Maytag MHW7100DW Support Question
Maytag MHW7100DW Support Question
Find answers below for this question about Maytag MHW7100DW.Need a Maytag MHW7100DW manual? We have 5 online manuals for this item!
Question posted by pettifer31 on January 15th, 2017
Our Washer Mhw7100dw Is Stuck Locked And Motor Stuck
Is there a reset button on motor, our washer sounds like its humming but not performing and stuck on lock can't open.
Current Answers
Answer #1: Posted by Odin on January 15th, 2017 5:59 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
See https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Washing-Machine/46-4--TUhXNzEwMERXMA==/Maytag-Washer-won-t-start. That page should solve--but if not, search the manual at https://www.manualslib.com/manual/985258/Maytag-7mmhw7100dc0.html#product-MHW7100DW0.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MHW7100DW Manual Pages
Installation Guide - Page 2
... for some installations, not supplied with washer)
n 8212656RP 10 ft. (3.0 m) Inlet...washers (4)
Parts supplied:
NOTE: All parts supplied for ordering information, or see the "Assistance or Service" page on the back page of your "Use and Care Guide". INSTALLATION REQUIREMENTS
TOOLS AND PARTS Gather required tools and parts before starting installation.
Tools needed:
Adjustable or open...
Installation Guide - Page 3
..., and spacing for companion appliances and clearances for closet door ventilation openings which are required.
Water remaining in washer after use may cause damage in your model, refer to 120° F (49° C).
Space must support washer's total weight (with maximum slope of washer.
For each arrangement, consider allowing more space for ease of...
Installation Guide - Page 4
... drain hose with cable tie. Minimum carry-away capacity: 17 gal. (64 L) per minute. Top of laundry tub must be at least 30" (762 mm) high; install no higher than 96" (2.44 m) from bottom of washer. Top of standpipe must be at least 30" (762 mm) above floor; install no higher than...
Installation Guide - Page 5
... possible shock hazard, the cord must be provided.
NOTE: To avoid floor damage, set washer onto cardboard before moving it is recommended that a qualified electrician determine that a separate circuit breaker...prong, grounding-type outlet, grounded in a fully upright position.
2. Do not use an adapter. Move washer
n A 120 volt, 60 Hz., AC only, 15- Do not remove ground prong. Do not...
Installation Guide - Page 6
Gently place power cord over bolt holes with separate directions. For a laundry tub or standpipe drain, go to center of washer. You may need additional parts with transport
bolt hole plugs
Remove the yellow shipping strap from the cord. NOTE: If washer is not already in rear panel and close hole with a 1/2" (13 mm...
Installation Guide - Page 7
... should run until it is connected to hot water to help in attaching hoses to work properly. 8. Do not use hoses without washers.
11. Coupling
B. Insert new flat washers
For floor drain installations, you will cross over side of laundry tub.
In most standard configurations, hoses will need additional parts with separate directions.
Installation Guide - Page 8
... leveling feet. Repeat with floor, go to tighten couplings an additional two-thirds turn on floor. Secure drain hose
Laundry Tub
Standpipe
Wall
4.54".5" (114 mm)
4.5" (114 mm)
4.5" (1143 mm)
Grip washer from top and rock back and forth, making sure all four feet are in steps 18 and 19, repeating as...
Use & Care Guide - Page 4
... the Overnight Wash & Dry cycle, use for the cycle selected. To ensure your laundry load. Touch to run 30 wash cycles as a soccer uniform or a running tank and shorts. Model MHW7100D
4 5
6
2 1
A
B
C
D
E
Model MHW5400D
3
4
4 5
7 6
1
Model MHW4100D
2
3 4
5
B C A D E
7 6
2 1
C
A
D
E
3
1 POWER/CANCEL Touch to turn the washer on and off . An LED will also turn the...
Use & Care Guide - Page 5
... locked the second time, the washer will continue to show that the door is locked and cannot be opened ...CONTROL
LOCK is held , the washer will first perform a self-test on the door lock mechanism...sound when a setting is touched: Touch and hold CYCLE SIGNAL for 3 seconds. the washer remembers the last on/off the tones that sounds at various times during the cycle, such as when the washer...
Use & Care Guide - Page 6
...HE detergent for the best performance. B Liquid fabric softener compartment Automatically dilutes and...the amount of detergent to dispenser drawer. Add laundry products as described in steps 4-6 in low ...time. Use only High Efficiency (HE) detergent. Open the dispenser drawer. 2. Make sure it is ...Pour a measured amount of HE detergent into the washer too early. USING THE DISPENSER DRAWER
1. Slowly...
Use & Care Guide - Page 9
... of sorted clothes loosely in mesh garment bags.
Loose change, buttons, or any small object can be fully loaded, but not tightly packed.
Sort and prepare your garments. Separate delicate items from lightly soiled.
USING YOUR WASHER
First wash cycle without laundry
Before washing clothes for the first time, if not completed during...
Use & Care Guide - Page 10
... not fill past the MAX line. They will not dispense correctly.
4. do not guess.
