2004 Mercury Mountaineer Support Question
2004 Mercury Mountaineer Support Question
Find answers below for this question about 2004 Mercury Mountaineer.Need a 2004 Mercury Mountaineer manual? We have 10 online manuals for this item!
Question posted by qmvfw7997 on May 12th, 2014
Trailer Lights
My Trailer running light and turn signals do not work ! What fuses controls this circuit.
Current Answers
Related Manual Pages
Owner's Manual - Page 14
If the light continues to flash, have the system serviced immediately. Speed control: Illuminates when the speed control is locked. AWD LOCK
DOOR AJAR
Turn signal: Illuminates when the left in the...the OFF/LOCK or ACCESSORY position and the driver's door is left or right turn signal or the hazard lights are turned on.
AWD lock (if equipped): Illuminates when all wheel drive (AWD) is ...
Owner's Manual - Page 33
... in , and position and the the high beams are not turned on. The autolamp control, located on the headlamp control, may be set to: • turn on the lamps automatically at night • turn the autolamps on for up to turn on . To turn off .
Lights
Lights
HEADLAMP CONTROL Turns the lamps off the lamps automatically during the daylight • keep...
Owner's Manual - Page 36
Adjust the aim by turning the adjuster control either clockwise (to adjust down to activate the left turn signal. • Push up ). TURN SIGNAL CONTROL • Push down ) or counterclockwise (to adjust up to turn signal.
The reading portion, the two outer lights, can only be toggled on . • any door is opened. • the instrument panel dimmer switch is not...
Owner's Manual - Page 40
Remove the two headlamp retainer pins, then pull headlamp forward.
3. Carefully pull old bulb out of the lamp assembly
Reverse steps to reinstall bulb(s).
40
2004 Mountaineer (mnt) Owners Guide (post-2002-fmt) USA English (fus) Remove the bulb socket from the lamp assembly. 4. Turn OFF the headlamps and open the hood. 2. Lights
Replacing front parking/turn signal bulbs 1.
Owner's Manual - Page 113
...activation programming procedure. Wait until the safety belt warning light turns off .) Read steps 1 - 9 thoroughly before proceeding with Autolamps, the Autolamps feature MUST be turned off . (Approximately 1-2 minutes) • Steps ... belt is unbuckled • the parklamps/headlamps are 40 times more likely to the RUN (or ON) position. (DO NOT START THE ENGINE) 2. To disable (one-time)...
Owner's Manual - Page 114
...the safety belt warning light turning off , then followed by flashing the safety belt warning light four times per second for three seconds, followed by flashing the safety belt warning light four times per .... 4. Safety belt maintenance Inspect the safety belt systems periodically to operate properly, they work properly and are no nicks, tears or cuts. Inspect the safety belts to make...
Owner's Manual - Page 170
... connect a trailer's hydraulic brake system directly to the vehicle's taillamp circuits, because it may be required. Make sure all running lights, brake lights, turn signals and hazard lights are required on long, steep grades. 170
REVIEW COPY: 2004 Explorer (exp), Owners Guide (post-2002-fmt) (own2002), Market: USA English (fus) Contact your vehicle's brake system. The speed control may...
Owner's Manual - Page 182
Roadside Emergencies
The high-current fuses are coded as follows: Fuse/Relay Location 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Fuse Amp Rating 60A** 30A** - 30A** 40A** ...point #2 Not used Power point #1 ABS module (valves) Powertrain Control Module (PCM) Ignition relay, Starter relay Trailer tow battery charge, Trailer tow turn signals Not used Memory (PCM/DEATC/Cluster), Courtesy lamps
182
REVIEW ...
Owner's Manual - Page 240
...to turn off the speed control in ...the top cruise gear and with steady pressure on the gas pedal. • Four-wheel-drive operation (if equipped) is less fuel efficient than gasoline, you will reduce fuel economy. • Use recommended engine oil. Conditions • Heavily loading a vehicle or towing a trailer... bug deflectors, rollbars/light bars, running boards, ski/luggage racks...
Owner's Manual - Page 279
... fluid, checking and adding (automatic) ...245 fluid, refill capacities ...263 lubricant specifications ..265, 267 Trunk ...82 Turn signal ...36 V Vehicle dimensions ...267 Vehicle Identification Number (VIN) ...269 Vehicle loading ...161 Ventilating your vehicle ...138 W Warning lights (see Lights) ...10 Washer fluid ...219 Water, Driving through ...161 Windows power ...48 rear wiper/washer ...44...
Scheduled Maintenance Guide 5th Printing - Page 13
... material. ❑ Check battery performance. ❑ Check operation of horn, exterior lamps, turn signals and hazard warning lights. ❑ Check radiator, coolers, heater and air conditioning hoses. ❑ Inspect windshield ...as the way to keep your vehicle running right, it is important that you have the systems on your vehicle keeps running great.
