Maytag MVWC300XW Support Question
Maytag MVWC300XW Support Question
Find answers below for this question about Maytag MVWC300XW.Need a Maytag MVWC300XW manual? We have 5 online manuals for this item!
Question posted by tecpengu on March 12th, 2014
Mvwc300xw Will Not Start
The person who posted this question about this Maytag product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Maytag MVWC300XW Manual Pages
Installation Instructions - Page 2
... basement, laundry room, closet, or recessed area.
271/2"
27"
(648 mm) (686 mm)
42" (1067 mm)
2
Tools needed:
Parts needed: (Not supplied with washer)
Your ...installation may require additional parts. INSTALLATION REQUIREMENTS
Tools and Parts Gather required tools and parts before starting installation. To order, please refer to...
Installation Instructions - Page 3
... 285834), 2 Connector Kits (Part Number 285385), and an Extension Drain Hose (Part Number 285863) that may cause damage in washer after use may be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Top of 315 lbs (143 kgs). n A level floor with beaded tie strap.
3
Water remaining in low temperatures...
Installation Instructions - Page 4
...mating, 3 prong, grounding-type outlet, grounded in accordance with a qualified electrician if you start: remove shipping materials It is necessary to avoid excessive noise from shipping carton on cardboard ...wire is used, it at this appliance be in the neutral or ground circuit.
48" (1.2 m)
Move washer to within 4 ft (1.2 m) of the customer to install it is taped shut.
2. n Do not...
Installation Instructions - Page 5
...to remove all parts from tub. Attach drain hose to move washer later.
4.
IMPORTANT: 4.5" (113 mm) of laundry tub. Drain hose form must be inside standpipe;
Squeeze clamp with pliers and... slide black elbow end of laundry tub. You may need to drain port
Remove tape from washer lid, open lid and remove cardboard packing tray from tray. NOTE...
Installation Instructions - Page 6
... must be attached and have water flowing to check for a few seconds through hoses into a laundry tub, drainpipe, or bucket to hot water inlet valve marked with cold water inlet valve. If... two-thirds turn . IMPORTANT: Do not overtighten or use old hoses.
You may enter washer. In most standard configurations, hoses will drain later.
6
n Periodically inspect and replace hoses...
Installation Instructions - Page 7
... all four feet make solid contact with beaded tie strap. 12.
Level Washer
IMPORTANT: Level washer properly to step 14. HELPFUL TIP: You may want to check levelness of washer about 1/2" (13 mm) from the washer cabinet.
HELPFUL TIP: You may want to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with...
Installation Instructions - Page 8
...protective film from back of /recycle all of powdered or liquid detergent and pour it into washer basket or detergent dispenser (on washer. Select any tape
remaining on some models). q Check for leaks around faucets and inlet ...removed from console and any cycle. Close lid.
Start washer and allow to see what was skipped.
Plug into a grounded 3 prong outlet. q Dispose of...
Dimension Guide - Page 1
...ventilation openings which are required.
Minimum carry-away capacity: 17 gal. (64 L) per minute. Laundry tub drain system
41/2" (114 mm)
30" (762 mm)
1" (25 mm)
1" (...
3" (76 mm)
Dimensions show recommended spacing allowed, except for planning purposes only. Top of washer. Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right ...
Energy Guide - Page 1
... loads a week and a 2007
national average electricity cost of 10.65 cents per therm.
• For more information, visit www.ftc.gov/appliances (P/N W10062952) Clothes Washer Capacity: Standard
Maytag Model: MVWC300X* Cat. Government
Federal law prohibits removal of
$1.218 per kWh and natural gas cost of this label before consumer purchase. U.S.
Use & Care Guide - Page 3
...that are made to be above the water line. For example, you start the cycle, the lid will lock, and the washer will begin the sensing process to determine the correct water level for the...result in longer cycle times and reduced rinsing performance. You will create too much sudsing with dirty laundry, fill it is added.
WHAT'S NEW UNDER THE LID? Cleaning with HE detergent during the ...
Use & Care Guide - Page 4
....
It ensures that are available on your laundry load.
You will hear the motor turn , and the lid will be added to the washer to maintain a minimum temperature.
2 OPTIONS
The... cycle press START again. SENSING
When the START/Pause/Unlock button is restarted. To restart the washer after the lid has been opened press start over when the washer is pressed, the washer will then ...
Use & Care Guide - Page 5
...allows for proper water removal, based on .
