Maytag MVWX655DW Support Question
Maytag MVWX655DW Support Question
Find answers below for this question about Maytag MVWX655DW.Need a Maytag MVWX655DW manual? We have 4 online manuals for this item!
Question posted by jm1714 on July 22nd, 2015
Washer Not Starting Wash Cycle
Maytag Bravos MCT model mvwx655dw0 - washer never went in to spin cycle after rinse, door unlocked and it just sat there. Took clothes out and tried to restart with just a couple of towels in washer -Press start, door locks, starts sensing spins one time, and door unlocks. i tried this again with the washer completely empty with the same result. I unplugged washer for 2-3 minutes and the washer still does the same thing with or without clothes.
Current Answers
Answer #1: Posted by Odin on July 22nd, 2015 3:49 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MVWX655DW Manual Pages
Installation Guide - Page 2
...couplings (2 pack) 6 ft. (1.8 m) Inlet hose, Black EPDM, space saving 90° elbow, hypro-blue steel couplings (2 pack)
Alternate parts: (Not supplied with washer...washers
To order, please refer to improve performance and minimize noise and possible "washer walk". INSTALLATION REQUIREMENTS
Tools and Parts Gather required tools and parts before starting...basement, laundry room, closet, or recessed...
Installation Guide - Page 3
...temperatures below the top of wash tub. Recessed area or ...washer, and water pressure of washer to weather or in door are minimum required. Top of installation and servicing, and spacing for companion appliances and clearances for floor standpipe drain system. Add spacing of 1" (25 mm) on the sides. IMPORTANT: To avoid siphoning, no higher than 96" (2.44 m) from bottom of laundry...
Installation Guide - Page 4
...., AC only, 15- n This washer is equipped with a qualified electrician if you start: remove shipping materials It is necessary to install it is recommended that a qualified electrician determine that a separate circuit breaker serving only this time.
4
Remove shipping base
To avoid damaging floor, place cardboard supports from washer.
1.
it must be plugged into...
Installation Guide - Page 5
... separate directions. For a floor drain, remove the preinstalled drain hose form as shown. Drain hose form must be inside standpipe; For a laundry tub or standpipe drain, go to move washer later.
4. Attach drain hose to free from tray.
3. Remove packing tray from tub. Free power cord
If clamp is not already in...
Installation Guide - Page 6
.... Screw coupling by hand until it is seated on valve when attaching to washer correctly.
10...washer. A small amount of water may need to inlet valves. 7.
CONNECT INLET HOSES
Washer must be connected to tighten couplings an additional two-thirds turn . Screw on coupling... parts with flat washers (not provided). Connect inlet hoses to tighten couplings an additional two-...
Installation Guide - Page 8
...your washer, measure 1/2 of normal
recommended amount of /recycle all parts are on some models). q Check for leaks around faucets and inlet hoses. Select any tape
remaining on washer. ...materials. Close lid. Start washer and allow to see what was skipped. q Check that washer is an extra part, go back through steps to complete full cycle.
8
q Read "Washer Care" in your Use...
Use & Care Guide - Page 3
... Sensing
Once you may hear nothing at the beginning of the wash cycle, you may also result in longer cycle times and reduced rinsing performance. Using regular detergent will not see a washer basket full of water as basket is normal for clothes to adding water, this washer delivers the detergent directly to the load size-no water...
Use & Care Guide - Page 4
... cycle. EXTRA RINSE This option can be set to "On" if using fabric softener.
5 START/PAUSE/UNLOCK BUTTON Press to most cycles. Once the lid has locked the second time, the washer will then move the load briefly, pause to allow water to pause the cycle and unlock the lid. Select a wash temperature based on during sensing. The wash time is restarted...
Use & Care Guide - Page 5
... cannot be added if the Fabric Softener-On option was spinning at increasing speeds for proper water removal, based on . The lid will hear sounds similar to the wash cycle as the washer rinses and moves the load.
Press START/Pause/Unlock again to open the lid, press START/Pause/Unlock. This light indicates that the lid is complete, this light...
Use & Care Guide - Page 6
... shirts, blouses, casual business clothes, permanent press, and blends.
Place small items in mesh garment bags before the wash portion of the cycle begins, and uses a higher water level than other fabric types. This cycle uses a higher, preset water level. High Combines a rinse and high speed spin for loads requiring an additional rinse cycle or to shorten drying times...
Use & Care Guide - Page 7
... clothes to washer basket prior to reduce tangling. Always follow fabric care label instructions to avoid damage to adding laundry. Load laundry ...cycle.
• Use mesh garment bags to help avoid tangling when washing delicate or small items.
• Turn knits inside out to reduce wrinkling and tangling.
7
Try mixing different sized items to adding laundry products. A dd laundry...
Use & Care Guide - Page 8
... softener into the washer too early.
Add liquid chlorine bleach
to dispenser
Pour a measured amount of detergent to produce the right amount of suds for information recommended method of fabric softener based on your wash cycle. Close dispenser drawer, then select Fabric Softener - If Extra Rinse option is added during rinse. Select cycle
Liquid Chlorine Bleach...
