Maytag MHW3000BW Support Question
Maytag MHW3000BW Support Question
Find answers below for this question about Maytag MHW3000BW.Need a Maytag MHW3000BW manual? We have 5 online manuals for this item!
Question posted by Sandydudley on July 20th, 2016
Maytag Pedestals
What pedestals do I need to go with the series 3000 washer and dryer
Current Answers
Answer #1: Posted by Odin on July 20th, 2016 6:38 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
There is a choice of two pedestals and a stacking kit for this washer at https://www.ajmadison.com/cgi-bin/ajmadison/MHW3000BW.html.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MHW3000BW Manual Pages
Dimension Guide - Page 2
...: 28" (710 mm) from bottom of washer. Specifications subject to have an overhead sewer and need . If a mating outlet is not available,...washer. (Additional hoses may be plugged into a mating, 3 prong, grounding-type outlet, grounded in the neutral or ground circuit. Always secure drain hose with a power supply cord having a 3 prong grounding plug. Floor standpipe drain system
Laundry...
Installation Guide - Page 2
Tools needed : (Not supplied with washer)
Water inlet hoses (2)
Flat inlet hose washers (4)
Drain hose with washer) Your installation may be shipped unassembled)
Available Accessories: An optional matching pedestal is available for ordering information, or see the "Assistance or Service" page on the back page of your "Use and Care Guide". To order, please ...
Installation Guide - Page 3
...IMPORTANT: Do not install, store or operate washer where it will need:
n A water heater set to reduce noise transfer. Space must support washer's total weight (with maximum slope of 315 ... located within 6 ft (1.8 m) of 20-100 psi (137.9-689.6 kPa).
Recessed area or closet installation (stacked washer and dryer):
6" (152 mm)
3" (76 mm)
76.5" (1943 mm)
48 in.2 (310 cm2)
5" (127 mm...
Installation Guide - Page 4
..., wall standpipe, floor standpipe, or laundry tub. A 1/4" (6 mm) diameter to pump higher than 96" (2.44 m), a sump pump and associated hardware are needed .) Always secure drain hose with cable...(710 mm) from bottom of washer. (Additional hoses may be needed .
install no higher than 96" (2.44 m) from bottom of washer. See "Alternate Parts". If you need to 1" (25 mm) diameter ...
Installation Guide - Page 6
...end of hole. See "Alternate Parts". IMPORTANT: Do not plug washer in rear panel and close hole with washer parts.
5.
For a laundry tub or standpipe drain, go to avoid suspension and structural damage...it over top of washer to allow free access to back of washer. You may need additional parts with a 1/2" (13 mm) wrench. R emove transport bolts from back of washer. Attach drain hose to...
Installation Guide - Page 7
...12. Do not use old hoses. do not force excess hose into standpipe or lay on washer. Drain hose form must be used.
Clear water lines
Run water for the cold water ...Coupling
B. IMPORTANT: Only 4.5" (114 mm) of laundry tub. You may need to avoid clogs. C onnect inlet hoses to water
faucets
4.5" (114 mm)
Place hose into a laundry tub, drainpipe, or bucket to remove the drain...
Installation Guide - Page 8
....
16. Place a level on floor. A small amount of hose failure, replace the hoses every 5 years. Secure drain hose
Laundry Tub
Standpipe
Wall
4.54".5" (114 mm)
4.5" (114 mm)
4.5" (1143 mm)
Grip washer from beneath washer.
Use pliers to tighten couplings an additional two-thirds turn on valve when attaching to side.
Record hose installation...
Installation Guide - Page 9
... contact with a wood block or similar object that will support weight of washer. 18. Adjust leveling feet
WARNING
Jam nut
If washer is level and all parts are about 4" (102 mm) with the floor. Repeat as needed. q Check that transport materials were completely
removed from console and any tape
remaining on feet until...
Use & Care Guide - Page 3
... provides a convenient working height. ACCESSORIES
Customize your dealer, call 1-800-807-6777, or visit: www.maytag.ca.
15" Pedestal Color-matched pedestals raise the washer and dryer to be installed on options and ordering, contact your new washer and dryer with the following genuine Maytag accessories. Stack Kit If space is at 1-800-901-2042, or visit: www...
Use & Care Guide - Page 4
..., use the Soil Level setting to add a garment, you can be displayed, followed by up and the Estimated Cycle Time will leave
your laundry load.
Spin Speed This washer automatically selects the spin speed based on and off Delay Start, use this preset soil level. Turn the knob to pause it. Factors...
Use & Care Guide - Page 6
... the door, and add items.
Done
Once the cycle is locked and cannot be displayed.
The Done indicator is
completely closed. Add laundry products as when the washer is sensed, the estimated time based on . Slowly close the dispenser drawer. Adding HE detergent to be lengthened;
IMPORTANT:
n Do not add single-dose...
Use & Care Guide - Page 7
...Spin™ Extra Rinse Delay Start
Wet load of clothes
Drain & Spin
Swimwear, items that need rinsing
Drain & Spin
with 3-4 items, not more than 1/4 full.
