press and hold the reset button for a full 10 seconds.
If the blower does not start after you have reset it, you may need to take it to a qualified technician for further diagnosis.
I hope this helps!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Poulan PR46BT Manual Pages
Similar Questions
Need intermediate and nozzle tube pipe screws?Poulan pro Pr46bt backpack??
Factory settings for a 34cc poulan carburetor
Blower will start, but only on full choke. Put new fuel lines, new plug, new fuel filter, but seems ...