Use & Care Guide - Page 9
... level by turning the Wash Temp knob to the desired setting. Cool Warm water is the temperature from your previous washer provided. When the cycle has finished, the DONE indicator will unlock once the washer movement has stopped.
This may be cooler than what your faucet. Then close lid and press START/ Pause/Unlock again to avoid odor...
Use & Care Guide - Page 10
... interrupted, press POWER/CANCEL. (For models with no Power/Cancel button, press and hold START/Pause/ Unlock for better ventilation and drying of the washer interior. If cycle
must be performed, at a minimum, once per month or every 30 wash cycles, whichever occurs sooner, to control the rate at which in turn may result in normal wash
cycles to provide rinsing at...
Use & Care Guide - Page 11
... DISPENSER TRAY
You may stay in hoses, freezing can damage washer. Wash in warm, soapy water, using again, run
washer on both water faucets; Before using a mild detergent.
4.
Plug in upright position.
2. Turn on RINSE & SPIN cycle for a medium-size load.
11 Because some water may find laundry product residue leftover in new location. disconnect and drain...
Use & Care Guide - Page 12
.... TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com/product_help In Canada www.maytag.ca for assistance...clothing such as metal snaps, buckles, or zippers touch against the stainless steel basket.
Load dry items in washer drain system. Fill hoses not attached tightly.
Check all four fill hose flat washers are removed during the spin/drain cycles...
Use & Care Guide - Page 13
... must be stopped to reduce suds. Washer will pause during certain phases of cycle. Washer may be closed for assistance and to possibly avoid a service call. Washer may be attached and have not become clogged. Close lid and press START/Pause/Unlock. Do not add more detergent.
13 Do not add more water to outlet.
Select RINSE & SPIN. Press START/Pause/Unlock.
Use & Care Guide - Page 14
.../product_help In Canada www.maytag.ca for small items.
Using a cycle with high spin speeds.
The washer may be attached and have been caught in the load, select DRAIN & SPIN. Washer not loaded as expected (cont.)
Washer not draining/ spinning, loads are still wet, or spin light remains on load after washer has started.
14
TROUBLESHOOTING
First try the solutions suggested here...
Use & Care Guide - Page 15
... load with a slower wash action and spin speed, however items will add additional water for proper fabric softener dispensing when "On" is less efficient at www.maytag.com/product_help In Canada www.maytag.ca for clothes to possibly avoid a service call.
This is tangling
Washer not loaded as recommended. Added water lifts the laundry off the washplate...
Use & Care Guide - Page 16
.... Be sure laundry packet is added to washer basket before washing to avoid snags and tears. TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com/product_help In Canada www.maytag.ca for the fabrics being washed. Items may have been damaged before washing.
The washer will not start or fill with the best cycle. The...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
How do I clean my Epic® or Neptune® front-load washer?
... my HE washer? This will cause product damage over time. Select the Normal/Casual wash cycle. Select the hottest wash water temperature available (not all areas under running water. The door will lock and filling will be added at a later step. Close the dispenser drawer. Replace the detergent compartment divider. Unlock the dispenser drawer by pressing the... -
The cycle time is not correct - Top-load HE washer with Dispensers in Corners
... the suds to break. This pause and rinsing is necessary and may occur several times to eliminate the suds. If the code remains and wash cycle dial is detected, then the washer will prevent this occur with Dispensers in Corners Not draining, not spinning out water, wet loads - Consider adding more items to... -
Detergent is on the load - Top-load HE washer with Dispensers in Corners
... for best results. Always use only HE High Efficiency detergent. Reduce load size if needed its easy to extend the shelf life. Older laundry detergents do not dissolve detergents well, especially powdered detergents. Are you use in the washer may not dissolve well in my Bravos HE washer. Is the wash water temperature...
Similar Questions
My Maytag Mvwb450wq Washer Won't Go From Fill To Wash Cycle.
It puts a small amount of water in. Then it sounds like it is spinning and never goes in to the wash...
It puts a small amount of water in. Then it sounds like it is spinning and never goes in to the wash...
(Posted by Parti1961 4 years ago)
What Is The Code To Reset This Machine?
This machine lost power after a blackout. It has a new motherboard. Last time this happened the tech...
This machine lost power after a blackout. It has a new motherboard. Last time this happened the tech...
(Posted by erikandrewlukacs 7 years ago)
Maytag Centennial Grinding Noise When Sensing But Wont Start Wash Cycle Washer
(Posted by soundlmgale 10 years ago)
Maytag Centennial Washer Wont Start Wash Cycle
(Posted by taniakhaus 10 years ago)
Wash Cycle Times
We just purchased subject washer and are suprised by the seeming long cycle times. For my reference,...
We just purchased subject washer and are suprised by the seeming long cycle times. For my reference,...
(Posted by rammns 11 years ago)