Oreck U3700HH Support Question
Oreck U3700HH Support Question
Find answers below for this question about Oreck U3700HH.Need a Oreck U3700HH manual? We have 1 online manual for this item!
Question posted by daparkers on September 1st, 2012
Where Can I Get New Brushes For The Motor Of The U3700hha?
The person who posted this question about this Oreck product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Oreck U3700HH Manual Pages
Owners Guide - Page 1
...; Trouble Diagnosis • Accessories ENGLISH
75672-02 REV E
B
S I M P LY
A M A Z I N G®
FRANÇAIS
GUIDE D'UTILISATION PAGE 6
E S PA Ñ O L
GUIA DEL USUARIO PAGE 11
USER'S GUIDE
U3700HH
HIGH SPEED UPRIGHT VACUUM CLEANER WITH
®
CLEANING SYSTEM
American Express
For Service Call: 1-800-471-1446
•IMPORTANT•
SAVE THIS BOOKLET!
Owners Guide - Page 3
...8226; Do not let the unit run appliance over area rug edges and fringe. The motor bearings are unable to pick up flammable or combustible liquids, such as gasoline or lighter fluid... Worn Belt, To Adjust or Replace Brush, Using an Oreck Fresh Air® Tab, Bulb Replacement, Stuffing or Blockage page 5
Maintenance and Customer Service
Your Oreck vacuum cleaner is a safety feature. Light ...
Owners Guide - Page 4
..., WHETHER EXPRESS OR IMPLIED, WILL APPLY AFTER THIS PERIOD.
Brush is broken. Replace belt. Make sure words "OLD" or "NEW" match at both ends.
This limited warranty applies to state...• Are pores of expendable or consumable parts such as carbon motor brushes, edge brushes, drive belts, bulbs, disposable bags and other warranty obligation with powder or fine dust? &#...
Owners Guide - Page 5
... 4
4. DO NOT operate the cleaner without a paper filter dust bag. Operating Recommendations
This new ORECK XL High-Speed Upright is dangerous to it cleans, gets under warranty.
6. The following ...important for vacuum use ONLY ORECK genuine belts. Be sure the disposable paper filter dust bag is in place. Wipe the outside of the cleaner.
8.
Secure to the motor and brush bearings.
...
Owners Guide - Page 6
...already been made and bristle height does not extend above baseplate, a new brush assembly should be cleaned. fig. 21 Your ORECK XL vacuum cleaner has a special ORECK FRESH AIR® tab pocket. Pull...coat hanger. Vacuum will hinge downward. Then reinsert tube and push down screw and tighten. If there is blockage, remove it is removed.
fig. 16 Loop the new belt over the motor drive shaft...
Similar Questions
Oreck Xl 2600 Brush Issues
I replaced the old worn brush with a new one. i set the "new" tabs up and tried to attach the bottom...
I replaced the old worn brush with a new one. i set the "new" tabs up and tried to attach the bottom...
(Posted by jack21453 9 years ago)
I Have Model U3700hh. Does It Lay Flat To Clean Under A Bed. No Hose,attachmem
(Posted by msmadeline24 11 years ago)
My 2600hh Sparks On The Armature. Will New Brushes Stop This.
The old brush's don't look bad and motor runs.
The old brush's don't look bad and motor runs.
(Posted by jmyers3940 11 years ago)
Looking For A Wiring Diagram For The Off/on Switch For Oreck U3700hh
I am replacing the off/on switch part # 294927 on the oreck U3700hh. Have disassembled the handle an...
I am replacing the off/on switch part # 294927 on the oreck U3700hh. Have disassembled the handle an...
(Posted by srpctm 12 years ago)