Makita MAC2400 Support Question
Makita MAC2400 Support Question
Find answers below for this question about Makita MAC2400.Need a Makita MAC2400 manual? We have 2 online manuals for this item!
Question posted by dclombard on January 29th, 2016
Air Receivers Drain Plug
Where is the "AIR RECEIVERS DRAIN PLUG?" Initial start up instructions state to open and run for twenty minutes.
Current Answers
Answer #1: Posted by Odin on January 29th, 2016 12:07 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
The instructions in the manual refer to the "air receiver's drain valve." That's located at the bottom of the air tank.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Makita MAC2400 Manual Pages
Owners Manual - Page 1
... Listed
MAC2400 2.5 4.8 4.2
100 PSI 130 PSI 51 mm 44 mm
120 1720 12.3 4.2 Gallon Yes
Minimum Circuit Requirement: 15 AMPS *A circuit breaker is operated on. Use only a fuse or circuit breaker that is the same rating as the branch circuit the air compressor is preferred.
Read the Safety Guidelines and ALL instructions carefully...
Owners Manual - Page 2
... ON-RECEIPT INSPECTION 7 STORAGE 8 DESCRIPTION OF OPERATION 8 INSTALLATION and BREAK-IN PROCEDURES 9
Location Of the Air Compressor 9 Lubrication and Oil 9 Initial Start Up Procedure 10 Extension Cords 10 Piping 10 Grounding Instruction 10 OPERATING PROCEDURES 11 Daily Start-up Checklist 11 MAINTENANCE 12 Filling with Oil 12 Changing the Oil 12 ROUTINE MAINTENANCE SCHEDULE 12...
Owners Manual - Page 3
....
• Do not operate the product when fatigued or under the influence of all persons, pets, and obstacles.
• Keep children away from the air compressor at all instructions and warnings in this manual.
• Become familiar with missing, broken, or unauthorized parts. Stay alert at all times.
• Never defeat the...
Owners Manual - Page 4
...VIOLENT TANK EXPLOSION RESULTING IN SERIOUS INJURY TO YOU OR OTHERS: • Failure to properly
drain condensed water from the tank, causing rust and thinning of the tank wall. • ... the equipment manufacturers recommendation and never exceed the maximum allowable pressure rating of air tools, spray guns, air operated accessories, tires AND other inflatables can cause them to explode or fly...
Owners Manual - Page 5
... TO PREVENT IT
• Your air compressor is normal for breathing.
Work in a secure location away from compressor.
• The compressed air from your compressor is connected provides proper... starts or stops.
It is powered by qualified service personnel or a licensed electrician, in accordance with good cross ventilation.
• Read and follow the safety instructions provided...
Owners Manual - Page 6
...as the compressor head or outlet tubes could result in , you
from Compressed Air
The compressed air stream can cause soft tissue damage, and can
• Never operate the
expose... Risk from the tank and any
attempt repair or
attachments before attempting maintenance, attaching tools or accessories. plugged in a serious skin burn.
• Never touch hot components during or immediately ...
Owners Manual - Page 7
... should be used where applicable.
GLOSSARY
CFM: Cubic feet per minute; When oil is carefully tested and checked before the motor automatically shuts off , air tank pressure drops as you long, trouble-free life. protecting your air compressor, it will restart automatically re-started is undersized for these applications.
ON-RECEIPT
INSPECTION
DAMAGE: Each...
Owners Manual - Page 8
... operating, the check valve is used to drain condensation at the air outlet. Review the "Maintenance" and
"Operating Procedures" sections and perform maintenance as being stepped on or run over).
OFF SWITCH: Turn this switch to "on the side of the air tank and is "open", allowing compressed air to cool before pushing the reset button...
Owners Manual - Page 9
...flow of each particular
accessory, the outlet regulated air pressure may have to allow for proper installation. Follow the instructions packaged with oil and broken in a clean... air compressor. Turn the knob clockwise to increase pressure and counterclockwise to closely follow initial start-up procedures. INSTALLATION AND
BREAK-IN
PROCEDURES
LOCATION OF THE AIR COMPRESSOR Locate the air...
Owners Manual - Page 10
..., and to factory testing and does not mean the pump contains oil. Use air compressor oil only. Initial Start Up Procedure: 1.Open the air receiver's drain
valve. 2.Plug power supply cord into
correct power source. 3.Run the compressor for air distribution lines. Low voltage can burst from air pressure.
If a pipe line is necessary, use the next larger size. Apply pressure...
