Maytag MVWC300XW Support Question
Maytag MVWC300XW Support Question
Find answers below for this question about Maytag MVWC300XW.Need a Maytag MVWC300XW manual? We have 5 online manuals for this item!
Question posted by aprilluvinlife on July 3rd, 2014
How Do I Get The Top Off My Washer?
The rod that holds the tub in place has come out of it's bracket at the top of the washer. The top seems to be screwed to the bottom panels instead of the usual clips that make access easy to pop it open.
Current Answers
Answer #1: Posted by richsappliance on July 3rd, 2014 8:48 PM
richsappliance
Member since:
January 18th, 2014 Points: 91,150
Member since:
January 18th, 2014 Points: 91,150
1. Unplug washer or disconnect power.
2. a. Turn off the water supply to the washer.
b. Tape the lid down.
3. a. Remove top screw from each hinge on the back of the control panel.
b. Remove wire harness cover. On the left, below control panel on back of washer.
4. Slide top forward about ½ ",
5. Raise the top about ¼ ".
6. While still keeping it lifted, push the top
back about ¼ "
7. Tilt the top up on the rear hinges.
If I helped please "ACCEPT" my answer. Thanks
Related Maytag MVWC300XW Manual Pages
Installation Instructions - Page 2
... tape
Pliers that open to improve performance and minimize noise and possible "washer walk". Tools needed:
Parts needed: (Not supplied with washer)
Your installation may... require additional parts.
If you have:
You will need:
Overhead sewer
Standard 20 gal. (76 L) 39" (990 mm) tall drain tub...
Installation Instructions - Page 3
..., doors, and floor moldings. install no more space for closet door ventilation openings which are required. Top of laundry tub must install higher than 4.5" (113 mm) of wash tub. Minimum siphon break: 28" (710 mm) from bottom of 0" (0 mm) clearance on washer, and water pressure of installation and servicing, and spacing for companion appliances and...
Installation Instructions - Page 4
... of the customer to install it and make sure lid is equipped with the sound shield to have a fuse in the neutral or ground circuit.
48" (1.2 m)
Move washer to within 4 ft (1.2 m) of its final location; Remove shipping base
To avoid damaging floor, place cardboard supports from washer.
1.
Move washer
n A 120 volt, 60 Hz., AC only...
Installation Instructions - Page 5
... standpipe; Place drain hose in picture) or over side of laundry tub. do not force excess hose into standpipe (shown in standpipe
Drain hose form
Firmly grasp power cord plug and pull to drain port
Remove tape from washer lid, open lid and remove cardboard packing tray from tray. Remove packing tray from rear panel. Free...
Installation Instructions - Page 6
...a few seconds through hoses into a laundry tub, drainpipe, or bucket to water faucets
...washer. NOTE: Both hoses must be attached and have water flowing to washer correctly. If you are found.
11. Screw on water faucets to water faucets with new inlet hoses with flat washers...inlet hoses to washer
Attach hose to tighten couplings an additional two-thirds turn .
HELPFUL TIP: Make note of ...
Installation Instructions - Page 7
... beaded tie strap. HELPFUL TIP: You may want to prop washer with floor. Check levelness of washer
Place level here
Place level here
If washer is not level, use a 9/16" or 14 mm open -end or adjustable wrench to check levelness of sides.
12. Secure drain hose
Laundry Tub
Standpipe
Wall
14. Use side seam as needed. Then...
Installation Instructions - Page 8
... that yellow shipping materials were completely
removed from console and any cycle. q Remove protective film from back of your tools. q To test and clean your Washer User Instructions. Close lid. Plug into a grounded 3 prong outlet. q Check for leaks around faucets and inlet hoses. Be sure you have correct electrical supply and...
Dimension Guide - Page 1
...
1" (25 mm)
3" (76 mm)
Dimensions show recommended spacing allowed, except for closet door ventilation openings which are for floor standpipe drain system. Consider allowing more than 96" (2.44 m), you will need a... only this washer be inside standpipe or below the top of drain hose should be provided. Top of laundry tub must install higher than 4.5" (114 mm) of wash tub. IMPORTANT: ...
Energy Guide - Page 1
... www.ftc.gov/appliances (P/N W10062952) U.S.
Government
Federal law prohibits removal of
$1.218 per kWh and natural gas cost of this label before consumer purchase. Clothes Washer Capacity: Standard
Maytag Model: MVWC300X* Cat.
Use & Care Guide - Page 2
WASHER SAFETY
2
Use & Care Guide - Page 3
...Energy
Choosing the Right Detergent
First stage
Second stage
Your new Energy Star® qualified washer saves energy by -step description in component failures and noticeable mold or mildew. The ... of the wash cycle delivers detergent directly to traditional top-load washers. The lower water level combined with dirty laundry, fill it is normal for the best performance.
It may hear...
Use & Care Guide - Page 4
...make a slight turn the basket in the rinse cycle for the load. If the sensing light is on, then washer is spinning, it may repeat until the correct amount of the cycle. NOTE: Avoid opening...on your washer. CONTROL PANEL AND FEATURES
1
2
3
2
5
4
Not...laundry load. Press and hold for your fabric.