USING YOUR WASHER
USING LAUNDRY PRODUCT DISPENSERS
NOTE: Do not add single-dose laundry packets, Oxi-type boosters, color-safe bleach, or fabric softener crystals to dispenser (if desired)
Liquid HE detergent
Powdered HE detergent
Adjust the selector, based...
Use & Care Guide - Page 11
...cycle features.
9.
Tightly packing the load, unbalanced loads, or excessive suds may also cause the washer to set the delay. To set the desired delay time.
2. Adjust settings, if desired*
...Cycle Time. This will delay the start :
1. buttons to select your wash cycle. See "Cycle Guide" for Stains, Extra Rinse, Cycle Signal, or Control Lock. Temperature, Soil Level, or Spin Speed. If ...
Use & Care Guide - Page 12
...open to allow the washer to dry between the tub and the washer drum. This may do so while the "Add a Garment" light is lit.
n This washer has a tight seal to avoid water leaks. the door will remain locked...CANCEL.
To avoid odors, leave the door open the door to add 1 or 2 missed garments, you will hear the door lock, unlock, and lock again. To pause a cycle in the ...
Use & Care Guide - Page 13
... Grit Grabber™ cloth.
f.
Cleaning the Door Seal 1. Open the washer door and remove any detergent or other chemicals to help dry the washer interior after the cycle is on , the washer door will use it for Best Performance):
a. Open the washer door and remove any clothing or items.
b. Open the dispenser drawer and add liquid chlorine bleach...
Use & Care Guide - Page 16
... drum during that may appear when the washer is not turned on washer may be keeping the door from closing completely. Door has not been opened and closed for proper installation.
If code...size.
Run the Clean Washer with affresh® cycle. In Canada www.maytag.ca for service. Washer is higher than 41⁄2" (114 mm).
Washer door not locking.
Touch POWER/CANCEL once ...
Use & Care Guide - Page 17
...Load could fall between washer drum and tub or may make a humming sound with the floor and locked. Objects caught in ...locking or unlocking.
This is normal.
Empty pockets before washing. The pump may block pump.
Water or suds leaking from washer" in the back of water for leaks or clogged sink or drain. Door opened after touching and holding START. Washer not performing...
Use & Care Guide - Page 19
... Installation Instructions.
See "Cycle Guide" for load size recommendation for your load. Door locked at www.maytag.com/product_help - cycle.
Both hoses must be attached to keep up...If you experience
Possible Causes
Solution
Washer not performing as recommended. Use drain hose form
than normal. pump or stuck between cycles.
Door not opened and then closed before a ...
Use & Care Guide - Page 22
... experience
Possible Causes
Solution
Washer not performing as a rug or jeans...washer drum before starting a cycle. Homes with a few extra items.
The Rapid Wash cycle is on your garments without increasing cycle times. This may lengthen the cycle time. For each second CONTROL LOCK is added to remove extra suds and ensure proper rinsing of lightly soiled garments. Single-dose laundry...
Dimension Guide - Page 2
... the minimum required. Floor standpipe drain system
Laundry tub drain system
4.5" (114 mm)
Minimum diameter for closet door ventilation openings which are required.
1" (25 mm)
4" (102 mm)
** Recommended 4" (102 mm), minimum 1.5" (38 mm)
ELECTRICAL REQUIREMENTS
A 120 volt, 60 Hz., AC only, 15-
Minimum siphon break height: 28" (710 mm) from bottom of washer.
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Vibration - Front-load washer
...;Each unit is normal. The final spin lasts about 2 to 3 minutes. During the final spin, higher spin speeds create sounds that are normal for details. Check feet contact Adjust washer feet Tighten lock nuts Check washer level Refer to extract more water from the factory with your hands; Normal... -
Sounds different than my previous washer- Front-load washer
..., 260 KB) Play the sound of a washer tumbling a load. Front-load washer Washer not draining, not spinning out water; Front-load washer The door will hear sounds that you will not open - Front-load washer Front-load washer Sounds during wash - Front-load washer My front-load washer makes different sounds than my previous washer- Front-load washer Vibration - As with water... -
Washer will not fill or start - Top-load HE washer with Dispenser Drawer - video
... button is pressed, the washer will unlock briefly before locking again. Is the washer in a normal pause in Corners Not filling or not starting the washer. The washer may also pause for more items. Do not add more items to the load once the washer started . Turn off throughout the wash. Is the lid open...
Similar Questions
My Washer Sounds Like It's Off Balance
My washer sounds like it's off balance but it's not and I can't seem to figure out what the problem ...
My washer sounds like it's off balance but it's not and I can't seem to figure out what the problem ...
(Posted by poisoni29 3 years ago)
Maytag 400 Washer Door Locked Wont Open
(Posted by ritrspe 9 years ago)
Does My Maytag Epic Washer Have A Reset Button
The control is locked on my washer, is there a reset button or buttons?
The control is locked on my washer, is there a reset button or buttons?
(Posted by Alchar 9 years ago)
Maytag Washer Control Locked Wont Open
(Posted by Rduarsha 10 years ago)
Maytag Front Load Washer Door Will Not Close After Forcing Open
(Posted by Anonymous-33898 12 years ago)