Maytag MVWX500XL Support Question
Maytag MVWX500XL Support Question
Find answers below for this question about Maytag MVWX500XL.Need a Maytag MVWX500XL manual? We have 3 online manuals for this item!
Question posted by jayhowell on May 4th, 2022
Wash Complete But Clothes Are Wet
I observed a maytag centennial complete a washing cycle and upon completion the clothes were overly wet. Upon watching from rear side with another load that the tub did not spin during the spin cycle. Agitator and pump works
Current Answers
Answer #1: Posted by SonuKumar on May 5th, 2022 12:15 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,621,300
Member since:
May 9th, 2021 Points: 16,621,300
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Answer #2: Posted by Odin on May 4th, 2022 11:41 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
See https://www.repairclinic.com/RepairHelp/Washing-Machine-Repair/11-4--/Maytag-Washing-Machine-Troubleshooting. Of these Most Common Problems, consider the ones listed first in the first and second rows.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MVWX500XL Manual Pages
Installation Instructions - Page 2
...tub or utility sink, sump pump and connectors (available from local plumbing suppliers)
1" (25 mm) standpipe
2" (51 mm) diameter to improve performance and minimize noise and possible "washer...Kit Part Number 285835
LOCATION REQUIREMENTS
Select proper location for installation are in cardboard insert in a basement, laundry room, closet, or recessed area.
271/2"
27"
(648 mm) (686 mm)
42" (...
Installation Instructions - Page 3
... than 96" (2.44 m) from bottom of wash tub. n Hot and cold water faucets located within 4 ft (1.2 m) of
power cord on carpet is your responsibility. See "Washer Care" in low temperatures. Add spacing of ... Guide. Top of 1" (25 mm) under entire washer. n A level floor with water and load) of washer. If you must be needed.)
Laundry tub drain system
Minimum capacity: 20 gal. (76 L)....
Installation Instructions - Page 4
...operation and to avoid excessive noise from shipping carton on cardboard supports. If your washer includes a sound shield, please refer to the instructions included with a power supply cord having... not ground to have a fuse in the neutral or ground circuit.
48" (1.2 m)
Move washer to install it is recommended that a qualified electrician determine that a separate circuit breaker serving only ...
Installation Instructions - Page 5
...laundry tub. You may need to back of washer.
4.5" (113 mm)
Place hose into standpipe or lay on elbow end of drain hose, slide it over side of drain hose should be used.
5 IMPORTANT: 4.5" (113 mm) of laundry tub. For a laundry tub... from washer lid, open lid and remove cardboard packing tray from rear panel. Gently place power cord over console to allow free access to move washer later...
Installation Instructions - Page 6
.... Check for leaks
Turn on water faucets to check for a few seconds through hoses into a laundry tub, drainpipe, or bucket to tighten couplings an additional two-thirds turn . NOTE: Both hoses must...It will cross over each other when attached correctly. Do not use tape or sealants on washer. 7. Remove drain hose form (floor drain installations only)
9. Clear water lines
For floor...
Installation Instructions - Page 7
...
Wall
14. Recheck levelness of sides. Use side seam as a guide to check levelness of washer and repeat as shown.
Not Level
LEVEL
Not Level
7
Check levelness of washer. HELPFUL TIP: You may want to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with wooden block.
Then turn the leveling foot...
Installation Instructions - Page 8
... water faucets are now installed.
Select any tape
remaining on washer. Start washer and allow to see what was skipped. q Check that washer is an extra part, go back through steps to complete full cycle.
8 q Check that yellow shipping materials were completely
removed from console and any cycle. q Remove protective film from back of powdered or liquid...
Energy Guide - Page 1
Clothes Washer Capacity: Standard
Maytag Models: MVWX500X*, MVWX550X*,
MVWX600X*, MVWX700X* Cat. U.S. V0Wm7DFA(3B)
Estimated Yearly Operating Cost
(when ... and use.
• Cost range based only on standard capacity models. • Estimated operating cost based on eight wash loads a week and a 2007
national average electricity cost of 10.65 cents per therm.
• For more information, visit...
Owners Manual - Page 3
... kinds of your load or allows time for your previous washer. Rather than diluting detergent as the washer determines the correct water level for clothes to use. It may hear nothing at the beginning of the wash cycle, you may also result in an agitator-style washer, this washer delivers the detergent directly to a traditional agitator-style washer. The package will...
Owners Manual - Page 4
.... You will leave your previous washer provided.
• Even in the rinse for each wash cycle. This light indicates that the lid is locked and cannot be selected if using fabric softener during a cycle.
For lightly soiled and delicate fabrics, press SOIL LEVEL to thoroughly wet the load. Not all spin speeds are available on all models...
Owners Manual - Page 5
...wash items or dripping wet items
Drain & Spin
No clothes in bold are available on during sensing.
Extra Rinse is a default option, but may also hear water flowing through the dispenser, adding detergent to drain washer after cancelling a cycle or completing a cycle after power interruption. Use this cycle to the load. This cycle features a spray rinse. This cycle uses a spin...
Owners Manual - Page 6
.... Helpful Tips: • When washing water-proof or water-resistant items, load
evenly. See "Cycle Guide" for best cleaning and to avoid pilling. USING YOUR WASHER
1. Loose change, buttons, or any... and prepare your garments.
Do not wrap large items such as sheets around basket wall. Load laundry into fabric.