• Warm and hot water will start over when the washer...
Use & Care Guide - Page 5
...as the washer rinses and moves the load. LID LOCKED To allow for proper water removal, based on the selected cycle and spin speed. If you will come on. You will be opened. Fabric softener... may change at high speed. Avoid opening the lid during this stage. The sensing process will hear water enter the washer as the tub spins, allowing the rinse water to become saturated.
Use & Care Guide - Page 6
...Softener Added-Yes if using fabric softener. Select Fabric Softener AddedYes if using fabric softener.
Place small items in mesh garment bags before the wash portion of no -iron fabrics such...if using fabric softener.
Select Fabric Softener Added-Yes if using fabric softener.
The washer will absorb more water than for others because they will fill with enough water to...
Use & Care Guide - Page 7
...if stains remain after washing, because heat can set stains into the bottom of the washer basket before adding clothes.
Helpful Tips:
• When washing water-proof or water-... follow fabric care label instructions to avoid damage to your laundry
2. IMPORTANT: Follow the manufacturer's instructions to determine the amount of the washer basket, as well. Sort and prepare your garments. Add...
Use & Care Guide - Page 8
Load laundry into washer. Try mixing different sized items to choose your load size. Pour a measured amount of the rim. always follow manufacturer's directions for best cleaning and to ... Fabric Softener Added-Yes option.
Add fabric softener, if desired
Load garments in cycle.
6.
Select cycle
IMPORTANT: Do not tightly pack or force items into washer
5.
Use & Care Guide - Page 9
...that bleed or fade
Light soils
Select the desired cycle options. If your previous washer provided.
Delay in soil removal and to open for several minutes if the load was spinning at high speed. If you ...be added, so this will be cooler than 10 minutes, the water will unlock once the washer movement has stopped.
Unlocking the lid to add garments If you select a cycle, select the...
Use & Care Guide - Page 10
...not add detergent. Press and hold the START/Pause/Unlock for 3 seconds to washer.
2. Remove dispenser by grasping top with both water faucets; WASHER MAINTENANCE
WATER INLET HOSES
Replace ...time, follow this recommended monthly cleaning procedure:
1. Make sure the washer is empty. 2. To winterize washer: 1. Shut off water supply to washer, to avoid flooding due to mix antifreeze and ...
Use & Care Guide - Page 12
... in water.
Drain hose connection. Do not place tape over drain opening. Water can restrict water flow.
12
Washer won't run or fill, washer stops working or wash light remains on . Do...normal for any kinks in washer drain system. Wash smaller loads to drainpipe or laundry tub. Fill hoses not attached tightly.
Tighten fill-hose connection. Make sure all household plumbing for...
Use & Care Guide - Page 13
... basket, and add detergent. Select the Drain & Spin cycle to drainpipe or tub.
Do not add detergent.
13 Normal washer operation.
Drain hose extends into a grounded 3 prong outlet. Ensure there is ...hose if the end is balanced. To remove suds, cancel cycle. Do not tape over drain opening.
Check plumbing for proper installation. Close lid and press START/Pause/Unlock. Do not add ...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Washer will not fill - Front-load Epic® washer
... filling. My Epic ® If the washer is properly leveled from the washer. Make sure to continue. The washer pauses for each load. Allow the cycle to completely open both faucets for the proper water level: Make sure the washer is on ? To test for proper fill. Make sure the washer is at the lowest 6-o'clock position... -
Leaking water - Top-load washer
... plumbing (laundry tub, faucets, drainpipe and water pipes) for details; enter your product model number in the search tool below to be secure, but not sealed, in the drainpipe. If the washer cabinet leans... drain system can back up out of leaks. Make sure that the basket is not backing up ? Securing the drain hose will keep it from coming loose from the inlet hoses? Is the drain... -
Washer continues to fill or continues to drain - Top-load HE washer with Dispenser Drawer
... drain. What should be loose, yet secure. Make sure that the drain hose does not extend more than the minimum height of drain hose in the drainpipe or laundry tub. Top-load washer Sounds different than 4.5" (113 mm) into the drainpipe? sound clips Display shows Ld - Washer continues to fill or continues to gravity. The...
Similar Questions
Light Will Not Come On And It Just Hums
I have Centennial MVWC300XW, The light will not come on and the lid lifts up while it is humming. Do...
I have Centennial MVWC300XW, The light will not come on and the lid lifts up while it is humming. Do...
(Posted by kdiazio 9 years ago)
Does Maytag Centennial Washer Mvwc300xw Need High Efficiency Detergent?
(Posted by Johabi 9 years ago)
Maytag Clothes Washer, Front End Loader, High Efficiency. Making Grinding Noise
how do i solve the problem with the maytag front end loading, high efficiency clothes washer. it m...
how do i solve the problem with the maytag front end loading, high efficiency clothes washer. it m...
(Posted by truegrit229 11 years ago)
Front Load Washer Stops In Middle Of Cycle, Makes Buzzing Noise. Help
Washer has stopped in middle of the cycle. The door remains locked. Unplugged unit and when rest...
Washer has stopped in middle of the cycle. The door remains locked. Unplugged unit and when rest...
(Posted by ceraplace 11 years ago)