Avoid opening the lid during this light will start over when the washer is complete, this stage. You will hear sounds similar to move the load. The ... the load promptly for the load to open the lid, press START/Pause/Unlock. At the beginning of the second stage, the washer will turn on the load size. The lid will hear the motor...
Use & Care Guide - Page 7
... garments if stains remain after washing, because heat can set stains into the bottom of the washer basket, as well.
If using an Oxi or color-safe bleach laundry boost product, add to avoid pilling. USING YOUR WASHER
1. Helpful Tips:
• When washing water-proof or water-resistant items, load evenly.
• Use...
Use & Care Guide - Page 8
...Softener Added-Yes option. Select cycle
IMPORTANT: Do not tightly pack or force items into washer
5. For more than 1 cup (250 mL).
IMPORTANT: Fabric Softener Added option must ... follow manufacturer's directions for best cleaning and to choose your load size. Load laundry into washer. Add liquid chlorine bleach to dispenser
Turn cycle knob to reduce wrinkling and tangling...
Use & Care Guide - Page 9
...START/Pause/Unlock button to restart the cycle. Unlocking the lid to add garments If you select a cycle, select the desired wash temperature by turning the Temperature knob to check for 2 to 3 minutes to the appropriate setting based on your previous washer...the cycle has finished, the DONE indicator will unlock once the washer movement has stopped. NOTE: Always read and follow fabric care ...
Use & Care Guide - Page 10
... more than recommended amount of time, follow this recommended monthly cleaning procedure:
1. If cycle must be interrupted, press START/Pause/Unlock twice and run washer on the label with the liquid fabric softener dispenser removed. Press and hold the START/Pause/Unlock for a period of bleach to ensure bleach has been rinsed from...
Use & Care Guide - Page 12
... block pump. Pull drain hose from washer cabinet and properly secure it to drainpipe or laundry tub. The washer senses load sizes and adds correct amount of water for any kinks in washer drain system. Check for optimal cleaning.
Washer not loaded as expected
Not enough water in the washer
Load not completely covered in this...
Use & Care Guide - Page 13
.... Select RINSE & SPIN. Cycles with lower spin speeds remove less water than 1 or 2 additional items after cycle has started to avoid tightly packing or unbalancing. Load may be tightly packed. See "Using Your Washer" for balanced spinning. Use drain hose form and securely attach to possibly avoid the cost of the load...
Use & Care Guide - Page 14
... the basket before adding the load items.
14
Remove any kinks in loose heaps evenly around the basket wall. Inlet valve screens on load after washer has started . The suds from too much detergent. Sand, pet hair, lint, etc. Add an Extra Rinse to the bottom of garments being washed.
Reduce tangling...
Use & Care Guide - Page 15
... suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of bleach dispenser when loading and unloading washer. Not using the Start/Pause/Unlock button.
Use Heavy Duty Heavy and Heavy Duty Regular cycle for the fabrics being washed.
Select Fabric Softener Added-Yes when...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Not filling or not starting - Load-sensing Energy Star top-load washer with agitator.
... have pushed in the correct position. Check to 6 seconds after the cycle started . The washer will start if the timer is on the washer clogged? Remove any accumulated film or particles from the washer. Washer will not start 4 to see if a household circuit breaker or Ground Fault Circuit Interrupt (GFCI) outlet has tripped. If so... -
Leaking water - Top-load washer
... the bottom of water per minute. Top-load washer Leaking water - See the Installation Instructions for leaks. Check the household plumbing (laundry tub, faucets, drainpipe and water pipes) for ...inlet hoses? Top-load washer My top-load washer is not backing up ? The drain system can cause water to see if the washer is centered before starting the washer. A large or unevenly ... -
Washer is not cleaning laundry - Top-load HE washer with Dispenser Drawer - video
... the Start button is added to the load. The washer will unlock briefly before starting the washer. Add only one or two items when the Sensing light is not cleaning laundry - ... and whites. Are the hot and cold water inlet hoses reversed? Washer is not cleaning laundry. Are you unload the washer promptly? See also: Why HE High Efficiency detergent is automatically added during...
Similar Questions
Does Maytag Centennial Washer Mvwc300xw Need High Efficiency Detergent?
(Posted by Johabi 10 years ago)
Maytag Centennial Washer,,,,constant Agitation, Even When Filling
My maytag is approx 2 years old, when I start the washer, it starts agitating right away, even witho...
My maytag is approx 2 years old, when I start the washer, it starts agitating right away, even witho...
(Posted by dandrday 12 years ago)