Get support for 2002 Mazda Millenia

2002 Mazda Millenia Support Question

2002 Mazda Millenia Support Question

Find answers below for this question about 2002 Mazda Millenia.
Need a 2002 Mazda Millenia manual? We have 1 online manual for this item!
Question posted by michelangelo347 on August 10th, 2013

New Belt Making Screeching Noise On Start-up, Goes Away In 20 Seconds.

low fluid cxaused by leak or defective pump?

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Manual Pages

Owner's Manual - Page 2

..., CAUTIONs, and NOTEs in this manual means "Do not do that this happen". Index: A good place to start is the Index, an alphabetical listing of the manual to best explain how to your vehicle. CAUTION A CAUTION indicates... owner's manual, when read from your vehicle. Please refer to make better use of the vehicle, indicates that in which bodily injury or damage to enjoy your manual.
Owner's Manual - Page 10

... and upright. When the seatback is stopped. The adjuster uses a great amount of the seat to make more than one adjustment at a time. Release the switch at the desired angle, release the switch....power. • Don't use can damage the motor. • To prevent the battery from seat belts. Change the seatback angle by turning the reclining switch. J76Y.book Page 2 Wednesday, March 27, ...
Owner's Manual - Page 15

... are designed to decrease the possibility of severe injury during a collision. All of the way when not in use . Always wear your seat belt and make sure all passengers always wear seat belts. However, the front passenger's seat and rear outboard lap/shoulder belt retractors operate in a collision. They could be much safer. Seat...
Owner's Manual - Page 18

Take up slack Tongue Keep low on hip bone Too high Buckle WARNING Positioning the Lap Portion of the Seat Belt: The lap portion of the seat belt is dangerous. Always make sure the shoulder portion of the seat belt worn too high is positioned across your shoulder and near your neck, but never under your...
Owner's Manual - Page 19

... buckle. J76Y.book Page 11 Wednesday, March 27, 2002 5:04 PM Essential Safety Equipment Seat Belt Systems M Unfastening the Seat Belts Depress the button on your upper arm. Always make sure the shoulder portion of the seat belt is locked. Simply push the button, move it to the desired position, and then release it...
Owner's Manual - Page 20

... serious injury. Buckle 3. Wear the lap belt snugly and as low as possible. 2-12 Form No. 8Q47-...EA-01F Pull the tongue to the webbing and pull. Insert it into the buckle until you hear a click. • To shorten, pull the loose end of the webbing. Make sure the lap belt is dangerous. Lengthen WARNING Wearing the Lap Belt: A lap belt...
Owner's Manual - Page 21

... may not hold in use, insert the buckle face up between the seatback and seat bottom and make sure the belt is not long enough, even when fully extended, a seat belt extender may be only for you at no charge from your Authorized Mazda Dealer for the particular vehicle and seat. This extender...
Owner's Manual - Page 24

...or she cannot hold onto a child in a sudden stop or a collision it with a seat belt. Follow the Manufacturer's Instructions and Always Keep the Child-Restraint System Buckled Down: An unsecured child...air bag. A rear-facing child-restraint system should sit in the rear and use them. Make sure the child-restraint system is dangerous. Always secure a child in your vehicle. Holding a...
Owner's Manual - Page 26

... system manufacturer's instructions carefully. The front passenger's seat is clearly the worst choice for belt routing instructions. 2. Depending on Rear Seat: Installation of a tether equipped child-restraint system...will result in an increased chance of serious injury if the child-restraint system goes forward without benefit of childrestraint system, it is safer in the three positions ...
Owner's Manual - Page 34

...the front seats. You could result. NOTE • When an air bag deploys, a loud inflation noise can provide the special care needed in incorrect or unexpected air bag deployment and the possibility of front ... that the seats retain an undamaged air bag connection. Don't make any modifications to tell the new owner of the air bags may cause light skin injuries on the front seats is...
Owner's Manual - Page 69

... any sign of a leak. • If you plan to the ON position. • Release the parking brake and make sure nothing will be in...belt fastened? • Do all the lights work? • Check all gauges. • Check all warning lights when the ignition switch is turned to back up, make sure the brake warning light goes off. Engine oil, engine coolant, brake fluid, washer fluid, and other fluid...
Owner's Manual - Page 77

