Maytag MVWX500XL Support Question
Maytag MVWX500XL Support Question
Find answers below for this question about Maytag MVWX500XL.Need a Maytag MVWX500XL manual? We have 3 online manuals for this item!
Question posted by WGEMT05 on November 28th, 2011
Will The Washer Work If There Is Not Hot Water
WILL THE WASHER WORK IF THERE IS NOT HOT WATER?
Current Answers
Related Maytag MVWX500XL Manual Pages
Installation Instructions - Page 2
... (51 mm) diameter to 19⁄16" (39.5 mm)
Optional tools:
Flashlight
Bucket
Parts supplied:
NOTE: All parts supplied for your washer in the top of your Use and Care Guide. n 8212656RP n 8212641RP n 8212646RP n 8212545RP
n 8212487RP n 8212638RP
n 8212637RP
10 ft. ... are in cardboard insert in a basement, laundry room, closet, or recessed area.
271/2"
27"
(648 mm) (686 mm)
42" (1067...
Installation Instructions - Page 3
...washer. Consider allowing more than 96" (2.44 m), you need. n Hot and cold water faucets located within 4 ft (1.2 m) of
power cord on all sides of 1" (25 mm) under entire washer.
Water remaining in washer...Proper installation is not recommended. Secure drain hose with water and load) of washer. Top of laundry tub must support washer's total weight (with beaded tie strap.
3 You...
Installation Instructions - Page 4
... breaker serving only this time.
4
it at this appliance be provided. Remove shipping base.
Remove shipping base
To avoid damaging floor, place cardboard supports from washer.
1. IMPORTANT: Removing shipping base is properly grounded. n Do not ground to avoid excessive noise from shipping carton on cardboard supports. NOTE: To avoid floor damage...
Installation Instructions - Page 5
... cord plug and pull to drain port
Remove tape from washer lid, open lid and remove cardboard packing tray from tray. For a laundry tub or standpipe drain, go to remove all parts from... tub. Place drain hose in place on bottom of laundry tub.
Gently place power cord over console to allow free access to move washer later.
4.
For a floor drain, remove the preinstalled drain...
Installation Instructions - Page 6
... a laundry tub, drainpipe, or bucket to check for leaks
Turn on water faucets to prevent clogs. Screw on coupling by hand until it is seated on valve when attaching to hot water inlet valve marked with separate directions. Damage can result. Screw coupling by hand until clear.
10.
Check for leaks. 7. Connect Inlet Hoses
Washer...
Installation Instructions - Page 7
... a level on feet until they are about 4" (102 mm) with wooden block. 12. Level Washer
IMPORTANT: Level washer properly to make sure all four feet make solid contact with beaded tie strap. When washer is level, skip to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with floor. Check levelness of...
Installation Instructions - Page 8
...washer, measure 1/2 of normal
recommended amount of your Washer User Instructions. Close lid. Select any tape
remaining on washer. q Check for leaks around faucets and inlet hoses. Start washer.... q Check that you have all of powdered or liquid detergent and pour it into washer basket or detergent dispenser (on .
q Check that all packaging materials. q Remove protective...
Energy Guide - Page 1
... cost of this label before consumer purchase. V0Wm7DFA(3B)
Estimated Yearly Operating Cost
(when used with an electric water heater)
$14
▼
$10
$71
Cost Range of Similar Models
128 kWh
Estimated Yearly Electricity Use
$9...; For more information, visit www.ftc.gov/appliances (P/N W10062924) Clothes Washer Capacity: Standard
Maytag Models: MVWX500X*, MVWX550X*,
MVWX600X*, MVWX700X* Cat.
Owners Manual - Page 3
...and hum at all, as with dirty laundry, fill it evenly around the basket wall. This low-water wash method uses less water and energy compared to thoroughly wet the load...step description in component failures and noticeable mold or mildew. Cleaning with Less Water
Washplate
Traditional agitator-style washer
Washer with a regular non-HE detergent.
Use only High Efficiency (HE) detergent...
Owners Manual - Page 4
...hot water may hear the hum of fabric and soils being washed. For heavily soiled and sturdy fabrics, press SOIL LEVEL to select more damp.
4
4 CYCLE OPTIONS When you may be cooler than what your washer... the second time, the washer will leave your laundry load. See "Cycle Guide... water wash, some are different from traditional washers.
This light indicates that are preset to work ...
Owners Manual - Page 5
... high. default is restarted. Higher water levels and Affresh® work together to the wash cycle as the washer rinses and moves the load. The sensing light may change at increasing speeds for best results. Unlike traditional washers, the load is not covered with Affresh™
Wash/Rinse Temperature:
Hot/Cold Warm/Cold Cool/Cold...
Owners Manual - Page 6
... follow fabric care labels instructions to avoid damage to items during washing. Helpful Tips: • When washing water-proof or water-resistant items, load
evenly. load them in loose heaps evenly around the washplate; Load laundry into fabric.
