Maytag MVWB950YW Support Question
Maytag MVWB950YW Support Question
Find answers below for this question about Maytag MVWB950YW.Need a Maytag MVWB950YW manual? We have 4 online manuals for this item!
Question posted by Johnvalentine on October 4th, 2014
Doesn't Work. Sometimes It Will Sometimes It Won't. Motherboard Probs.
The person who posted this question about this Maytag product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by Odin on October 4th, 2014 8:35 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MVWB950YW Manual Pages
Installation Guide - Page 2
...)
Flashlight (optional)
4" min (102 mm)
Adjustable or open-end wrench 9/16" (14 mm)
Wood block
Drain hose form
Cable Tie
Parts needed (Not supplied with washer):
Water inlet hoses (2)
Flat inlet hose washers (4)
Tape measure or ruler
Level
2
INSTALLATION REQUIREMENTS
TOOLS AND PARTS Gather the required tools and parts before starting installation.
Installation Guide - Page 3
..., door, and floor moldings.
■■ Additional spacing should be considered on all sides of the washer to reduce noise transfer.
■■ For closet installation, with vents
* Required spacing
3 See your washer in a basement, laundry room, closet, or recessed area.
Louvered doors with equivalent ventilation openings are required. If you have:
You...
Installation Guide - Page 4
... 96" (2.4 m) from bottom of washer.
Floor drain system
■■ A 120 volt, 60 Hz., AC only, 15- If a mating outlet is not available, it is the personal responsibility and obligation of drain hose should be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Top of laundry tub must be at...
Installation Guide - Page 5
...removed, be sure lid is necessary for support. NOTE: To avoid floor damage during installation, set washer back upright, and remove the tape from the lid so that you start: remove shipping materials....ring
INSTALLATION INSTRUCTIONS
Before you can open the lid and remove the foam packing ring from the washer tub. IMPORTANT: ■■ Be sure the foam shipping base has been removed from the...
Installation Guide - Page 6
...washer basket is seated on smooth sections of laundry tub. Use pliers to avoid clogs. HELPFUL TIP: Make note of the laundry tub. Connect inlet hoses to washer correctly.
3. Both hoses must be connected for washer... but loose enough to work properly. Washer must extend 4.5" (114 mm) beyond the form.
3. IMPORTANT: To keep drain water from going back into the washer: ■■ Do...
Installation Guide - Page 7
... the cabinet.
4.5" 4.5" (114 mm) (114 mm)
4.5" (114 mm)
A
A
A
Secure drain hose to laundry tub leg, drain standpipe, or inlet hoses for leaks
Move the washer to work properly. You will help reduce the chance of washer
Place level here
Turn on valve when attaching to check whether all four feet are found.
5. 4. Connect inlet...
Use & Care Guide - Page 4
... 60°F (15.6°C), detergents do not dissolve well. SOIL LEVEL Soil Level (wash time) is designed to dispense laundry boosters such as well.
2 POWER/CANCEL BUTTON Press to turn the washer ON or OFF.
3 WASH CYCLE KNOB Use the Wash Cycle knob to ensure better soil and stain removal. For most...
Use & Care Guide - Page 5
...Fabric softener will continue to move the basket while filling. DONE Once the cycle is pressed, the washer will light if you can press REMINDER RESET button to restart. Press START/PAUSE once. Not ...moving the load. At each cycle. DELAY This indicator will add a small amount of water to work with all options can be used to automatically add a second rinse to delay the start of ...
Use & Care Guide - Page 6
... and options are default settings for liquid chlorine bleach, color-safe bleach, or Oxi product laundry boosters.
All cycle settings use Oxi products in their first wash. This dispenser cannot dilute ...Save Spray Rinse
Fabric Softener
Oxi Treat Stains
Use this cycle for sturdy garments with this washer.
• Do not spill or drip any fabric softener onto the clothes. • At...
Use & Care Guide - Page 7
...Fabric Softener
Oxi Treat Stains
This cycle is also a good choice for the cycle and washer model being washed. Cycle combines high-speed wash action and high-speed spin.
This cycle... "Machine Washable" on this cycle for liquid chlorine bleach, color-safe bleach, or Oxi product laundry boosters. For maximum soil and stain removal, use a cold rinse temperature.
7 This cycle uses...
Use & Care Guide - Page 9
... not load garments directly over the center of the washplate should be visible. USING YOUR WASHER
1. Load laundry into fabric.
• Treat stains promptly.
• Close zippers, fasten hooks, tie... items, load evenly. Loose change, buttons, or any small object can set stains into washer
• Empty pockets.
IMPORTANT: Garments need to move freely for tips and more information on...
Use & Care Guide - Page 10
...with liquid chlorine bleach. HE detergents are made to determine the amount of cleaning washer dispensers. Follow the manufacturer's instructions to produce the right amount of fabric softener... of suds for liquid chlorine bleach, color-safe bleach, or Oxi product laundry boosters. HELPFUL TIP: See "Washer Maintenance" for Oxi products. IMPORTANT: Fabric Softener option must be dispensed in...
