Miele T 8023 C Support Question
Miele T 8023 C Support Question
Find answers below for this question about Miele T 8023 C.Need a Miele T 8023 C manual? We have 2 online manuals for this item!
Question posted by nancyroscelli on February 1st, 2020
Lint Behind Condenser Miele T8023c
I had have this exact dryer for a few years. I clean the condenser as you have shown regularly since we have a dog that sheds a lot.Two questions I have -1) When the condenser is taken out, there is a fair amount of lint build up in the way back of where the condenser lives. I get most of it out with my vacuum.2) Recently there has been a build up of condensation around the 'large window' so that a small puddle of water ends up dripping out onto the floor.Any thoughts on either of these issues?Thanks,Nancy
Current Answers
Related Miele T 8023 C Manual Pages
Operating and Installation manual - Page 1
US, CA
M.-Nr. 09 460 400
en - Operating and Installation Instructions
Condenser Dryer T 8023 C
To prevent accidents and appliance damage read these instructions before installation or use.
Operating and Installation manual - Page 2
... a program 12 Adding or removing laundry during a program 12 Child lock 13 Dryer care 14 Cleaning the lint filter 14 Cleaning the exterior and the control panel 15 Cleaning the drum 15 Emptying the condensed water container 16 Cleaning the condenser 17 Quick Guide 19 Dryer Care 19 Changing the light bulb 19 Frequently asked questions 20 After sales service 22...
Operating and Installation manual - Page 3
... Loose filling could cause the laundry to ignite when heated even after use fabric softener sheets to a chemical reaction that have been previously cleaned, washed, soaked or spotted ...If these operating instructions. items with flammable cleaning agents or items containing acetone, alcohol, petrol, stain remover, wax or chemicals from the dryer.
- items treated with padding or filling...
Operating and Installation manual - Page 4
....
~ WARNING - Contact a qualified electrician if you are not too hot to handle
~ Clean the lint filter before or after
each
stage of the program selected, including the cooling down phase. This.... IMPORTANT SAFETY INSTRUCTIONS
~ Allow the dryer to complete each load.
~ Keep the area around the air intake
(toe kick) and adjacent surrounding areas free from lint, dust and dirt.
~ The interior...
Operating and Installation manual - Page 5
... child lock has been activated or if a fault occurred.
5 Interrupts a program when pressed. If the dryer is opened.
f "FAULT" indicators
An illuminated indicator will go off . d "Status" display Shows the current cycle of the finished laundry. Flashes during program selection and lights once the program starts.
h "Door" button
Opens the door when...
Operating and Installation manual - Page 7
... sheet may clog the filters and cause the dryer to open the door.
^ Load the laundry loosely into the drum.
^ Make sure the lint filters are in the closed door.
7 Turn on the dryer and load the laundry
^ Press the "On/Off" button to turn on the dryer.
^ Press the "Door" button to overheat.
^ Press the...
Operating and Installation manual - Page 8
... which allow machine drying.
sheets,
-
To prevent moisture loss, roll up the laundry until ironing.
e.g.
cotton, linen or permanent press
fabrics made of cotton, e.g. ...shrink.
Normal
Knitted cotton fabrics that wrinkle
requiring an ironed finish. Using the dryer
Program
Fabric
Note
Normal Available drying options: Turbo, Gentle, Anti-crease
Extra Dry...
Operating and Installation manual - Page 9
Using the dryer
OPTIONS
Turbo Fast drying for about 1 hour.
9 Gentle For drying delicate fabrics slowly at a lower temperature. Anti-crease Prevents wrinkles if laundry is not removed immediately after the end of the button. Select a drying option (if needed)
^ A drying option can be selected or deselected with increased temperature ...
Operating and Installation manual - Page 11
... "Start/Stop" button. See "Frequently asked questions" for details.
^ Press the "Door" button. ^ Open the door. ^ Remove the laundry. ^ Check that the drum is empty. ^ Clean the lint filter after each use
(see "Dryer care"). ^ Close the door.
^ Press the "On/Off" button to turn off the dryer.
^ Empty the condensed water container weekly (if not connected...
Operating and Installation manual - Page 12
...to stop the drying program. To continue drying:
^ Select the new program by pressing the e or - Adding or removing laundry during a program
^ Turn off the dryer using the "On/Off" button.
^ Press the "Door" button.
^ Open the door.
,CAUTION - There is ... a dryness level (available in the drum.
^ Add or remove items.
^ Close the door.
