Maytag MHWE450WW Support Question
Maytag MHWE450WW Support Question
Find answers below for this question about Maytag MHWE450WW - 4.5 cu. Ft. Front Load Washer.Need a Maytag MHWE450WW manual? We have 2 online manuals for this item!
Question posted by plungedps on July 19th, 2011
Error 5r Comes Up What Does That Mean
what does error code 5r mean
Current Answers
Answer #1: Posted by ehjohnson7 on July 19th, 2011 1:49 PM
ehjohnson7
Member since:
July 17th, 2011 Points: 294,933
Member since:
July 17th, 2011 Points: 294,933
without knowing what product this for it is hard to tell but maytag.com has a owner center where you can download owners manuals with these codes. the one i looked ta was a Maytag Neptune MAH5500B Front Load Washer Problem and error cod 5r was problem with control call for service at
1-800-688-9900 USA and 1-800-688-2002 Canada
Related Maytag MHWE450WW Manual Pages
Owners Manual - Page 3
... of others . WARNING
You can kill or hurt you and others are not followed.
3 These words mean:
DANGER
You can happen if the instructions are very important. Always read and obey all safety messages.
WASHER SAFETY
Your safety and the safety of injury, and tell you what the potential hazard is the...
Owners Manual - Page 4
The parts supplied are in the washer drum.
Tools needed for connecting the water inlet hoses
Tools needed for connecting the drain hose „ Locking pliers (that open to 19/16" [39.5 mm])
„ Pliers (that open to 19/16" [39.5 mm])
„ Flashlight (optional)
4 INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Owners Manual - Page 5
...; and connector kit, Part Number 285835
4 ft (1.2 m) drain hose extension kit, Part Number 285863
2 longer water fill hoses: 6 ft (1.8 m) Part Number 76314, 10 ft (3.0 m) Part Number 350008
Optional pedestal
This ...you will add to the total height of the washer for a total height of 53.5" (1359 mm). Inlet hose washers (4) D. If You Have Laundry tub or standpipe taller than 96" (2.4 m)...
Owners Manual - Page 6
...with foam backing, is recommended to the washer.
„ A grounded electrical outlet located within 4 ft (1.2 m) of the hot and cold ...load) of 1" (25 mm) under a custom counter, or in a basement, laundry room, closet, or recessed area. See "Electrical Requirements." The dimensions shown are for the recommended spacing. Location Requirements
Selecting the proper location for your washer...
Owners Manual - Page 7
... closet or confined area
Recommended installation spacing for recessed or closet installation, with stacked washer and dryer
The dimensions shown are for the recommended spacing. Recommended installation spacing for ... spacing **For venting out the side, 1" (25 mm) spacing is allowed.
1" (25 mm)
7 Side view - Washer on pedestal
18" min. (457 mm)
1" (25 mm)
27" (686 mm)
A
1" (25 mm)
1" ...
Owners Manual - Page 8
...½" 1" 1" 27"
1"
(102 mm) (800 mm) (25 mm) (25 mm) (686 mm) (25 mm)
Drain System
The washer can result in the top are
required.
7" (178 mm) 7" (178 mm)
Laundry tub drain system (view C) The laundry tub needs a minimum 20 gal. (76 L) capacity. It is recommended. See "Tools and Parts." Additional hoses might...
Owners Manual - Page 9
...result in back or other injury. There are 4 bolts in accordance with local codes and ordinances. „ This washer is equipped with a power supply cord having a 3 prong grounding plug.
...IMPORTANT: Position the washer so that the rear of the washer is to have the properly grounded outlet installed by a certified technician.
9 NOTE: If the washer is within approximately 3 ft (900 mm) of...
Owners Manual - Page 10
...Screw on the washer. Once drain ... until it is seated on the washer.
4. H
C
9. NOTE: ...risk of use to the washer. Attach the hose with ...washers (supplied) into each end of drain
hose.
2. A
B
A. Washer
2. Screw on coupling by hand until it is seated on the washer...washers in place, release pliers.
Connect the Inlet Hoses
1.
Connect the Drain Hose
Remove drain hose from washer...
Owners Manual - Page 11
... perfectly level (use a 17 mm open-end wrench to turn the nuts on the bottom of the laundry tub. Repeat this step until washer is level, use a level).
3.
Complete Installation
1. Check the electrical requirements. See "Electrical Requirements."
2. Check that you have all packaging materials. 5.
IMPORTANT: All four feet must ...
Owners Manual - Page 12
... 50 minutes to follow these instructions can be changed, however. This washer provides a threecompartment dispenser which means fewer loads. The water level is self-cleaning, and can result in the wash... POWER/CANCEL, the Clean Washer cycle, and then select START/PAUSE. Laundry products are a beginner or an expert. Auto Water Level This washer automatically adjusts water level for...
Owners Manual - Page 13
...load of your washer. Dynamic Off-Balance Detection
This washer uses two sensors to detect load size and the amount of fabric.
This wash system, along with a regular non-HE detergent. It may be different from that of sorted clothes in washer errors... clothes.
Sort laundry according to color and type of off-balance within the load. Do not overload washer. Washer door should close...
Owners Manual - Page 14
... in component failures and noticeable mold or mildew. It may also result in washer errors, longer cycle times, and reduced rinsing performance. Follow the manufacturer's instructions to determine...items and avoid washing single items. Load evenly.
„ It is recommended that should be removed from the washer.
Open the dispenser drawer and add laundry products to the proper compartment. 3....
