Maytag MVWX600XW Support Question
Maytag MVWX600XW Support Question
Find answers below for this question about Maytag MVWX600XW.Need a Maytag MVWX600XW manual? We have 3 online manuals for this item!
Question posted by macamaro2005 on March 8th, 2016
I Have A Maytag Bravos Model Mvwx600xw With The Problem: The Motor Does Not
spin, but I tested and it is in good condition, shift actuator works, water pump works, but motor does not. Please help. THANK YOU
Current Answers
Answer #1: Posted by Odin on March 9th, 2016 6:38 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MVWX600XW Manual Pages
Owners Manual - Page 3
... goes through a self-test. The package will hear the motor turn the basket in short pulses to the load size-no water level selector is the low-water washplate wash system.
WHAT'S NEW UNDER THE LID? Cleaning with Less Water
Washplate
Traditional agitator-style washer
Washer with your previous washer. The washer automatically adjusts the water level to thoroughly wet...
Owners Manual - Page 4
...water safe for even distribution. The lid will help reduce tangling and wrinkling.
4
SPIN SPEED This washer automatically selects the spin...washer to select available cycles on your laundry load. Overloading, unbalanced loads, or excessive suds may also add or remove options for your washer...fabrics, press Soil Level to work with all models. Not all spin speeds are preset to select less...
Owners Manual - Page 5
... hum of these spins. Once the lid has locked the second time, the washer will unlock briefly before water is working properly. You will hear the motor turn , and the...water removal, based on . This process may also come on the selected cycle and spin speed.
RINSE
You will first perform a self-test on , the washer is added to 3 minutes before locking again. SPIN
The washer spins...
Owners Manual - Page 6
..., select Drain & Spin, add additional detergent and select a cycle based on all models.
This cycle uses a higher, preset water level. Items to wet down the load before washing. The washer will drain, but ...to shorten drying times for that best fits the load being washed. Higher water levels and Affresh® work together to wash large items such as dust mites and pet dander from ...
Owners Manual - Page 7
...tangling.
7 Loose change, buttons, or any small object can set stains into washer
• Empty pockets. Synthetics, knits, and corduroy fabrics will pick up lint ... and to your laundry
2. load them in loose heaps evenly around basket wall. USING YOUR WASHER
1.
Helpful Tips: • When washing water-proof or water-resistant items, load
evenly. Load laundry into fabric. •...
Owners Manual - Page 8
...at correct time in longer cycle times and reduced rinsing performance.
HELPFUL TIP: See "Washer Maintenance" for a small amount of water to turn on the washer.
8 Do not use more than 1 cup (250 mL...detergent to the bottom of the washer basket before adding clothes. Using Oxi or color-safe bleach: If using an Oxi or color-safe bleach laundry boost product, add to dispenser
...
Owners Manual - Page 10
... SPIN cycle for about 30 seconds to liquid chlorine bleach dispenser. Lift up any remaining water into slot. NOTE: For best results, do not have been rinsed from original shipping materials back
inside washer basket. 6.
Turn off water supply to washer, to avoid flooding due to CLEAN WASHER with AFFRESH™ cycle. Because some water may find laundry...
Owners Manual - Page 11
... adding more water to basket could fall between basket and tub or may be necessary to the washer.
11 Wash smaller loads to www.maytag.com/help for assistance and to possibly avoid a service call for service to remove items.
It is normal to hear the pump making a continuous humming sound with periodic gurgling or...
Owners Manual - Page 12
... at www.maytag.com/help for an HE low-water washer. Make sure all household plumbing for any blown fuses. This is power to washer.
NOTE: If problems continue, contact an electrician.
12 See "What's New under the Lid."
Check that the washer was unable to possibly avoid a service call. Washer won 't run or fill, washer stops working or wash...
Owners Manual - Page 13
... is normal. Remove any clogs from regular detergents can slow or stop draining and spinning? TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com/help for assistance and to the washer.
Do not add more water to possibly avoid a service call.
Do not add more than 4.5" (114 mm). Select...
Owners Manual - Page 14
...water. Added water lifts the laundry off the washplate, resulting in the inlet hose. Load garments in loose heaps evenly around the basket wall. Be sure to washer.
Use Whites and Power Wash cycle for proper water... www.maytag.com/help for assistance and to measure correctly.
Washer not loaded as recommended. Add only 1 or 2 garments after washing
Load is tightly packed. Washer is ...
Owners Manual - Page 15
... if possible, depending on top of water still in the bleach dispenser.
If you experience
Possible Causes
Washer not performing as expected (cont.)
Small amount of bleach dispenser when loading and unloading washer. TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com/help for the fabrics being washed. Use...
Owners Manual - Page 16
...Maytag") will need it is installed in accordance with original model/serial numbers that have other rights that vary from unauthorized modifications made to repair or replace appliance light bulbs, air filters or water...the problem
after checking "Troubleshooting," additional help you...Maytag designated service company. In Canada, call 18006889900.
MAYTAG® LAUNDRY...
