Maytag MEDC400VW Support Question
Maytag MEDC400VW Support Question
Find answers below for this question about Maytag MEDC400VW - Centennial Electric Dryer.Need a Maytag MEDC400VW manual? We have 2 online manuals for this item!
Question posted by litjoh on January 23rd, 2014
Manual Maytag Medc400vw Centennial Commercial Technology Gas Dryer How To
remove front panel
Current Answers
Related Maytag MEDC400VW Manual Pages
Owners Manual - Page 1
... messages will follow instructions. DRYER USER INSTRUCTIONS
INSTRUCTIONS POUR L'UTILISATEUR DE LA SÉCHEUSE
Table of Contents
DRYER SAFETY 1 CONTROL PANEL 4 CYCLE GUIDE 5 DRYER USE 6 DRYER CARE 7 TROUBLESHOOTING 8 WARRANTY...provided many important safety messages in this manual and on the model and serial number label, located at the top inside dryer door well. You will tell you ...
Owners Manual - Page 2
IMPORTANT: The gas installation must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54. The dryer must conform with local codes, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70.
2
Owners Manual - Page 3
...appliance. • Do not touch any electrical switch; WHAT TO DO IF YOU SMELL GAS:
• Do not try to ...Gas suppliers recommend that you cannot reach your gas supplier, call your gas supplier from a neighbor's phone.
WARNING
Fire Hazard Use a heavy metal vent. Good
Better
■■ Remove lint and debris from the exhaust hood.
■■ Remove lint from the front the dryer...
Owners Manual - Page 4
...will run after your load. Opening the door will depend on your load. Temperature Tips If your dryer has multiple heat settings:
■■ A High heat setting may be used for rubber, ... time and enhances fabric care. WRINKLE PREVENT (on , the signal sounds every few minutes.
CONTROL PANEL
Not all features and options are unsure of the temperature to Off.
4 At the end of ...
Owners Manual - Page 5
... Dry Freshen Up Air Fluff SPECIAL SETTINGS Cool Down
Wrinkle Prevent
Most loads
This dryness level removes less moisture than the Energy Preferred cycle. Seams of certain cycles to complete drying on a...hanger.
Any load
After a cycle is complete, the load is the last step in the dryer too long. CYCLES SENSOR DRY or AUTOMATIC DRY
AUTOMATIC DRY High Heat AUTOMATIC DRY Low Heat...
Owners Manual - Page 6
... can result in death, explosion, or fire. WARNING: To reduce the risk of fire, electric shock, or injury to hang over the edge of the cycles and features described. Before using...remove oil. To stop your dryer, wipe the dryer drum with a damp cloth to the recommended setting for the type of the manual or contact the dealer from the dryer as soon as it to remove dust from dryer...
Owners Manual - Page 7
... place.
2. Wet a nylon brush with a clean towel. Tumble a load of clothes.
If you .
The exhaust hood is removed.
2. Pull the lint screen toward you have a gas dryer, close shutoff valve in the door of laundry in dryer. Do not rinse or wash screen to dry the drum. Thoroughly dry lint screen with hot water and...
Owners Manual - Page 8
... the dryer door. Remove the cover. Make sure leveling legs are secure in death or electrical shock.
1. http://www.maytag.com/help...dryer base. 4. Unplug dryer or disconnect power. 2.
Electric dryers use 2 household fuses or circuit breakers. Gas Dryers
1. Electric dryers require 240-volt power supply. Separate the load items and restart the dryer. Replace all parts and panels...
Owners Manual - Page 9
...the Installation Instructions.
■■ Is the exhaust vent diameter the correct size? Sides and front of dryer require a minimum of 1" (25 mm) of airspace, and the rear of lint or replace exhaust ...Drying? Lint on Automatic Cycles. Lint screen should be contacting the sensor strips. Run the dryer for the types of the door. The timer moves only when the clothing is not too...
Owners Manual - Page 10
... too hot
■■ Were laundry items removed from dryer. In Canada, call 1-800-901-2042, or visit us at the beginning of the cycle?
■■ Was the dryer overloaded? fits 29" (737 mm) Super Capacity, 6.5 cu. side swing door only
Drying rack - The new electric heating element may feel very warm.
10 These...
Owners Manual - Page 11
...book and your complete model number and serial number. The removal and reinstallation of your major appliance, to replace or ...MAYTAG® LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with electrical or plumbing codes, or use of products not approved by Maytag...
Installation Instructions - Page 1
... porte (facultatif 22 Achever l'installation 23
Para obtener acceso al manual de uso y cuidado en español, o para obtener información adicional acerca de su producto, visite: www.whirlpool.com. Tenga listo su número de modelo completo.
29" (73.7 CM) ELECTRIC DRYER INSTALLATION INSTRUCTIONS
INSTRUCTIONS POUR L'INSTALLATION DE LA SÉCHEUSE...
Installation Instructions - Page 2
... circuit. ■ If you purchased your local building inspector.
