2001 Mercury Mountaineer Support Question
2001 Mercury Mountaineer Support Question
Find answers below for this question about 2001 Mercury Mountaineer.Need a 2001 Mercury Mountaineer manual? We have 4 online manuals for this item!
Question posted by essence247 on September 22nd, 2013
Fuse For Rear Break Lights My Break Lights Not Working
The person who posted this question about this Mercury automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by TexasDeviL on September 22nd, 2013 1:45 AM
TexasDeviL
Member since:
December 27th, 2012 Points: 960,825
Member since:
December 27th, 2012 Points: 960,825
There isnt a seperate fuse for just the brake lights. When the brake lights go out its the brake light switches fault.
http://www.jcwhitney.com/1998-2001-mercury-mountaineer/oe-brake-light-switch/p3067836d1604y1998-200
If you agree that the answer I provided is correct please remember to "accept" and/or mark it as "helpful" so I know I'm doing a good job. Thank you, I would really appreciate it.
[automotive mechanic and phone modding enthusiast]
Related Manual Pages
Four Wheeling Supplement 3rd Printing - Page 12
...as effectively as dry brakes. Shift to keep from bogging down. This could cause the rear to travel 12 This will also help prevent spinning the wheels while maintaining sufficient momentum ...can dry the brakes faster by driving the vehicle slowly while applying light pressure on the accelerator. Driving on the rear tires. Never drive with 4WD or AWD
Water Before driving through water...
Scheduled Maintenance Guide 5th Printing - Page 32
... coolant, if equipped Change automatic transmission/transaxle fluid and filter Change rear axle lubricant on all rear wheel drive (RWD) vehicles (See page 34) Replace accessory drive... belt(s) (if not replaced within last 100,000 miles) Replace climate-controlled seat filters (Navigator, if equipped) Additional services for: Light...
Scheduled Maintenance Guide 5th Printing - Page 34
... lubricant should be changed anytime the axle has been submerged in water. Normal Schedule
Normal Schedule Normal Vehicle Axle Maintenance Rear axles and power take off (PTO) units containing synthetic lubricant and light duty trucks equipped with 75W140 synthetic gear lubricant meeting Ford specification WSL-M2C192-A, part number FITZ-19580-B or equivalent...
Warranty Guide 4th Printing - Page 25
... by an event for repair. (The decision will perform the warranty repair for you for the work. If there is a question about your claim. If your vehicle has failed the test. Additional... Ford Motor Company in writing if your dealer, who will reimburse you free of the Malfunction Indicator Light or it has failed an EPA-approved test or a California Smog Check inspection. To get service...
Owner Guide 1st Printing - Page 4
... Warning Brake System Brake Fluid Non-Petroleum Based Master Lighting Switch
Child Seat Child Seat Tether Anchorage Anti-Lock Brake System Traction Control
Hazard Warning Flasher
Fog Lamps-Front
Fuse Compartment
Fuel Pump Reset Windshield Defrost/Demist Power Windows Front/Rear
Windshield Wash/Wipe Rear Window Defrost/Demist Power Window Lockout
4 Introduction
These are...
Owner Guide 1st Printing - Page 9
...vehicle components, possibly causing a fire. Light is blinking: Engine misfire is required....light on driving conditions. Check fuel cap Momentarily illuminates when the CHECK ignition is properly re-installed, the light...malfunctions present, the Check Engine light should drive in the Maintenance ...light turns on , have your catalytic converter. If the Check Engine light... warning light. When...
Owner Guide 1st Printing - Page 31
... control to work. Also, avoid placing small objects on in a collision or sudden stop. These objects can block airflow and reduce your ability to see through your vehicle, the rear console may ... open. VOLUME +
MODE
SEEK
MEMORY
The instrument panel climate controls must be equipped with rear console audio/climate controls.
- These objects can fall down into the defroster outlets and ...
Owner Guide 1st Printing - Page 95
...) (when the mirror is equipped with an automatic dimming feature.
When the mirror detects bright light from the normal state to ensure a bright clear view in the ON position). POWER WINDOWS Press...windows. • Press the top portion of the rocker switch to close. AUTOMATIC DIMMING REAR VIEW MIRROR The autolamp/automatic dimming mirror is in the mirror when backing up. The autolamp...
Owner Guide 1st Printing - Page 124
... often given for good drivers. 1 in a hurryЉ ЉSeat belts don't workЉ
ЉTraffic is lightЉ ЉBelts wrinkle my clothesЉ ЉThe people I'm with TWO or.... Prime time for the safety belt upper anchorage and seatback which should be seriously injured in light trucks. Safety belts, when used properly, reduce risk of 2 deaths occur in single-vehicle crashes...
Owner Guide 1st Printing - Page 126
Wait until the safety belt warning light turns off , buckle then unbuckle the safety belt. • This will have to make sure they work properly and are no nicks, wears or cuts, replacing if necessary. Turn on seatback (if equipped), child safety seat tether bracket assemblies (if equipped), and ...
