2005 Mazda Tribute Support Question
2005 Mazda Tribute Support Question
Find answers below for this question about 2005 Mazda Tribute.Need a 2005 Mazda Tribute manual? We have 1 online manual for this item!
Question posted by rbewley on October 17th, 2013
No Start
Replaced crank shaft sensor. theres no ground at wiring conector to sensor and only 1.2 volts with key on and cranking engine. coils have 12 volts going in and 12 volts coming out. no spark, compression good, fuel pressure good. please help.
Current Answers
Related Manual Pages
Owner's Manual - Page 58
... reenabled when the vehicle is unlocked using the following procedure: Before starting, ensure the ignition is located on the door panel three times. 3. Place the key in the ignition and turn the ignition to your dealer supplied keys, replacement keys are closed. Press the power door unlock control on the remote entry transmitter. If you...
Owner's Manual - Page 62
..., and the horn will start the arming process. Sounding a panic alarm to confirm that all 2. To replace the battery: 1. DO NOT... doors 1. If any of the remote entry transmitter near the key ring. Press and release to time out in this chapter. ...flash when the pressed. Replacing the battery The remote entry transmitter uses one coin type three-volt lithium battery CR2032 or ...
Owner's Manual - Page 78
...The fact that something is wrong with impact and safing sensors. • Restraint system warning light and back-up tone. • The electrical wiring for both stages of the dual-stage air bag supplemental... overall level of frontal crash protection to front seat occupants and is designed to help better protect a range of occupants in a collision does not mean that the pretensioners or...
Owner's Manual - Page 80
... bag off the passenger front air bag. This maximizes the effectiveness of the safety belts and helps properly position the occupant relative to the air bag to prevent unnecessary replacement of air bag(s) after a collision. The sensor also turns off . Front safety belt load limiter The front outboard safety belt load limiter allows...
Owner's Manual - Page 86
... technician to the procedures in a collision. Failure to replace the Belt and Retractor assembly could reduce the effectiveness of...crash. The safety belt pretensioner uses the same crash sensor system as the front airbags and side-curtain air...height adjustment Your vehicle has safety belt height adjustments at the start of injury in Workshop Manual. The safety belt pretensioner removes...
Owner's Manual - Page 87
.... Unless all safety procedures are followed, injury could be seriously injured. Refer to replace both front restraints under the above conditions could accidentally activate it or make it inoperable... deployed, they will not work again and must be replaced if the vehicle is dangerous. WARNING: Modifying the components or wiring of the pretensioner system, including the use electronic testing...
Owner's Manual - Page 97
...its own internal circuits and the supplemental air bag electrical system wiring (including the impact sensors), the system wiring, the air bag system readiness light, the air bag back ...extremely important that are part of air bag deployment. The sensors are designed to occupants who are not properly restrained or are not replaced, the unrepaired area will turn off the front passenger's frontal...
Owner's Manual - Page 105
... using a properly installed child or booster seat because it is detected by the rollover sensor. Children 12 years old and under should always be properly restrained in the restraints control module (RCM...event. The side-curtain air bags (if equipped) will not interfere with seat belts, can help reduce the risk of severe injuries in the event of a rollover event is designed to inflate...
Owner's Manual - Page 127
...damaged, it as soon as the road tires and wheels that if you should replace it should be replaced rather than one dissimilar spare tire/wheel at a time • Use commercial ...the following: • Handling, stability and braking performance • Comfort and noise • Ground clearance and parking at curbs • Winter weather driving capability • Wet weather driving capability...
Owner's Manual - Page 131
... nut one-half turn counterclockwise but do not remove them until the wheel is raised off the ground.
131
REVIEW COPY 2005 Mazda Tribute (j14), Owners Guide (post-2002-fmt) (own2002), Market...the lug wrench to the underbody storage area, raise winch up into the installed position. 7. If not replacing the spare or flat tire to remove the lug nut from the spare tire tether.
6. Use the attached...
Owner's Manual - Page 133
...injury, do not put any part of 1 inch (25 mm) off the ground. Replace the flat tire with the lug nut wrench. 11.
Do not fully tighten ...handle counterclockwise. 13. Reinstall lug nuts until the wheel has been lowered. 12. Refer to the following guides and turn the jack handle clockwise until the... (fus) Do not start the engine when your body under the jacking notches.
Owner's Manual - Page 134
Tires, Wheels and Loading
14. To replace jack in vehicle, guide the jack bottom first in trim opening and position in failure of cable... the wheel partially under the vehicle and install the retainer through the center of jack and close thumbscrew. Place tire on the ground with aluminum wheels, remove the wheel center cap. 4. Reinstall the jack and tools in wheel and attach lug nut using lug...