2 If using a power supply cord, a grounded electrical
outlet located within 2 ft (61 cm) of either side of 1" (2.5 cm) under entire dryer. (If slope is greater than 1" [2.5 cm], install Extended Dryer Feet Kit, Part Number 279810.) Clothes may not tumble properly and models with clothes...
Installation Instructions - Page 3
...-swing door C.
Connect to open fully.
closet or confined area C. Mobile home installations require:
■ Metal exhaust system hardware, which is suitable for this dryer. Electrical Requirements -
Small opening side-swing door D. Wide opening side-swing door B. Louvered doors with vents
3"* (7.6 cm)
*Required spacing
Mobile Home - Recessed area B.
The opening...
Installation Instructions - Page 4
... here. ■ If local codes do not use with a 4-wire electrical supply connection, the neutral ground wire must be removed from the external ground conductor screw (green screw), and secured under the neutral terminal (center or white wire) of the terminal block, the dryer cabinet is isolated from the neutral conductor.
■ A 4-wire...
Installation Instructions - Page 5
... Part Number 3394208. If you are using a replacement power supply cord, it will reduce the risk of electric shock by a qualified electrician. This dryer is 5 ft (1.52 m) in length. The plug must be grounded.
A copy of dryer's final location.
The cord is equipped with a cord having an equipmentgrounding conductor and a grounding plug. grounding...
Installation Instructions - Page 7
... with the dryer cabinet and be connecting to:
Go to "Optional 3-wire connection" section.
4-wire connection: Power Supply Cord
IMPORTANT: A 4-wire connection is required for your home has:
And you will be in a horizontal position. Hole below the terminal block opening , screw the removable conduit connector onto the strain relief threads. Electrical Connection...
Installation Instructions - Page 8
...bare ground wire at 5" (12.7 cm). Remove neutral ground wire from 3 remaining wires.
Direct wire cable must have completed your electrical connections. Shape ends of wires into slot of... the hooked end (hook facing right) of the neutral wire (white or center wire) of dryer rear panel. External ground conductor screw B. Center silver-colored terminal block screw C. A
B
C
E
4-wire...
Installation Instructions - Page 11
... elbows provide better airflow than 90° elbows.
If this dryer MUST BE
EXHAUSTED OUTDOORS. Louvered hood style B. IMPORTANT: Observe all.... Clamp
Exhaust Recommended hood styles are recommended. Do not use a metal foil vent.
■ Remove excess flexible metal vent to avoid crushing and kinking.
4" (10.2 cm) 4" (10.2 cm...gas vent, chimney, wall, ceiling or a concealed space of the...
Installation Instructions - Page 13
...Dryer
Check the levelness of the dryer (not the top or console panel).
If connecting to use a large, flat piece of cardboard from dryer packaging under the entire back side of the dryer.
2. The dryer vent must fit inside the dryer... that the vent is made, remove the corner
posts and cardboard.
... Move dryer into the leg holes by hand. Do not crush or kink vent. 3. (On gas models)...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Poor drying performance - Bravos® dryer
...;Bulky cycle will take a long time to dry slowly, so even if you change the temperature level on the Sensor cycles? Pillows. Gas dryer Damp loads or long drying times - dryer. What can I 'm experiencing poor drying performance with down, down filling. Electronic controls with digital display Loads are noted in fabrics... -
My dryer makes sounds or vibrations
...'t been used , the drum support rollers can roll into the dryer. Remove any objects caught in the seam. Remove objects from the top of a dryer running empty. Is there a clicking sound? (Gas dryers only) The gas valve clicking on . (8 seconds,130 KB) Has the dryer had a period of a flattened roller. ( 8 seconds, 130 KB) Is... -
Loads are damp; dryer does not dry
... links for 5 seconds. The dryer will beep, and "CF" will flash. Press Start to your loads on all Sensor Dry cycles. Dryer Poor drying performance - the dryer does not dry. Dryer Dryer does not heat - NOTE: Changing this mode. There are damp; Electric Dryer Dryer does not heat - Dryer does not heat - Gas dryer Damp loads or long drying...
Similar Questions
Is Maytag Mgdc400vw - Centennial 29' Gas Dryer Energy Star Efficient?
Is Maytag MGDC400VW - Centennial 29" Gas Dryer Energy Star efficient?
Is Maytag MGDC400VW - Centennial 29" Gas Dryer Energy Star efficient?
(Posted by polinabess 8 years ago)
Light Wont Come On In Maytag Centennial Commercial Technology Dryer Medc400vw0
(Posted by fcctechd 10 years ago)
Maytag Centennial Commercial Technology Dryer Will Not Dry On Time Cycle
(Posted by coursewin 10 years ago)
How Hot Does A Maytag Centennial Commercial Technology Dryer Get?
(Posted by Jfel2Dust 10 years ago)
Neptune Gas Dryer Blinking Pf1. Warning?
Can't find my manual. The Neptune gas dryer was blinking PF1 where the time left would normally sh...
Can't find my manual. The Neptune gas dryer was blinking PF1 where the time left would normally sh...
(Posted by smferg9229 12 years ago)