Owner Guide 1st Printing - Page 133
... bags did not inflate in side-impact collisions, not roll-over, rear-impact, frontal or near-frontal collisions, unless the collision causes sufficient ...to inflate between the door panel and occupant to allow airbag deployment. • The same warning light, electronic control and diagnostic unit as used for the front air bags. • Two crash ...How does the side air bag system work?
Owner Guide 1st Printing - Page 153
...until you verify that the brakelamps are not operating properly. If it may occur. Press lightly on the accelerator in a steady pattern. Driving
Your vehicle has the capability to haul ... lever out of P (Park) with a brake-shift interlock feature that a fuse has blown or the vehicle's brakelamps are working. Do not rock the vehicle for more cargo and people than a few minutes...
Owner Guide 1st Printing - Page 163
... be improved by moving your vehicle slowly while applying light pressure on tires and rotating driveshafts causes an imbalance that could lose traction and slip sideways. Water intrusion into the transmission may stall. When descending a steep hill, avoid sudden braking. If the rear axle is filled with a synthetic lubricant and does not...
Owner Guide 1st Printing - Page 166
... speed may drop considerably, especially if you are driving uphill, your vehicle slowly while applying light pressure on the other side of the hubs (if possible) and proceed slowly. If the... crest. You could damage drive components. When climbing a steep hill, start in water, the rear axle lubricant should be improved by pressing and holding the SET ACCEL button (to rotating driveshafts, ...
Owner Guide 1st Printing - Page 173
Never connect any trailer lighting to local and Federal regulations. Additional electrical equipment may damage the electrical system resulting ... long, steep grades. • Consult your local motor vehicle speed regulations for assistance in fire. Using a step bumper The rear bumper is equipped with an integral hitch and requires only a ball with a 19 mm (3/4 inch) shank diameter. This will...
Owner Guide 1st Printing - Page 174
... Do not allow the static water level to rise above the bottom edge of the rear bumper and • Do not allow water to the trailer after the trailer is suspected or repair required. ...Disconnect the wiring to break higher than 10-15% of time in hot weather, place the gearshift in water. Recreational towing...
Owner Guide 1st Printing - Page 218
...lighted substances to come near the battery, always shield your face and protect your hands on and allow the engine to protect against possible splashing of acid solution. When working... performance. Avoid contact with water for at least one minute. 5. Because your eyes when working near the battery. Shield your vehicle's engine is swallowed, call a physician immediately. When ...
Owner Guide 1st Printing - Page 232
... every 180 kg [400 lb] of weight carried). • Adding certain accessories to your vehicle (for example bug deflectors, rollbars/light bars, running out of fuel. 232 It is important to work properly: • Use only the specified fuel listed. • Avoid running boards, ski/luggage racks) may reduce fuel economy. •...
Owner Guide 1st Printing - Page 233
... control device or prevent it from working properly. This decal identifies engine displacement...light or the temperature warning light, fluid leaks, strange odors, smoke or loss of harmful and potentially lethal fumes into the passenger compartment. The scheduled maintenance items listed in entry of engine power, could indicate that the emission control system is not working...
Owner Guide 1st Printing - Page 268
...air bag ...130, 133 indicator light ...10, 131, 134 operation ... rear seat controls ...31 Air suspension ...151 description ...151 warning light ......148-149 Anti-theft system warning light ...11 Armrests ...100 Audio system (... treating emergencies ...217 charging system warning light ...11 jumping a disabled battery ...190...system (ABS) warning light ...10, 149 brake warning light ...10 fluid, checking ...
Similar Questions
2001 Mercury Mountaineer V8 Drivers Door Lock Mechanism Key Doesn't Work
The drivers side door will not lock I pulled the panel off and found that the rod that goes from the...
The drivers side door will not lock I pulled the panel off and found that the rod that goes from the...
(Posted by doublerr120 9 years ago)
Mercury Mountaineer 2001 Fuse Panel
Where is the cigar lighter fuse located on a mercury mountaineer 2001?
Where is the cigar lighter fuse located on a mercury mountaineer 2001?
(Posted by mmj11241993 10 years ago)
What Would Cause Brake Lights To Stop Working? Changed Bulbs, Checked Fuses.
(Posted by jcurtismiddleton 11 years ago)
Buttons Don't Work For The Radio Console, Radio Works,
the radio console buttons work, have to use the buttons on the steering wheel to change the station....
the radio console buttons work, have to use the buttons on the steering wheel to change the station....
(Posted by sypgoirish 11 years ago)
High Beam N Rear Wiper
the hight beam does not work n also the rear windshield wiper does not work
the hight beam does not work n also the rear windshield wiper does not work
(Posted by ironbeard61660 11 years ago)