Owner's Manual - Page 157
Tires, Wheels and Loading
Replace the rear axle lubricant any time the axle has been submerged in the Roadside emergencies ...neutral permits "flat-towing" (all four (4) wheels off the ground. RECREATIONAL TOWING An example of lubrication damage. Your vehicle, with its front wheels on the ground) for pulling behind a motorhome. Disconnect the wiring to a speed of 113 km/h (70 mph) but you...
Owner's Manual - Page 158
... running. 3. LOCK, locks the gearshift lever and allows key removal. 2. ON, all Canadian Interference-Causing Equipment standard requirements regulating the impulse electrical field strength of the ignition 1. START, cranks the engine. When starting a fuel-injected engine, avoid pressing the accelerator before you have difficulty starting . Always open the garage door before or during...
Owner's Manual - Page 160
... illuminate, have the vehicle serviced.
Make sure the corresponding lights illuminate or illuminate briefly. light may not
Starting the engine Note: Whenever you start your vehicle, release the key as soon as the engine starts. Excessive cranking could damage the starter. 160
REVIEW COPY 2005 Mazda Tribute (j14), Owners Guide (post-2002-fmt) (own2002), Market: USA_English (fus...
Owner's Manual - Page 161
... with ungrounded electrical systems or two-pronged (cheater) adapters. Turn the key to crank with the fuel shut off in accident or death. 161
REVIEW COPY 2005 Mazda Tribute (j14), Owners Guide (post-2002-fmt) (own2002), Market: USA_English (fus) Driving
1. If the engine still fails to start within five seconds on the first try again.
Owner's Manual - Page 184
...not working, a fuse may have blown. Check the appropriate fuses before replacing any electrical components.
15
Note: Always replace a fuse with a higher amperage rating can cause severe wire damage and could start a fire. Standard fuse amperage rating and color COLOR Fuse rating 2A ...
FUSES AND RELAYS Fuses If electrical components in the vehicle are identified by a broken wire within the fuse.
Owner's Manual - Page 191
... VEHICLE WARNING: The gases around the battery can explode if exposed to the ON position without starting the engine. If it cools. Roadside Emergencies
WARNING: Steam from an overheated engine is coming from the engine compartment: do not go near the front of the vehicle. See Adding coolant in the radiator hoses and connections, heater hoses...
Owner's Manual - Page 196
... cable from the positive (+) terminal of the disabled vehicle's battery. Roadside Emergencies
3. After the disabled vehicle has been started and the jumper cables removed, allow it to idle for several minutes so the engine computer can relearn its idle conditions.
196
REVIEW COPY 2005 Mazda Tribute (j14), Owners Guide (post-2002-fmt...
Owner's Manual - Page 264
... Spark plugs, specifications ...256 Special notice ambulance conversions ...7 Specification chart, lubricants ...255 Speed control ...51 Starting your vehicle ...158-160 jump starting ...191 264 Steering wheel tilting ...45 T Tilt steering wheel ...45 Tires ...121-122 alignment ...142 care ...141 changing ...128 checking the pressure ...124 inspecting and inflating ...123 label ...140 replacing...
Similar Questions
I Found Code P0453
Ground wire get 12 volt I checked for short I didn't find where am I check?
Ground wire get 12 volt I checked for short I didn't find where am I check?
(Posted by yohannesdz 8 years ago)
Ignition Coil #3 Have To Be Replaced If Oil Leak On The Coil Container.
Does ignition coil #3 have to be replaced if oil leak on the coil container. My oil light kept comin...
Does ignition coil #3 have to be replaced if oil leak on the coil container. My oil light kept comin...
(Posted by woodst11420 8 years ago)
Main Key Won't Start 05 Mazda Protege
Main key won't start my 05 Mazda Protege.....if I use the spare key it will start then if I shut it ...
Main key won't start my 05 Mazda Protege.....if I use the spare key it will start then if I shut it ...
(Posted by xnutmgx 9 years ago)
03 Tribute Won't Stop Dinging!!
Only had it for a couple months about 4 days ago it started making a dinging noise. 5 sets of 5 ding...
Only had it for a couple months about 4 days ago it started making a dinging noise. 5 sets of 5 ding...
(Posted by tracybanks92 10 years ago)
Car Won't Start Heard A Metallic Type Of Noise Car Died When Driving
Car has fuel pressure , good compression, timing chain is turning can see thru oil cap but no spark...
Car has fuel pressure , good compression, timing chain is turning can see thru oil cap but no spark...
(Posted by rbewley 10 years ago)