Maytag MEDC200XW Support Question
Maytag MEDC200XW Support Question
Find answers below for this question about Maytag MEDC200XW.Need a Maytag MEDC200XW manual? We have 2 online manuals for this item!
Question posted by madkis8333 on June 18th, 2013
Dryer Not Drying.
Dryer will run for 1/2 hour and then shuts off.
Clothing is humid and wet
Current Answers
Related Maytag MEDC200XW Manual Pages
Owners Manual - Page 2
DRYER SAFETY
2
Owners Manual - Page 4
...Timed Dry, the dryer runs the amount of time set and sometimes results in shrinkage, wrinkling, and static due to the dryer ...DRY/Automatic Dry cycles to efficiently dry laundry.
This sensing occurs throughout the drying cycle and the dryer shuts off when the load reaches the selected dryness. each load. Use Timed Dry for final product check. During SENSOR DRY/Automatic Dry cycles, drying...
Owners Manual - Page 5
... or air temperature and shuts off when the load reaches the selected dryness level. Drying time will depend on the fabrics in the cycle selections. Promptly removing clothes at the end of Cycle signal is also selected.
2 TEMPERATURE / FABRIC Select a drying temperature based on your load. TIMED DRY Will run after your dryer. Drying time and temperature will...
Owners Manual - Page 6
...run the dryer for foam, rubber, plastic, or heat-sensitive fabrics.
Use the Air Fluff (no heat) setting for the specified time on all models. Drying time varies based on all models. Items to dry: Jeans, heavy work clothes, towels
Work clothes... in the load or air temperature and shuts off when the load reaches the selected dryness level. Items to dry:
Heavy or bulky items Any load
Cycle...
Owners Manual - Page 7
....
1. Place laundry in the dryer. Close the door. Some models have a different door than the one shown. Load the dryer
Clean the lint screen before operating this dryer.
USING YOUR DRYER
WARNING: To reduce the risk of its holder.
Do not rinse or wash screen to tumble freely.
7 For additional cleaning information, see "Dryer Care". clothes should...
Owners Manual - Page 8
... dryness level, depending on a hanger to the desired position or select the Automatic Dry Cycle that has the temperature included in the shortest time. Energy Preferred is used for more load moisture. Promptly removing clothes at which the dryer will shut off.
3. Select the desired cycle
5. NOTE: Not all options and settings are available...
Owners Manual - Page 9
... cloth until stain is hard to a residue buildup. Doing so can cause longer drying times for proper dryer operation. n If lint falls off the screen with hot water. 3. This buildup can cause overheating and damage to avoid drum staining. This includes clearing piles of laundry in the dryer. A screen blocked by a qualified servicer. To wash: 1. Wet...
Owners Manual - Page 10
....
3. If you are secure in gas supply line. 3. For gas dryers: 1. Clean lint screen. Close shut-off valve to gas supply
line. 3.
Cap the open fuel supply line. 5. Unplug dryer or disconnect power. 2. (For gas dryers only): Close shut-off valve in dryer base. 4. Use tape to secure dryer door. Turn off power at home.
Open the...
Owners Manual - Page 11
...
Clothes are not drying satisfactorily, drying times are not installed, or the dryer is not level front to back and side to possibly avoid the cost of garments being dried.... the dryer to tumble freely.
Dryer will not run
Door not closed completely.
Unusual sounds
Dryer had a period of operation. If the dryer hasn't been used for 5-10 minutes. Electric dryers require...
Owners Manual - Page 12
... cycle.
Odors
You have an odor. Laundry items were removed from dryer.
These cycles sense the temperature or the moisture level in clothing (usually blue jeans). Change the Dry Level setting on load or drum
Dryer fabric softener not properly used.
Add dryer fabric softener sheets at the end of drying time in the area where your...
Installation Instructions - Page 2
... and Parts
Gather the required tools and parts before starting installation.
We have provided many important safety messages in this manual and on your appliance. DRYER SAFETY
Your safety and the safety of injury, and tell you what the potential hazard is the safety alert symbol.
All safety messages will follow...
Installation Instructions - Page 3
...marked for proper exhaust installation.
Drying times can be large enough to allow the dryer door to open fully.
...clothes may not tumble properly and automatic sensor cycles may not operate correctly.
The combined weight of a companion appliance should contain:
■■ A UL listed 30-amp power supply cord, rated 120/240 volt minimum. At lower temperatures, the dryer might not shut...