Installation Instructions - Page 2
...pump and connectors (available from local plumbing suppliers)
1" (25 mm) standpipe
2" (51 mm) diameter to improve performance and minimize noise and possible "washer walk". Tools needed:
Parts needed: (Not supplied with washer... REQUIREMENTS
Select proper location for installation are in cardboard insert in a basement, laundry room, closet, or recessed area.
271/2"
27"
(648 mm) (686...
Installation Instructions - Page 3
..." (2.44 m) from bottom of washer.
Water remaining in washer after use may cause damage in low temperatures. Minimum carry-away capacity: 17 gal. (64 L) per minute. If you need a sump pump system.
This washer has been tested for a standpipe drain: 2" (51 mm). Consider allowing more than 96" (2.44 m) from bottom of laundry tub must be at least...
Installation Instructions - Page 5
... excess hose into standpipe (shown in picture) or over side of laundry tub. For a laundry tub or standpipe drain, go to back of washer.
4.5" (113 mm)
Place hose into standpipe or lay on elbow...from tub
Connect Drain Hose
5. Gently place power cord over end as shown in place on bottom of laundry tub. See "Tools and Parts".
6. IMPORTANT: 4.5" (113 mm) of drain hose onto black drain...
Installation Instructions - Page 6
.... IMPORTANT: Do not overtighten or use a Y-adapter (not provided).
8. Damage can result.
Clear water lines
For floor drain installations, you must use tape or sealants on washer. Connect Inlet Hoses
Washer must be connected to water faucets
Run water for future reference. HELPFUL TIP: Make note of which hose is snug. Repeat with second hose for...
Installation Instructions - Page 7
...
Not Level
7 Check levelness of washer. HELPFUL TIP: You may want to raise the washer.
12. Tighten leveling feet
Jam nut
With washer in its final location, place a level on feet until they are about 4" (102 mm) with floor. Level Washer
IMPORTANT: Level washer properly to step 14. Secure drain hose
Laundry Tub
Standpipe
Wall
14. When...
Installation Instructions - Page 8
... steps to complete full cycle.
8 q Check that water faucets are now installed.
q To test and clean your Washer User Instructions. Be sure you have correct electrical supply and recommended grounding method. 16. Plug into washer basket or detergent dispenser (on . q Check that all parts are on some models).
q Remove protective film from back of your...
Energy Guide - Page 1
...with a natural gas water heater)
Your cost will depend on your utility rates and use.
• Cost range based only on standard capacity models. • Estimated ... per kWh and natural gas cost of this label before consumer purchase. U.S.
Clothes Washer Capacity: Standard
Maytag Models: MVWX500X*, MVWX550X*,
MVWX600X*, MVWX700X* Cat. Government
Federal law prohibits removal of
...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
The water temperature is not correct - Bravos washer with Dispensers in Corners
... connections. Washing many loads in water temperature during installation. Top-load washer with Dispensers in my Bravos washer. If this occurs, turn off the water lines at the nearest sink until you than your previous washer. This is normal. The wash water temperatures may notice lower hot or warm water temperatures. Are the hot and... -
Loads are wrinkled - Bravos washer with Dispensers in Corners
... rpm to avoid the same problem. Top-load HE washer with agitator Did the wrinkling occur while washing a large load? Make sure the hot-water inlet hose is tightly packed in the washer for proper connection to promptly remove loads from my washer - Were the clothes left in the washer is on. Bravos washer with Dispensers in Corners... -
Washer will not fill or start - Bravos washer with agitator
... the water and check for leaks. Select Spin Only to continue. Top-load HE washer with a cycle selection. The IntelliFill Water Level control senses the size of the load and adds the correct amount of delay are turned on a fuse box, check to the washer and turned on some models only) Your washer will...
Similar Questions
Have Maytag Bravos Model Mvwx700xw1. Does Everything But Wash.
In Wash the wash plate just moves back and forth 1" from the normal about 5" range. Already replaced...
In Wash the wash plate just moves back and forth 1" from the normal about 5" range. Already replaced...
(Posted by vhrnung 6 years ago)
Maytag Ciothes Washer Bravo Model Model Mvwb450 Wq Leak Water The End Of Cycle
why
why
(Posted by viklynne 10 years ago)
My Maytag Washer Is Not Spinning My Cloths Dry
I have a maytag MVWX600XW washer and it does not spin the cloths dry in regular or heavy wash moods....
I have a maytag MVWX600XW washer and it does not spin the cloths dry in regular or heavy wash moods....
(Posted by wpc5159 11 years ago)
Lid Switch On A Mvwc200xw0 Where Is It Located What Color Are The Wires I Want
washer will not work the lid switch is messed up is there any way i can disable this and if i can ...
washer will not work the lid switch is messed up is there any way i can disable this and if i can ...
(Posted by mln927 11 years ago)
La590 Top Load Washer Does Not Spin
LA590 top load washer does not spin - I only hear hum. Pump does not seem to be clogged. LID switch ...
LA590 top load washer does not spin - I only hear hum. Pump does not seem to be clogged. LID switch ...
(Posted by doshichetan 11 years ago)