Use & Care Guide - Page 13
... the console and secure with a damp cloth and towel dry. Because some water may find laundry product residue leftover in your washer for a period of time, follow WINTER STORAGE CARE directions before moving , or not using again, run
washer on both water faucets. 2. Put 1 qt. (1 L) of R.V.-type antifreeze in hoses, freezing can damage...
Use & Care Guide - Page 14
..., or zippers touch against the bottom of the washplate.
Water may be necessary to call ... Tighten fill-hose connection. Fill hose washers Drain hose connection
Check household plumbing for leaks (laundry tubs, drain pipe, water pipes, and faucets.)
An unbalanced load can backup out of alignment and cause water to hear metal...
Use & Care Guide - Page 15
... washplate. To remove suds, cancel cycle. Do not add more water to outlet. washer stops working (cont.)
Check proper electrical supply. Check that inlet valve screens have water flowing to inlet valve. Check for washer to run or fill, washer stops working
Both hoses must be tightly packed.
Do not interrupt cycle. Suds from regular...
Use & Care Guide - Page 17
... www.maytag.ca. The load will be completely under the Lid". Additional water lifts the laundry off the washplate, resulting in pockets during wash cycle.
The suds from regular detergent can occur if the washer is complete.
Unload washer as soon as recommended. Sharp items were in less effective cleaning.
Load garments in...
Use & Care Guide - Page 18
... in the dispenser. Use drain hose form and attach securely to continue.
Allow the washer to ensure proper dispensing.
Drain extends more than 4.5" (114 mm) into standpipe. See... operation
Clogged dispensers or laundry products dispensing too soon. Ld (too long to the cold water inlet. Use liquid chlorine bleach only in display
Washer lid left open . ...
Use & Care Guide - Page 19
... ... F## code (F-type error code) appears in Display (cont.)
dU (Lid cannot unlock) Objects on washer lid prevent it from the top of the washer. Fd (Factory Default)
Washer sets back to restart washer.
To return all All-purpose appliance cleaner Laundry supply storage cart
19 Accessories
See "Installation Instructions" for installation accessories
Part Number: 8212526...
Use & Care Guide - Page 20
... or limitation of incidental or consequential damages, so these parts that prevent function of the washer and that is not available.
9. If you are excluded from defects in accordance with Maytag...States and Canada, contact your major appliance if it was purchased. MAYTAG® LAUNDRY LIMITED WARRANTY
This Maytag Limited Warranty supersedes and replaces the limited warranty printed in ...
Warranty Information - Page 1
...limitation of incidental or consequential damages, so these parts that prevent function of the washer and that vary from state to state or province to resolve the problem
after checking... of purchase, when this major appliance was purchased. LIMITATION OF REMEDIES; MAYTAG® LAUNDRY LIMITED WARRANTY
This Maytag Limited Warranty supersedes and replaces the limited warranty printed in the...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
How do I clean my front-load washer dispensers?
... dispenser housing area, use a small soft brush to the housing. Front-load Neptune® Front-load washer FAQs Knowledgebase search tips Dispensers not working correctly - Remove the inserts from the drawer. The inserts are not working correctly - washer with rear-mounted console Leaking water - If needed, use mild soap and water and a soft... -
Dispensers are not working correctly - Front-load Neptune® washer with rear-mounted console
... any excess laundry additives. Overfilling can block the flow of the cycle. This is thicker than chlorine bleach and will remain in the dispenser at the end of water through the dispenser; There are not working correctly. Color-safe bleach is normal. How do I clean my front-load washer dispensers? Do... -
Washer continues to drain - Front-load washer
... machine (siphoning) as described in the Installation Instructions, will provide the appropriate length of the drainpipe covered in the drainpipe or laundry tub. Front-load washer Leaking water - Front-load washer Dispensers not working correctly - Is the drain hose taped onto the drainpipe? Is top of drain hose in tape? Make sure the...
Similar Questions
Washer Model 6630
At the end of the wash cycle there is a humming sound even though the screen reads end. Will this en...
At the end of the wash cycle there is a humming sound even though the screen reads end. Will this en...
(Posted by rfrizelle 2 years ago)
Fl Error Code
my Maytag Neptune washer gives error code FL. the washer will start but it gets to a point to spin o...
my Maytag Neptune washer gives error code FL. the washer will start but it gets to a point to spin o...
(Posted by spoindexter 2 years ago)
Why The Water When Selected On Hot Is Hardly Warm .
The hot water selection is misleading. The water is hardly warm and that does not does the job on my...
The hot water selection is misleading. The water is hardly warm and that does not does the job on my...
(Posted by rpazitny 6 years ago)
Machine Does Not Drain
My machine stops mid cycle without draining and no lights or codes are on
My machine stops mid cycle without draining and no lights or codes are on
(Posted by rosecottageone 9 years ago)