Owners Manual - Page 15
... Options and Modifiers are using the Delay Wash option, powdered laundry products should be used . Select START/PAUSE (for powdered detergent...mL).
„ The fabric softener is too high, the washer will not operate correctly with the same type of liquid or ...LIQUI
A
SO
B
„ Powdered detergent:
Selector in position for load size.
„ If you are available with a pour spout; This...
Owners Manual - Page 16
...for 3 seconds until the door of the washer. These routines may have preset options. Cycle done The cycle done indicator stays on your laundry. To lock the controls Select and hold ...resume with the addition of your water pressure, water temperature, detergent, and clothes load. Adding items This washer allows an 8-minute period in which portion of fabric and soil levels. To unlock...
Owners Manual - Page 17
...
Normal (1:50)
Hot/Cold
High
Power Wash
Heavy (1:55)
Hot/Cold
Extra High
Clean Washer N/A
N/A
N/A
with AFFRESHTM washer cleaner or bleach and steam, to thoroughly clean the inside of your laundry. Quick Wash Use this cycle to wash small loads of lightly soiled garments that you can reduce the spin speed by NSF International...
Owners Manual - Page 18
...„ You can be released after this option when you press cancel at anytime to unload your laundry.
18
„ To change Soil Level (cycle time), select the SOIL LEVEL button until the desired... control regulates incoming hot and cold water. See "Preset Cycle Settings" in the removal of load you are not able to unload your clothes soon after starting a cycle anytime before or during...
Owners Manual - Page 19
... your garments. „ Use only High Efficiency detergents. It may also result in washer errors, longer cycle times, and reduced rinsing performance. Remove non-washable trim and ornaments.
... "Gentle" cycle on load size. Lightly soiled sports wear made of polyester, nylon, linen, or cotton blends Use this cycle to avoid scratching the washer interior. LAUNDRY GUIDE
Refer to each ...
Owners Manual - Page 20
...
Heavy Work Clothes
4 jeans 4 work pants 4 work shirts
Towels
10 bath towels 10 hand towels
Mixed Load
3 sheets (1 king, 2 twin) 4 pillowcases 3 shirts 3 blouses
Loading
2 sweatpants 2 sweatshirts
14 washcloths
9 T-shirts 9 shorts 10 handkerchiefs
WASHER CARE
Cleaning Your Washer
Cleaning the door seal 1. NOTES: „ Read these areas of the tub for proper use. The machine...
Owners Manual - Page 21
...is complete, leave the door open slightly to allow the cycle to cancel the failure code.
Unlock the dispenser drawer by pressing the Release Lever
on both water faucets. 5.
...Cleaning the exterior Use a soft damp cloth or sponge to follow these instructions can damage your washer. Do not use an adapter. Disconnect water inlet hoses from faucets and drain.
WARNING
Electrical...
Owners Manual - Page 22
... to cancel the cycle.
The door may look closed for the washer to possibly avoid the cost of a service call for a medium-size load, to clean the washer and remove the antifreeze, if used . Press POWER/CANCEL and then press START/PAUSE. „ "F" Codes other than 96" (2.4 m) above the floor? Failure to rear panel...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Display shows an error code - Front-load washer
... an error code - Front-load washer Display shows F20 or FH - Front-load washer Display shows F26 - If the error remains on the display, call for one minute. Front-load washer The following answers for error-code related issues you can correct: Display shows Sud or Sd - Front-load washer Display shows F22 or FdL - washer - Front-load washer My front-load washer... -
Display shows an error code - Top-load washer with Dispensers in Corners
...load washer shows dU - Top-load washer with the washer: washer - Top-load washer The following list of codes indicates a possible electronics communication problem with Dispensers in Corners shows Sd - Top-load washer shows dL - Top-load washer shows HC - Top-load washer with Dispensers in Corners washer display . Display shows an error code - shows Sd - Top-load washer... -
Display shows an error code - Top-load washer with Dispensers in Corners
... Top-load washer Display shows dU - If the error remains on the display, call for service. Top-load washer with Dispensers in Corners Display shows Sd - Top-load washer with Dispensers in Corners Display shows Ld - Top-load washer Display shows Ld - Top-load washer Display shows HC - Top-load washer Display shows Po - Display shows an error code - Top-load washer The...
Similar Questions
Cu Ft For My Maytag Washer,model# Mhwe450ww02 Front Load Washer
Hi, I want to know cu ft for my Maytag washer,Model# mhwe450ww02 front load washer
Hi, I want to know cu ft for my Maytag washer,Model# mhwe450ww02 front load washer
(Posted by rashmi3462 8 years ago)
Have Maytag Neptune Front Load Washer, It Has Come Up With An R5 Error Code, Wha
washer works fine just eror code 5r error code everry 5 min beeps too?
washer works fine just eror code 5r error code everry 5 min beeps too?
(Posted by carasbmw 11 years ago)
What Does The Error Code F-30 Mean Maytag Mhwe500vp
What does the error code F-30 mean and how do I fix it. Is there a service manual for a mhwe500vp
What does the error code F-30 mean and how do I fix it. Is there a service manual for a mhwe500vp
(Posted by kami2 12 years ago)
What Does Lf Error Code
What does error code LF mean on a matag series 2000 front loader washer
What does error code LF mean on a matag series 2000 front loader washer
(Posted by Hpennie123 12 years ago)
What Does The Error Code F-35 Mean?
i have a maytag 5000 series wiyh steam the error code F-35 was displayed what does that mean
i have a maytag 5000 series wiyh steam the error code F-35 was displayed what does that mean
(Posted by anzerb01 13 years ago)