... use of radio noise. 1. Make sure the parking brake is moving, shift into neutral (N). If you may damage the starter and drain the battery. 6. Turn the ignition switch to the START position and hold (up without operating the accelerator. • Whether cold or warm, the engine should fasten their seat belts. 2. If the engine...
Owner's Manual - Page 81

...screeching noise consult an Authorized Mazda Dealer. 5-7 Form No. 8Q47-EA-01F This causes a screeching noise to a weak battery, not a malfunction. Recharge the battery. WARNING Driving with Worn Disc Pads: Driving with both lights are on for a few seconds... Driving Your Mazda Starting and Driving M ABS Warning Light NOTE When the engine is jump-started to charge the battery...
Owner's Manual - Page 135

... starts playing. Reversing Press the program button ( ) to rewind. When the cassette tape ends, the unit automatically reverses play This operation makes ... APC detects 15 seconds of the one being played. NOTE RPT may not operate properly if • A tape was recorded at a low level. •...Noise reduction system manufactured under license from Dolby Laboratories Licensing Corporation.
Owner's Manual - Page 164

...a loud knocking or pinging noise, the engine is still leaking, stop the engine and let... 's low, look for leaks in the radiator hoses and connections, heater hoses and connections, radiator, and water pump. If neither coolant nor steam is no leaks are ... you . Then turn the ignition switch to the ON position without starting the engine. If this doesn't lower the temperature, stop the engine...
Owner's Manual - Page 166

...a low fluid level. (2.5 liter V6 DOHC) You may hear noise (from open battery cells are dangerous. Don't jump-start , it there-for a few days. If it there. 2. Low Fluid Level or Frozen Battery: Jump-starting is...away from the valve tappets) if the engine has not been in use for up . 3. Hydrogen gas, produced during normal battery operation, could ignite and cause the battery to 10 seconds...
Owner's Manual - Page 167

... disconnect in Step 3. WARNING Connecting to Negative Terminal: Connecting the end of the second cable to a Moving Part: Connecting a jumper cable near any part that its ...belts) is grounded. 2. Connect the jumper cables in the exact sequence as in another vehicle, don't allow the vehicles to a point away from the discharged battery (4). A spark could get caught when the engine starts...
Owner's Manual - Page 188

.... If you find a low fluid level, have the brakes inspected. Mixing different fluids will damage painted surfaces. Be careful not to the power steering pump, don't operate the vehicle for long periods when the power steering fluid level is low. Your brakes could signal brake lining wear or a brake system leak. If brake fluid does get medical attention...
Owner's Manual - Page 189

... lines and hoses for leaks and damage. J76Y.book Page 17 Wednesday, March 27, 2002 5:04 PM Maintenance and Care Owner Maintenance Miller Cycle Engine V6 DOHC Automatic Transaxle Fluid (ATF) M Inspecting Automatic Transaxle Fluid Level The automatic transaxle fluid level should be kept between MIN and MAX. CAUTION • Low fluid level causes transaxle slippage...
Owner's Manual - Page 190

... both sides of the dipstick for 30 minutes. Full A Low Full B Low When the vehicle has been driven and the fluid is lower than about 20°C (70°F), start the engine and inspect the fluid level after stopping the engine and allowing the fluid to make sure it doesn't pass full. The vehicle could move suddenly and...

Similar Questions

01 Mazda Millenia 2.3l Driving 1/2 Mile Rpm Guage Starts Dropping
I have a 2001 Mazda Millenia which was dying on my wife while she was driving. She would drive about...
(Posted by budmanblue1963 8 years ago)
1999 Millenia...tcs Light Started Jerking
driving on interstate about 75..can started like jerking as if the brakes were on. the TCS light cam...
(Posted by spiveykatie 10 years ago)
How Do You Change Timing Belt?
(Posted by Anonymous-109297 11 years ago)
Serpentine Belt
How do you replace the outer belt on a 2002 mazda millenia
(Posted by warrenjacks 12 years ago)
Ask a New Question
Use the box below to post a new question about this Mazda automobile .
Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

Mazda Manuals

Find free 2002 Mazda Millenia manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Mazda Reviews

View thousands of Mazda user reviews and customer ratings available at ReviewOwl.com.

Contact Information

Complete Mazda customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Mazda customer service rankings, employee comments and much more from our sister site.

Mazda Recalls

Find comprehensive Mazda recall information updated hourly on RecallOwl.com.