MULTI-POINT INSPECTION
In order...
Owner Guide 2nd Printing (Spanish) - Page 326
.... If the indicators stay on . Key-in-ignition warning chime: Sounds when the key is left or right turn signal or the hazard lights are on, the ignition is off when the speed control system is locked. Turns off (the key is not in the ignition) and the driver's door is opened . Door ajar (if...
Owner Guide 2nd Printing (Spanish) - Page 345
... , and position and the high beams are not turned on , rotate the control counterclockwise to . Pull headlamp control towards the instrument panel to turn foglamps on .
Push the headlamp control towards you to turn on the parking lamps, instrument panel lamps, license plate lamps and tail lamps. Lights
Lights
HEADLAMP CONTROL Turns the lamps off the lamps automatically during the...
Owner Guide 2nd Printing (Spanish) - Page 348
... OFF. Horizontal aiming is not required for each headlamp. TURN SIGNAL CONTROL • Push down ) or counterclockwise (to adjust up to activate the left turn signal. • Push up ). The reading portion, the two outer lights, can only be toggled on . • any of the remote entry controls are pressed and the ignition is non-adjustable. Adjust...
Owner Guide 2nd Printing (Spanish) - Page 352
... by its plastic base and do not touch the glass. Lights
5. Carefully pull old bulb out of the lamp assembly
Handle a halogen headlamp bulb carefully and keep out of children's reach. Turn OFF the headlamps and open the hood. 2. Replacing front parking/turn signal bulbs 1. The oil from your hand could cause the bulb...
Owner Guide 2nd Printing (Spanish) - Page 426
... sure they work properly and are no nicks, tears or cuts. Ford Motor Company recommends that all safety belt assemblies in use in vehicles involved in 114 Seating and Safety Restraints
1. Wait until the safety belt warning light turns off , buckle then unbuckle the safety belt. • This will have to the RUN (or...
Owner Guide 2nd Printing (Spanish) - Page 481
... vehicle may damage the electrical system resulting in proper trailer tow wiring installation.
Make sure all running lights, brake lights, turn signals and hazard lights are required on long, steep grades. 169 Never connect any trailer lighting to your chances of the vehicle hitch. The speed control may be required. Do not attach safety chains to the manufacturer's specifications...
Owner Guide 2nd Printing (Spanish) - Page 493
Roadside Emergencies
The high-current fuses are coded as follows: Fuse/Relay Location 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Fuse Amp Rating 60A** 30A** - 30A** 40A** 60A** 20A** - 20A** ...Not used Power point #1 ABS module (valves) Powertrain Control Module (PCM) Ignition relay, Starter relay Trailer tow battery charge, Trailer tow turn signals Not used Memory (PCM/DEATC/Cluster), Courtesy lamps
181
Owner Guide 2nd Printing (Spanish) - Page 552
...go driving. Maintenance and Specifications
• Revving the engine before turning it off the speed control in hilly terrain if unnecessary shifting between third and fourth gear ... a trailer may reduce fuel economy at any speed. • Carrying unnecessary weight may reduce fuel economy (approximately 0.4 km/L [1 mpg] is lost for example bug deflectors, rollbars/light bars, running boards,...
Owner Guide 2nd Printing (Spanish) - Page 592
... fluid, checking and adding (automatic) ...245 fluid, refill capacities ...263 lubricant specifications ..265, 267 Trunk ...82 Turn signal ...36 V Vehicle dimensions ...268 Vehicle Identification Number (VIN) ...270 Vehicle loading ...162 Ventilating your vehicle ...139 W Warning lights (see Lights) ...10 Washer fluid ...219 Water, Driving through ...162 Windows power ...50 rear wiper/washer ...45...
Similar Questions
Turn Signals Won't Work, Checked Fuses. Now What 97 Mercury Mountaineer.
Slid threw ditch due to bad weather . Turn signals won't work, hazards, horn ,back defrost,and wiper...
Slid threw ditch due to bad weather . Turn signals won't work, hazards, horn ,back defrost,and wiper...
(Posted by GOODMAYNRD 10 years ago)
How Does The Warning Low Tire Pressure Light Turn Off On A 2004 Mercury
mountaineer
mountaineer
(Posted by wickeMef 10 years ago)
Car Turns Off, Battery Light On, Car Hot Gage Not Showing This
(Posted by cancerpisces559 10 years ago)
What Would Cause Brake Lights To Stop Working? Changed Bulbs, Checked Fuses.
(Posted by jcurtismiddleton 11 years ago)
Blinkers/ Turn Signal
Left turn signal doesn't wrk in front or the back was tld tht maybe it has something to do with wiri...
Left turn signal doesn't wrk in front or the back was tld tht maybe it has something to do with wiri...
(Posted by lsapphire 11 years ago)