^ Turn the dryer back on with the "On/Off" button.
12
Operating and Installation manual - Page 14
Dryer care
Cleaning the lint filter
The lint filter must be cleaned after every program.
^ Open the door and remove the lint filter, 1, by gently lifting it upwards.
^ Remove the lint from the door frame lint filter with your fingers.
^ Any lint remaining in the hollow casing of the door can be removed through the gap at the bottom with...
Operating and Installation manual - Page 15
..., scouring pads, steel wool or caustic (oven) cleaners on the dryer.
Lock the door frame filters.
^ Wipe clean with hot water if necessary. Cleaning the drum
The filters must be cleaned with warm water and liquid dish soap applied with a soft sponge.
^ Wipe dry. Dryer care
The lint filters can be rinsed with a soft cloth.
15...
Operating and Installation manual - Page 16
... started, or if it clicks into place. ^ Restart the drying program if needed. Dryer care
Emptying the condensed water container
Depending on the installation, the condensed water will either be emptied weekly. Should the container be full when the tumble dryer is empty, push it
back into its opening until it becomes full during...
Operating and Installation manual - Page 17
... of electric
shock, disconnect the dryer from the power supply by shutting off the power main, tripping the circuit breaker or unplugging the power cord before performing maintenance.
^ Clean the condenser every 6 months and when the "Filter/Vent" indicator lights. Dryer care
Cleaning the condenser
,To reduce the risk of the condenser access area.
^ Pull out the...
Operating and Installation manual - Page 18
... and locked in the reverse order.
Rinse the condenser until clean.
^ Place the condenser lengthwise on a towel to air dry.
18 Dryer care
Rinsing the condenser
Returning the Condenser
^ Put the condenser back in place in place.
^ Restore power.
^ Rinse the condenser along the left side with warm water.
^ Rinse the condenser from the front with warm water.
^ Check...
Operating and Installation manual - Page 20
button until the desired program indicator lights.
3. Make sure that laundry will not be selected or deselected with a firm swing - do not push it shut.
^ A ... door.
^ Close the door with each press of the button. Quick Guide
1.Turn on the dryer.
^ Press the "Door" button to open the door.
^ Load the laundry into the drum. Select a program
^ Press the "On/Off" button to turn on the...
Operating and Installation manual - Page 21
Select the dryness level
Quick Guide
5. 4. Select the buzzer (if desired) 6. Start the program
^ Press the selection button until the desired indicator illuminates.
^ Press the "Start/Stop" button.
7. At the end of a program The "Anti-crease / End" indicator will light. ^ Press "Door" and remove the laundry. ^ Clean the lint filter. ^ Press the "On/Off" button to turn off
the dryer.
Operating and Installation manual - Page 25
... opening? What if the laundry is clogged with the dryer's Select a timed program to increase
the dryer. Reduce the load size.
Remove any blockages. Clean the lint filters (see
detergent residue. Possible fault
This is insufficient. See "Dryer care". The laundry was not spun sufficiently in Select a higher spin speed in the room is condensed moisture from the...
Operating and Installation manual - Page 35
... enough, an extension hose is available as an optional accessory from the Miele.
^ Pull the drain hose off the holder.
^ Drain remaining water in the middle clamp to be damaged!
^ The drain hose holds a small amount of the dryer.
The condensed water can also be drained directly if the machine is installed near...
T8023C Condenser Dryer - Page 2
Condenser Tumble Dryer T 8023 C
FEATURES European standard capacity Honeycomb Drum™ with interior light Electronic moisture monitoring Buzzer on/off Anti-creasing...; Standard programs: Extra Dry,
Wrinkle-Free, Woolens, Smooth, Sturdy, Fluff, 20 minute, 30 minute Program options: Turbo, Full Load, Gentle
FOREVER BETTER
T 8023 C Page 2 of 3
Similar Questions
Miele T8033 C Water In Condensor Part
Hi, I just opened my dryer to clean and there was a ton of water in the condensor part. I had water ...
Hi, I just opened my dryer to clean and there was a ton of water in the condensor part. I had water ...
(Posted by DaphneLM 1 year ago)
Buzzer Signals At End Of Dry Cycle Even When It Isnt Selected. Any Tips?
(Posted by Jstorm60 2 years ago)
Hi My Dryer Is Not Heating Up. What Can The Problem Be ?
Hi my dryer is not heating up. What can the problem be ?
Hi my dryer is not heating up. What can the problem be ?
(Posted by Payalkedia 6 years ago)
