Makita XAD01Z Support Question
Makita XAD01Z Support Question
Find answers below for this question about Makita XAD01Z.Need a Makita XAD01Z manual? We have 1 online manual for this item!
Question posted by vlsconstructionservices on April 10th, 2015
I Want To Swap Keyed Chuck With Keyless
How do i swap keyed drill chuck with a keyless
Current Answers
Answer #1: Posted by sabrie on April 10th, 2015 10:19 PM
sabrie
Member since:
May 23rd, 2013 Points: 3,306,778
Member since:
May 23rd, 2013 Points: 3,306,778
the video on the link below will give you full instructions on how to change a keyed chuck to key less.
www.techboss.co.za
Related Makita XAD01Z Manual Pages
Owners Manual - Page 2
... reduce personal injuries. 12. Do not use a ground fault circuit interrupter (GFCI) protected supply. Use personal protective equipment. A wrench or a key left attached to a rotating part of inattention while operating power tools may result in explosive
atmospheres, such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for...
Owners Manual - Page 3
...tool before use , keep it away from other metal objects, like paper clips, coins, keys, nails, screws or other condition that can cause personal injury.
2. Power tool use and care 24. Any power tool...Maintain power tools. Many accidents are dangerous in a hazardous situation. Use of the power tool is below when using only identical replacement parts. GEB051-2
CORDLESS DRILL SAFETY ...
Owners Manual - Page 4
... the battery cartridge.
• To remove the battery cartridge, slide it from the tool while sliding the button on (1) battery charger, (2) battery, and (3) product using battery...not incinerate the battery cartridge even if it is completely worn out. SAVE THESE INSTRUCTIONS. Tips for tool. ･ volts
･ direct current
･ no load speed
･ revolutions or reciprocation ...
Owners Manual - Page 5
...placed under one of light
directly. In this situation, release the trigger switch on the tool and stop after the switch trigger is operated in a manner that the switch trigger ...Do not look in the neutral position, the switch trigger cannot be pulled.
5
B
A
014176
This tool has a reversing switch to the "OFF" position when released. When the reversing switch lever is increased...
Owners Manual - Page 6
... on either side of the three holes and tighten clockwise. After use, return the chuck key to the storage cavity on the tool.
014175
Drilling operation Drilling in the chuck as far as it to the convex portion of the tool housing on the tool securely.
Screw
014178
CAUTION: • Always be sure that the side grip is...
Owners Manual - Page 7
... workmanship and materials for 15 minutes before proceeding with your local Makita Service Center. • Drill bits • Chuck key • Chuck key holder • Hook • Plastic carrying case • Various type of normal wear and tear: the tool has been abused, misused or improperly maintained: alterations have other rights which should be performed by...
Similar Questions
How Do You Remove The Chuck And End Bearing From The Gear On A Makita 6408 Drill
(Posted by icemannusa1 9 years ago)
How To Replace Chuck On Makita Drill Model Hp 2050
(Posted by Anonymous-149497 9 years ago)
Tool Not Working
I bought a new makita LXPH01 Hammer Drill. I put a fully charged lit-ion battery 3.0a but when I pr...
I bought a new makita LXPH01 Hammer Drill. I put a fully charged lit-ion battery 3.0a but when I pr...
(Posted by shiki98 11 years ago)