Installation Instructions - Page 4
... and secured under the neutral terminal (center or white wire) of the terminal block, the dryer cabinet is available for mobile home installations. A time-delay fuse or circuit breaker is prohibited.... cord.
■■ If codes permit and a separate ground wire is used when the dryer is manufactured ready to reduce noise transfer.
■■ For closet installation, with elbow. ...
Installation Instructions - Page 5
... to connect the exhaust vent.
5
place under entire back edge of cardboard from dryer carton; The cord should contain:
■■ A UL listed 30-amp power...or nonmetallic sheathed copper cable (with ground wire), covered with clothes dryers. Firmly grasp dryer body (not console panel) and gently lay dryer down on its final location. Leave enough room for electrical...
Installation Instructions - Page 7
... not further tighten strain relief screws at this page. For 4 wire Power Supply Cord Connection, continue to hold in a horizontal position. Spade terminals with the dryer cabinet and be in place.
Attach power supply cord
A
to connect neutral
ground wire and neutral wire.
2. Remove neutral ground wire (E) from a 3/4" (19 mm) UL...
Installation Instructions - Page 8
... with hold -down screw.
Remove center screw
B
Connect remaining wires to outer terminal block screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Now, go to Venting Requirements. Tighten screw.
6. Connect neutral wire
BC
Connect neutral wire (white or center) (C) of power supply cord to center...
Installation Instructions - Page 12
...foil vents with lint.
Housecleaning problems and health problems.
See "Venting Kits" for best drying performance and to collect indoors, which may obstruct exhaust (such as flowers, rocks, ...9632;■ Must be fully extended and supported in final dryer location. ■■ Remove excess to achieve best drying performance. Review Vent system chart and if necessary, modify...
Installation Instructions - Page 14
...12" min. (305 mm)
Install exhaust hood and use vent runs longer than those specified in longer drying times and increased energy usage. Terminate the exhaust vent outside. ...Rigid metal 27 ft. (8.2 m) 21 ft. (6.4 m)
Vent must not terminate beneath the mobile home. Run vent to dryer location using elbows or making turns, allow as much room
as possible. Avoid 90° turns. Do not ...
Installation Instructions - Page 15
...
1.
Complete Installation Checklist q Check that vent is secured to exhaust hood with a damp cloth to existing vent, make sure all packaging materials.
After dryer is clean.
If there is not crushed
or kinked. For direct wire installation, turn on dryer. q Check that you have all parts are snug against the ground before tightening...
Installation Instructions - Page 16
... in cabinet are intact and tight, or that both circuit breakers have not tripped. q When the dryer has been running for 5 minutes, open the dryer door and feel for the dryer. If you do not remove) top screws from dryer cabinet.
4.
If there is helpful. NOTE: You may be 2 household fuses or circuit breakers for...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
No or low ice production - Bottom freezer/French door refrigerator
... refrigerator has just been installed, allow 24 hours for 24 hours, make sure the ice maker is not jammed in the ... ejector arm or the bail arm of high household water consumption (laundry, dishwasher, etc.) can reduce water flow. Straighten the water ...system is not being produced? If the ice maker has been running for full ice production to refill after heavy use a &#... -
My dryer makes sounds or vibrations
...and may be tumbling in the dryer. This ball of a dryer running empty. Front-load washer You can make the dryer shake or vibrate. Use a dry rack when drying tennis shoes. Are you hearing ...the cycle. Normal dryer sounds: The following are normal sounds of a flattened roller. ( 8 seconds, 130 KB) Is the load knotted or balled up . Laundry items with large ... -
Damaged clothing - Top-load HE washer with Dispensers in Corners
...nbsp;This cycle starts with a soak to thoroughly saturate your large load. This is not cleaning laundry - Loose strings may tangle with other load items. Loads are washing loads of garment, such as... when the Add A Garment or Add Clothes light is on top of garments, evenly around the basket wall. Do not let bleach splash, drip, or run down into the washer basket. Always measure...
Similar Questions
Which Dryer Vent Kit Do I Need For Maytag Model Medc200xw
(Posted by gefvla 10 years ago)
Maytag Centennial Commercial Dryer Runs But Does Not Heat
(Posted by msullAsh 10 years ago)
Our Maytage Medc200xw Dryer Will Heat But The Drum Is Not Turning. Please Help
(Posted by sullivanm 12 years ago)