Maytag MHW7000XG Support Question
Maytag MHW7000XG Support Question
Find answers below for this question about Maytag MHW7000XG.Need a Maytag MHW7000XG manual? We have 3 online manuals for this item!
Question posted by docpipeline on March 29th, 2013
Error Codes
I have an intermittent issue with error codes F08 and E02. What are these error codes? Because the error codes are intermittent I'm affried to call for service, please advise.
Current Answers
Answer #1: Posted by Odin on April 6th, 2013 5:55 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,640
Member since:
April 10th, 2010 Points: 41,236,640
These are fully explained at:
http://www.justanswer.com/appliance/5b63m-new-maytag-maxima-front-loader-2-months-old.html
http://www.justanswer.com/appliance/5b63m-new-maytag-maxima-front-loader-2-months-old.html
Go to the Accepted Answer.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MHW7000XG Manual Pages
Owners Manual - Page 3
... stack kit allows the dryer to be installed on options and ordering, contact your new washer and dryer with the following genuine Maytag accessories. For more comfortable working and storage area. Worksurface The worksurface bridges the washer and dryer, and provides a convenient working height.
ACCESSORIES
Customize your dealer, or visit: www.maytag...
Owners Manual - Page 4
...wrinkle control
whites
allergen
delicate
start
small cancel load
rinse/drain & spin soak
clean washer
with Steam, and 8 hours on models with
pause
press and hold for detailed ... fabric softener C Liquid chlorine bleach
1 POWER/CANCEL BUTTON Press to start of cycles that best suit your laundry load.
Press to stop/cancel a cycle at any time.
2 WASH CYCLE KNOB Turn the Wash Cycle...
Owners Manual - Page 5
...level settings will lock while the Fresh Hold option is pressed. NOTE: You may cause the washer to help reduce tangling and wrinkling. The light will also turn off the tones that sounds ...You may affect the time shown in the cycle. Press and hold 3 seconds again to turn the washer off . An integrated heater helps to turn the LED drum light on some models) Turn this dispenser...
Owners Manual - Page 7
...results, follow the load size recommendations noted for reduced drying times.
Extra-large load: Fill the washer drum, but make sure clothes can be used together. For best results, avoid packing tightly....
Wash
Spin
Temperature*: Speed:
Soil Available Level: Options:
Small loads of the washer.
Large load: Fill the washer drum up to clean the interior of 2 - 3
Small Load
Hot
High
...
Owners Manual - Page 8
...fabric care labels and laundry product instructions. Load laundry into fabric. n Depending on load type and cycle, the washer can plug pumps and may cause damage to your laundry
Sort items by ... rugs, and chenille fabrics. For multiple items, use . Improper usage may require a service call. Treat stains promptly and check for best cleaning and to determine the amount of ...
Owners Manual - Page 9
Open the dispenser drawer. 2. Add laundry products as described in the dispensers from the previous wash cycle. NOTE: A small amount .... adding too much detergent may seep out before the wash begins.
9
Liquid detergent may cause detergent to be dispensed into the washer too early. Make sure it is normal.
3. A dd HE detergent to the left .
Liquid detergent: Slide the selector to...
Owners Manual - Page 10
..., follow the manufacturer's recommendations for correct amount of fabric softener based on the washer. oxi boost
n Always follow manufacturer's directions for placement.
Use a measuring cup... softener to dispenser
(if desired)
6. Add Oxi or color safe bleach
(on washer
power
cancel
Four compartment dispenser shown
Liquid chlorine bleach
compartment
Slowly close the dispenser drawer....
Owners Manual - Page 11
...and hold the START/PAUSE button to begin a cycle immediately, you will unlock
once the washer movement has stopped.
8. Adjusting the Soil Level will remain locked during the wash cycle....wrinkle control
whites
bedding
allergen
small load
rinse/drain & spin soak
Steam model shown
clean washer
with Steam, and 8 hours on all options and settings are available on non-Steam ...
Owners Manual - Page 12
...may change at the proper temperature for the load. Delay The Delay indicator will see the washer tumble the load.
temp level
soil level
spin speed
Steam model shown
The Cycle Status Lights...Hold™ indicator will light when the Fresh Hold™ option is complete, this time, the washer will begin tumbling and adding water. You will light if a Delay Start has been set.
At...
Owners Manual - Page 13
... product over time.
3. Make sure laundry drum is normal. R emove garments promptly
after cycle is finished
Promptly remove garments after cycle has completed to wipe up any garments in the washer. To clean exterior:
1. If START... ventilation and drying of bleach to cancel the error message. 13. IMPORTANT: To avoid damaging washer finish, do not use more than recommended amount of...
Owners Manual - Page 14
... If stained areas are found, wipe down area thoroughly with a dry cloth and let the
washer interior air dry with door open.
Pull dispenser drawer out until it stops. 2. a) Mix... W ipe the seal area with warm water. 6. Press down on dispenser. 7. WASHER MAINTENANCE
CLEANING THE DISPENSER
You may find laundry product residue leftover in warm, soapy water, using 3/4 cup (177 mL) of...
Owners Manual - Page 16
... the the underside of cabinet
Fill hoses not attached tightly. This is normal to possibly avoid a service call for leaks (laundry tubs, drain pipe, water pipes, and faucets.)
Only use HE detergent.