• Treat stains promptly.
• Close zippers, fasten hooks, tie strings and sashes, and remove...
Owners Manual - Page 7
... in component failures and noticeable mold or mildew.
Using Laundry Product Dispensers
3. It is selected, fabric softener will be dispensed into tray, always follow manufacturer's directions for a small amount of water to dispenser
Detergent tray
5. Do not overfill tray - Starting Your Washer
6. Low-water washing creates excessive sudsing with liquid chlorine bleach.
Owners Manual - Page 8
...Always read and follow this will unlock once the washer movement has stopped.
Colors that bleed or fade
Light soils
Cold Warm water may find laundry product residue leftover in soil removal and to begin... you select a cycle, the default settings for more than 10 minutes the water will pump out. Wash Temp
Hot Some cold water is delayed for 2 to 3 minutes to add, if not previously set....
Owners Manual - Page 9
... half the manufacturer's recommended amount for a moment and pause, lid will lock, then cycle will be interrupted, press POWER/CANCEL and run washer on both water faucets, disconnect and drain water inlet hoses.
2.
NON-USE AND VACATION CARE
Operate your clothes. Plug in new location. Disconnect drain hose from original shipping materials back...
Owners Manual - Page 10
... spin/drain cycles.
Check floor for leaks (laundry tubs, drain pipe, water pipes, and faucets.)
Washer not loaded properly.
Both Hot and Cold water faucets must be level. Load could unbalance washer. Adding wet items to washer or adding more water to fill appropriately)
Check for proper installation or see "Using Your Washer" section.
Make sure all household plumbing...
Owners Manual - Page 11
... 3 prong outlet. Lid must be closed for washer to run or fill, washer stops working or wash light remains on (indicating that the washer was unable to pump out water within ten minutes
Empty pockets and use garment bags for small items. Use a cycle with short spins that the washer was unable to fill appropriately) (cont...
Owners Manual - Page 12
....
Lower drain hose if the end is normal. See "Using Your Washer" section. Added water lifts the laundry off the washplate, resulting in loose heaps evenly around the basket wall. Inlet valve screens on washer may require additional rinsing.
This includes cooler hot and warm washes. Use cycle designed for the fabrics being washed.
Remove...
Owners Manual - Page 13
...use liquid HE detergent. Not using correct cycle for fabric type.
Residual powder in Washer Maintenance. Items may result in residual powder in the dispenser.
Wash like colors ...Cleaning your load with low water pressure may have been added incorrectly.
This may not have tangled. Be sure to measure correctly.
Clogged dispensers or laundry products dispensing too soon. ...
Owners Manual - Page 14
... BE PRODUCT REPAIR AS PROVIDED HEREIN.
MAYTAG® LAUNDRY LIMITED WARRANTY
This Maytag Limited Warranty supersedes and replaces ...1. Expenses for travel and transportation for the replacement of the washer and that prevent function of the drum motor (stator and... repair or replace appliance light bulbs, air filters or water filters. Consumable parts are unable to parts or systems resulting...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Washer is not cleaning laundry - Top-load HE washer with Dispensers in Corners
... before starting the washer. Make sure the hot-water fill hose is connected to the hot faucet and the cold-water fill hose is HE...washer work Did you using the Oxi Treat Stains or Stain Cycle option? Damaged clothing - Does the water level seem too low? See also: Why HE High Efficiency detergent is not cleaning laundry. Use more water than conventional top-load washers... -
The water temperature is not correct - Top-load HE washer with Dispenser Drawers - video
... amount of time may notice lower hot or warm water temperatures. You may use up operation. video The chlorine bleach dispenser is not correct. Turn the water back on and make a difference in each of laundry. The water temperature in Corners Washer will not fill or start -up the available hot water faster than I expect - The Bravos... -
Washer is not cleaning laundry - Top-load HE washer with Dispenser Drawer - video
... the hot and cold water inlet hoses reversed? The amount of water has been added to soils and carrying them a dingy appearance. See also: Why HE High Efficiency detergent is automatically added during the rinse portion of iron in my washer? Detergent works by attaching to the load. To avoid dye transfer, unload the washer as...
Similar Questions
Hot Water Leaks Into The Washer
hot water leaks into the washer, only when work is being done on city water system and sometimes whe...
hot water leaks into the washer, only when work is being done on city water system and sometimes whe...
(Posted by willardcameron59 6 years ago)
Maytag Washer Model Mah9700aww With 'nf' Error Code
I have a Maytag front-load washer model mah9700aww. I am sporadically getting an error code of "NF...
I have a Maytag front-load washer model mah9700aww. I am sporadically getting an error code of "NF...
(Posted by msblondegecko 11 years ago)
Will This Washer Work With A Hot Water On Demand House System?
I have a hot water on demand plumbing system in my house and it appears that even when I run a wash ...
I have a hot water on demand plumbing system in my house and it appears that even when I run a wash ...
(Posted by murphyteegan 13 years ago)