• Treat stains promptly.
• Close zippers, fasten hooks, tie ...
Owners Manual - Page 7
... will be dispensed into the last rinse. It is closed completely, then press POWER/cancel to choose your load size. It may cause detergent to be selected to immediately dispense into detergent tray. HELPFUL TIP: See "Washer Maintenance" for the best performance. Select cycle
Do not overfill, dilute, or use color-safe bleach or...
Owners Manual - Page 8
... once the washer movement has stopped. Select cycle modifiers
10. Select Start/Pause/Unlock
to check for several minutes if the load was spinning at high speed. This may be cooler than 10 minutes the water will light up slightly, and then continue pulling out. 3. Bright colors Moderate to help dissolve detergents.
Wash in soil...
Owners Manual - Page 9
... washer where it will be interrupted, press POWER/CANCEL and run a Rinse and Spin cycle to wipe up any remaining water into washer for a medium-size load...washer. bleach dispenser Liquid chlorine
IMPORTANT: Do not add detergent to locate, level, and
connect washer. 2. Turn on RINSE AND SPIN cycle for a period of time, follow these steps: 1. NON-USE AND VACATION CARE
Operate your clothes...
Owners Manual - Page 10
... restrict water flow.
10 Check all four fill hose flat washers are removed during the spin/drain cycles. See "Using Your Washer" for leaks (laundry tubs, drain pipe, water pipes, and faucets.)
Washer not loaded properly.
TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com/help
Clicking or metallic noises
Objects caught in...
Owners Manual - Page 11
... or wash light remains on (indicating that may hear the hum of cycle. Do not add more detergent. Always measure detergent and follow detergent directions based on your garment.
Load may not allow even distribution of the load in pump or between basket and tub, which can slow or stop the washer. Select Drain & Spin to the washer.
Only...
Owners Manual - Page 12
... hose.
Inlet valve screens on load after cycle
Incorrect or wrong wash or rinse temperatures
High speed spins extract more water to slow or stop draining and spinning.
Washer not loaded as recommended.
Add only 1 or 2 garments after washer has started . Washer not loaded as recommended. Not cleaning or removing stains
Wash load not completely covered in less effective cleaning...
Owners Manual - Page 13
... label instructions. The washer will not start or fill with the best cycle.
Always measure detergent and follow manufacturer's directions based on your load, or use liquid HE detergent. Use Whites and Power Wash cycle for the fabrics being washed. Liquid chlorine bleach may have tangled. The lid is tightly packed.
It is complete to avoid dye...
Owners Manual - Page 14
...or to you. In Canada, call 18006889900. MAYTAG® LAUNDRY LIMITED WARRANTY
This Maytag Limited Warranty supersedes and replaces the limited warranty printed in the Use and Care ... area where service by an authorized Maytag servicer is not available.
9. This limited 10-year warranty on the duration of implied warranties of the washer and that is operated and maintained ...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Washer will not fill or start - Top-load HE washer with Dispensers in Corners
... Delay Wash status light on? (on some models only) Your washer will not fill or start - To run properly, the washer should seem low because this washer work differently than the washer provides. Once the load is not completely submerged in Corners FAQs Knowledgebase search tips Select Spin or Spin Only to be closed after the last cycle? Is... -
How do I clean my Epic® or Neptune® front-load washer?
... Epic or Neptune front loading washer? This will begin. Do not add any clothing or items from the softener and bleach compartments). To maintain washer freshness: Use only HE High Efficiency detergent. Do not use . My front load washer has an odor Not draining, not spinning out water, wet loads - Select the hottest wash water temperature available (not... -
My Bravos® washer is not rinsing loads well. What is causing this? Dispensers in Corners
....6°C). Not draining, not spinning out water, wet loads - My Bravos® Bravos washer with water. Can I turn off the button tones on the detergent packaging. What is causing this ? washer? Dispensers in my washer? The Stain Cycle option (one some models) should be started filling with Dispensers in low-speed wash cycles, such as sand or lint...
Similar Questions
My Maytag Mvwb450wq Washer Won't Go From Fill To Wash Cycle.
It puts a small amount of water in. Then it sounds like it is spinning and never goes in to the wash...
It puts a small amount of water in. Then it sounds like it is spinning and never goes in to the wash...
(Posted by Parti1961 4 years ago)
Maytag Washer Mvwx700 How To Use Only Cold Water During Wash Cycle
(Posted by burleakin 9 years ago)
Mvwc200xwo Odor Problems
Our clothing continously sours after the wash cycle has completed. After following all suggested tro...
Our clothing continously sours after the wash cycle has completed. After following all suggested tro...
(Posted by mceacrl 11 years ago)
Does Not Fill With Water But Goes To Wash Cycle Sensor Light And Does Nothing
Washer senses for a long time then goes to wash cycle light but no waterfills.
Washer senses for a long time then goes to wash cycle light but no waterfills.
(Posted by cutting2009 11 years ago)
Will This Washer Work With A Hot Water On Demand House System?
I have a hot water on demand plumbing system in my house and it appears that even when I run a wash ...
I have a hot water on demand plumbing system in my house and it appears that even when I run a wash ...
(Posted by murphyteegan 13 years ago)