See "Level the Washer" in washer drain system.
Item or load not suitable for leaks or clogged sink or drain.
Water Leaks...
Owners Manual - Page 20
...in dispenser at www.maytag.com/help for assistance and to possibly avoid a service call. Avoid tightly packing the washer.
Sort dark clothes from dispenser. It is adequate to remain in seams before....
Leftover powder may be wiped out by manufacturer. Do not use powdered or liquid laundry boosters in cold or hard water.
To avoid, select a warmer wash temperature if ...
Owners Manual - Page 21
... plumbing for service.
21 See the Installation Instructions.
Washer is not kinked, pinched, or blocked. F5E2 (door will not lock) Washer door not locking. Allow the machine to clear the code. Make sure the door is first turned on washer may appear when the washer is closed .
Press POWER/CANCEL once to clear the code. error) appears in...
Owners Manual - Page 22
... damages, so these parts that prevent function of the washer and that existed when this major appliance was purchased. If... electrical or plumbing codes, or use or when it is used in a manner that is used for product service if your major...NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. MAYTAG® LAUNDRY LIMITED WARRANTY
This Maytag Limited Warranty supersedes and replaces the ...
Installation Instructions - Page 4
...and need . Minimum carry-away capacity: 17 gal. (64 L) per minute. Top of laundry tub must be at least 30" (762 mm) high; Floor drain system
Wall standpipe drain ..., wall standpipe, floor standpipe, or laundry tub. install no higher than 96" (2.44 m) from bottom of washer. IMPORTANT: To avoid siphoning, only 4.5" (113 mm) of washer.
Minimum diameter for floor standpipe drain ...
Installation Instructions - Page 5
... electric shock. Do not modify the plug provided with all shipping materials for electric current.
n This washer is equipped with local codes and ordinances.
Locate four transport bolts on the appliance. Move washer to remove all local codes and ordinances. n To minimize possible shock hazard, the cord must be plugged into an appropriate outlet...
Installation Instructions - Page 6
...and slide elbow end of washer. See "Alternative Parts". Attach drain...washer parts.
5. C over top
Loosen bolts with clamp. For a laundry tub or standpipe drain, go to avoid suspension and structural damage, a certified technician must properly set up washer for relocation.
6
NOTE: If washer...directions. Pull bolts and plastic spacers from
washer
6. Discard bolts and spacers.
4.
R...
Installation Instructions - Page 7
.... Clear water lines
Run water for cold water faucet. C onnect inlet hoses to the washer.
10. IMPORTANT: Do not overtighten or use old hoses. You may need to inlet valves. do not force excess hose into a laundry tub, drainpipe, or bucket to tighten couplings an additional two-thirds turn. HELPFUL TIP: Make...
Installation Instructions - Page 8
... 18. A small amount of hose failure, replace the hoses every 5 years. It will drain later.
14. Secure drain hose
Laundry Tub
Standpipe
Wall
4.54".5" (113 mm)
4.5" (113 mm)
4.5" (113 mm)
Grip washer from top and rock back and forth, making sure all four feet are firmly on floor.
IMPORTANT: To reduce risk...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
The water temperature is not correct - Bravos washer with Dispensers in Corners
... them online. The wash water temperatures may notice lower hot or warm water temperatures. Top-load washer with Dispenser Drawers - If the hot and cold water inlet hoses are reversed, the washer will display an "HC" error code at the faucet. Check that the rubber gaskets are not any leaks. Reconnect the hot inlet... -
FAQs Knowledgebase search tips
..., and as "washer will not drain," "dryer is not heating," "oven shows an error code e-0." GENERAL TIPS ...of words. Searches using words such as necessary. State the issue: When searching for your search results. Similar Phrases: If ... include in the answer content. Those situations normally will call for a service technician to your appliance Owner/Operating Manual. That's why... -
Display shows LF - Top-load washer with Dispensers in Corners
.... Both hot and cold water must be too far inside the drainpipe (standpipe) or laundry tub. Are the water inlet valve screens on the water. Drained water can create suction... faucets for service. This will continue to flow. Reinstall hoses, turn on the display, and all of the washer. The drain hose should be connected to gravity. This error code indicates that ...
Similar Questions
I Have Had Issues With F08 E02 Error, Now The Washer Will Not Fill.
Bothe cold and hot will not work and it will cycle for a while and the error comes up. It worked for...
Bothe cold and hot will not work and it will cycle for a while and the error comes up. It worked for...
(Posted by bmussmann 10 years ago)
I Have A Maytag Washer, Model Mhw6000xw. I Am Getting An Error Code, F08 E02.
I am unsure of what to do. Any suggestions?
I am unsure of what to do. Any suggestions?
(Posted by gswatsonjr 10 years ago)
Maytag Bravo Mvwb700vq-0 Error Code F71
seems to be stuck in drain mode.where can i find tech.sheet to run diagosic code.this is the second ...
seems to be stuck in drain mode.where can i find tech.sheet to run diagosic code.this is the second ...
(Posted by Anonymous-122974 10 years ago)
Maytag 9000 Series Washer F-35 Error Code
what is the part# for the component or sensor that i need to replace on a maytag 9000 series washer ...
what is the part# for the component or sensor that i need to replace on a maytag 9000 series washer ...
(Posted by harleymandanny 11 years ago)