Poulan 380ZX Support Question
Poulan 380ZX Support Question
Find answers below for this question about Poulan 380ZX.Need a Poulan 380ZX manual? We have 2 online manuals for this item!
Question posted by bewilliams on October 6th, 2014
Poulan Pro 380 Zero Turn Mower Will Not Move
new drive belt on tranmission but mower not moving properly. moved good at first but moved slow after thirty minutes of mowing.
Current Answers
Answer #1: Posted by TechSupport101 on October 6th, 2014 5:40 PM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,305
Member since:
May 24th, 2013 Points: 12,171,305
Hi. Apart from a faulty motion drive belt, a weak battery or air caught up in the transmission can result in drive loss or slowness.
Related Poulan 380ZX Manual Pages
User Manual - Page 3
... 5 General 5 Driving and Transport on Public Roads 5 Towing 5 Operating 5 Good Service 6 Manufacturing ...Engine 24
Jumper cables 27
Running 28 Operating on Hills 29 Mowing Tips 30 Stopping the Engine 31 Manual Transport 32 maintenance 33... 36 Parking Brake 37 V-belts 37 Deck Belt 37 EZT Belt 38 Cutting Blades 38
Blade replacement 38 Adjusting the Mower Deck 39
Leveling Deck 39...
User Manual - Page 4
... certain vehicle components contain or emit chemicals known to the State of any mind altering substance. Each person operating the mower must be under the influence of California to operate the mower. WARNING! Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State of California to...
User Manual - Page 5
... operated, maintained, and repaired by steering controls both contribute to rapidly mow primarily large areas. Do not tow on public roads. Use only approved repair parts to change without fail.
Lawn mowers and all who are subject to maintain this machine on mower.
Continuous dedication to improve our products require that specifications and design...
User Manual - Page 13
...Remove gas-powered equipment from the engine and the sun may otherwise cause the fuel to cool at least two (2) minutes before refueling.
• Never fuel the machine indoors.
• Never store the machine or fuel container where ... near spilled fuel.
• Never use and leave space for the mower deck's drive belt is complete. Never fill the fuel tank indoors
8011-516
WARNING!
User Manual - Page 16
.... This mower is equipped with an internal combustion engine and should not be lifted by local traffic regulations before transporting the machine on or near ditches, canals, and other hazards. It may cause loss of traction and loss of suitable strength using a slow speed.
WARNING!
WARNING! Make wide turns to the drive system.
•...
User Manual - Page 17
... Blade control lever 7. Park brake 3. The rider is regulated and thereby the direction and speed.
1
2
3
4
CHOKE FAST SLOW
5
6
7
8
9
1. Fuel tank cap 8. Bypass linkage
8077-001
17 CONTROLS
This operator's manual describes the PoulanPro Zero Turn Rider.
Control Locations
Transmission from the engine is made via belt-driven hydraulic pumps. Motion control levers
6.
User Manual - Page 18
... in uneven positions when standing still or do not fit in the slots for example, to turn very rapidly if one control backward (behind the neutral position.
The rotation direction when zero turning is determined by moving forward, move the right control towards the neutral position. If the left .
Neutral slot, Neutral lock 4. When both...
User Manual - Page 21
...and level concrete or blacktop surface.
The fuel valve is ON when the valve is used to turn clockwise to temporarily adjust the cutting height, such as when passing a minor bump in the transport... high position (F) to the fuel line. IMPORTANT INFORMATION
In order to place the mower deck in the lawn. Fuel shut off valve is not tracking straight, check the air pressure in the notch...
User Manual - Page 23
... in that direction. Additionally, we suggest when first operating the mower, use a reduced throttle speed and reduced ground speed by NOT moving . We also suggest first time users, or new users to Zero Turn mowers to become familiar with mower controls and zero turning capability, they return to start engine (see Manual Transport in a forward direction, first pull both...
User Manual - Page 28
... a straight line forward or backward respectively.
Engage the mower blade by the operator to leave the seat without first setting the parking brake will shut off the engine.
2.