For best results, avoid... low-speed spin for gentle fabric care and reduced wrinkling. See "Washer Care." See "Washer Care" in the washer during the Clean Washer with affresh® cycle. then select Extra Rinse to about 3/4 full...
Use & Care Guide - Page 9
...n Mend rips and tears to avoid further damage to your laundry
Single-dose laundry packet, Oxi-type boosters, color-safe bleach, or fabric softener crystals can set stains into washer
Sort items by recommended cycle, water temperature, and colorfastness.
Improper... loosely in mesh garment bags. Use only HE detergent. Items need to prevent pilling. n Wash small items in the washer.
Use & Care Guide - Page 14
...process has been completed. Clean Washer Cycle Cancellation Procedure: 1. Use an all-purpose surface cleaner, if needed.
Occasionally wipe the outside of your washer, you may take up to... repeat the Clean
Washer cycle or to wash laundry using your washer to adequately rinse any remaining chemistry. Slide cover panel back
onto posts on the washer once. 2. The washer will begin to ...
Use & Care Guide - Page 17
...normal for leaks (laundry tubs, drain pipe, water pipes, and faucets.)
Only use HE detergent.
Water Leaks
Check the following for flexing or sagging. Fill hose washers. Washer not performing as ...unlocking.
Loose items such as final amounts of water are This is normal at www.maytag.com/product_help - balancing the load.
Check household plumbing for optimal cleaning.
17 Water...
Use & Care Guide - Page 19
...or visit our website at end of the drain hose more detergent. After 3 wash cycles in the washer. Select DRAIN & SPIN to inlet valve. or rinse temperatures
If the "Add a Garment" light...garment bags when washing small items.
Door locked at www.maytag.com/product_help - In Canada www.maytag.ca for proper installation. The hose needs an air gap. Use the recommended cycle/speed spin for ...
Use & Care Guide - Page 20
... loaded as recommended. The wash water was not warm enough to reduce wrinkling. Items need to unload the washer at www.maytag.com/product_help - Add only 1 or 2 garments after washer has started . See the "Cycle Guide" for the available settings and options for load, use the Fresh Spin™ option if you experience
Possible...
Use & Care Guide - Page 22
... loads. This extends the cycle time. This ensures a gentle wash for assistance and to remain in dispenser at www.maytag.com/product_help - Adding laundry packet incorrectly. The options you experience
Possible Causes
Washer not performing as a rug or jeans jacket with low water pressure may be increased.
When excessive suds are washed in...
Use & Care Guide - Page 23
...; LAUNDRY LIMITED WARRANTY
This Maytag Limited Warranty supersedes and replaces the limited warranty printed in these limitations and exclusions may not apply to you. Some states and provinces do not allow the exclusion or limitation of incidental or consequential damages, so these parts that prevent function of the washer and that is used...
Warranty Information - Page 1
...in a remote area where service by Maytag.
5. The removal and reinstallation of the washer and that existed when this major ...and delivery. MAYTAG SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. MAYTAG® LAUNDRY LIMITED WARRANTY
This Maytag Limited Warranty ...service under this limitation may not apply to you need repair service, first see the "Troubleshooting" section...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Vibration - Front-load washer
... a pedestal, all four of the feet should be in the floor from being damaged during spin. Modern washers have your product model number in firm contact with the floor . adjust the feet if the washer teeters. The lock nuts on all four washer feet need to the washer installation, always check the... -
Washer is not cleaning laundry - Top-load HE washer with Dispensers in Corners
... and composition through a series of a cycle only. Sort loads before starting the washer. Dilute fabric softener and add to find it stops. Use your water inlet hoses for the fabrics. Top-load HE washer with Dispensers in water? The following illustrates how your Bravos washer operates. Top-load washer Washer is not cleaning laundry. The water level... -
Purchasing compactor bags
... not solve my problem The answer needs updating and/or additional information The answer could be improved Thank you Not Helpful Helpful Answers others found helpful Removing and installing a compactor bag Terms of 3 Please tell us how we can make this answer more useful. | Laundry Overview Washers Dryers Accessories Refrigeration Refrigerators Freezers Cooking...
Similar Questions
Maytag 3000 Series Dryer
Dryer will come on but not start up. Was working fine then just didn't stay back up. The lights come...
Dryer will come on but not start up. Was working fine then just didn't stay back up. The lights come...
(Posted by Tinagardner39 8 years ago)
Washer Not Filling Water
got a brand new maytag maching 3 months ago, was working perfectly fine and suddenly the water is no...
got a brand new maytag maching 3 months ago, was working perfectly fine and suddenly the water is no...
(Posted by faizankhan 8 years ago)
Annoying Sounds On Maytag 3100 Series Washer Dryer Help!!
How do I turn off on/off beeps/chimes and noises on maytag mhw3100dw washer&dryer??
How do I turn off on/off beeps/chimes and noises on maytag mhw3100dw washer&dryer??
(Posted by Esthermillen7 9 years ago)
How To Install Washer Dryer Pedestals Neptune
(Posted by exdmrunc 9 years ago)
Maytag 3000 Washer. Showing E1 & F6. Trouble Starting New Load,
(Posted by Jbalger901 10 years ago)