In order, for example, to the right. operation
Running
1. Turning on the spot (zero turn right while moving one is equipped with an operator presence system. The...
User Manual - Page 29
... necessary, pull drive levers into the neutral position and push to the outside of the unit and engage the parking brake.
• To restart movement, release the parking brake.
• Pull the control levers back to the center of the mower and press forward to regain forward motion.
• Make all turns slowly.
User Manual - Page 30
The average lawn should be mowed twice. When cleaning, the mower deck shall be raised into the soft lawn, clumps build, and the grass clippings fasten under the cowling.
• Hose the mower deck underside with water after moderate growth. Avoid flooding water on terrain that slopes more evenly distributed over the mown area. Never drive the...
User Manual - Page 31
... order to the minimum position (tortoise symbol).
Turn the ignition key to prevent unauthorized use choke to be discharged.
Raise the mower deck with the lifting lever
8058-074 8058-... when leaving the
mower to the stop the engine.
• Move the steering controls outward. • Remove key. operation
Stopping the Engine
Allow the engine to idle a minute in any other position...
User Manual - Page 34
... brake. • Place the Blade-switch in the disengaged position. • Turn the ignition switch to Lubrication Schedule 3,4)
●
●
●
■... cable Check the condition of belts, belt pulleys Change the engine oil... (every 200 hours) Check/adjust the mower deck Check the engine valve clearance 4)...8226; Make sure the blades and all moving parts have completely stopped. • ...
User Manual - Page 36
...again. Check that prevents starting or driving under the following conditions.
The steering controls are engaged and the driver temporarily moves off and repair the safety system ...moved into the neutral position, otherwise the engine will stop. MAINTENANCE
Safety System
The machine is disengaged.
2.
The mower deck is equipped with a safety system that the engine stops if the mower...
User Manual - Page 38
...Belt
To replace EZT belt Park the mower on the EZT as this section of blades should be removed from the engine pulley and EZT pulleys. Create slack in the belt by turning counterclockwise. 2. Wrap the EZT belt.... Install new or resharpened blade with a PoulanPro bolt if required. Torque blade bolt to cool at least two (2) minutes. The sharpening of the manual). 2. Belt installation 1....
User Manual - Page 39
... the mower in a base measurement position. See Technical
Data section. 3. Disconnect the spark plug wire from all spark plugs and place the wire where it cannot
come in all moving parts have completely stopped. 5. Check the pressure in contact with a heavy cloth when handling.
WARNING!
Rotate blade to align side to
side. Turn...
User Manual - Page 40
... under the mower deck, will void the warranty.
1
Removal and installation of the fork and take the unit to the cleanout port and turn on the engine and electrical components. After mowing, snap the...tires. Inspect the entire machine for service. IMPORTANT INFORMATION
DO NOT add any garden hose. Make it is away from the accessory packet) to clean the machine directly after use ...
User Manual - Page 44
... terminal cable connectors.
• Parking brake on. • Hydraulic pump bypass linkage engaged. • Drive belt for the transmission gears slack or has
come off. • Defective hydraulic system. • Air in hydraulic system.
• Drive belt for the mower deck has come loose. • Contact for the electromagnetic coupling has
loosened. • Blade switch...
User Manual - Page 45
...Turn over the engine so that the oil is a good way to stand for long periods of the mower deck to the fuel in the tank or in use the mixing ratios specified by the manufacturer of properly...steps:
1. An annual checkup at least 10 minutes after adding the stabilizer so that may have added...spark plug and pour about a tablespoon of the mowing season, the machine should be in the storage ...
Similar Questions
Why Does The Belt Put On Keep Coming Off Poulan Pro 380zx
Every belt we put on mows for a little bit and then comes off. What are we doing wrong
Every belt we put on mows for a little bit and then comes off. What are we doing wrong
(Posted by pattya66 1 year ago)
Stering Hard To Turn
after replacing the drive belt, I noticed that it was hard to turn. any suggestions?
after replacing the drive belt, I noticed that it was hard to turn. any suggestions?
(Posted by Anonymous-151048 9 years ago)