Owners Manual - Page 11
...air pressure. OPERATING
PROCEDURES
Daily Start-up Checklist 1. Turn the pressure switch lever to "ON/AUTO" and allow tank pressure to "OFF". 7. Open the regulator by opening drain cock valve on bottom of damage. After the water has been drained, close the drain...have the same configuration as the plug. Remove the air tool or accessory. 9. DO NOT USE AN ADAPTER. The ...
Owners Manual - Page 12
... to a unit in a normal working environment.
Changing the Oil: Note: Every 300 hours or 3 months, whichever comes first. 1.Remove the oil drain plug. PERSONAL INJURIES CAN OCCUR. Drain water from the air tank, any unusual noise and/or vibration.
3. The modifications will require a greater frequency of the sight glass.
BEFORE PERFORMING ANY MAINTENANCE OR...
Owners Manual - Page 13
... or speed. 2. Replace the pressure release tube and fitting. 9. SERVICE
INSTRUCTIONS
Air Filter - The motor must be sure it is clean. • If..., CAUSING AIR TANK RUPTURE OR AN EXPLOSION.
Allow oil to drain completely. 2.Replace the oil drain plug (The
use the compressor, check the air filter to...started and is running. The check valve may be suspected when: 1. Fuses blow out...
Owners Manual - Page 14
....
• Adjust or replace pressure switch.
A defective check valve results in a constant air leak at the pressure release valve where there is a pressure in the pressure release valve... RUPTURE OR EXPLODE.
PRIOR TO ATTEMPTING ANY REPAIRS, UNPLUG THE COMPRESSOR
AND BLEED OFF TANK AIR PRESSURE. PROBLEM CAUSE
Excessive tank pressure safety valve pops off , unplug. Improper wiring. If...
Owners Manual - Page 15
... . If valve still leaks, it is not plugged in.
• Hole in hose.
• Check valve restricted.
• Air leaks.
• Decrease amount of air.
Do not operate the air compressor in " pressure of pressure drop when the accessory is used, adjust the regulator following the instructions. Page 15 safety valve.
PROBLEM CAUSE
Pressure reading...
Owners Manual - Page 16
... pressure.
Page 16 Regulator will not run. (con't)
• Check valve is stuck open , replace it.
Regulator knob has continuous air leak. Do not operate the compressor ... Warranty Service Center. If necessary, reset circuit breaker.
Replace regulator. if the valve does not open .
• Loose electrical connections.
• Possible defective capacitor.
• Paint spray on...
Owners Manual - Page 17
...West Allis, WI 53227 (414) 541-4776
Customer Record
When you need service: Send complete tool (prepaid) to one of the Makita Factory Service Centers listed, or to the outside of the carton detailing ...the problem with your tool. Date Purchased Dealer's Name and Address
Model No. Decatur Boulevard Suites 22-24 Las Vegas,...
Owners Manual - Page 18
..., and • arsenic and chromium from chemically-treated lumber. MAKITA LIMITED ONE YEAR WARRANTY
Warranty Policy
Every Makita tool is caused by others;
• repairs are specially designed to state.
Some states do this one year period, return the COMPLETE tool, freight prepaid, to one of original purchase.
To reduce your exposure to the...
Owners Manual - Page 19
...MONTH
DAY
YEAR
INTL. Any comments:
3. STATUS Married Single
SEX M F
STREET ADDRESS CITY
STATE
ZIP CODE
PHONE
AREA CODE
AGE: Under 19
20-29
30-39
40-49
50-59
Over... was purchased from:
Home Center
Other (
Hardware/Lumber Store
Tool Distributor
Industrial Supply
Construction Supply
2.Use of the product is intended for:
Construction Trade
Industrial Maintenance
Home Maintenance
...
Parts Breakdown - Page 1
...
PB-MKTA-072605
www.makita.com Makita Air Compressor Part Breakdown - MODEL MAC2400
Item Description
Part #
Qty Item Description
...draining plug 33 Motor cover 34 Motor / crankcase cover bolt 35 Air filter assembly 36 Oil filler/crankcase breather
304015-E 1 316001-E 1 321001-E 1 360001-E 1 433011-E 1 352071-E 9 170013-E 1 324003-E 1
65 Spring washer for motor cover 69 Start Capacitor 70 Run...
Similar Questions
Tank To Regulator Hose With Flare Fittings?
The hose on my Mac2400 leaks. It goes from the tank to the regulator. What is this part called?
The hose on my Mac2400 leaks. It goes from the tank to the regulator. What is this part called?
(Posted by jimransom 2 years ago)
Ignition Coil Air Gap
/what is the normal air gap between ignition unit and flywheel on the ek7301 chop saw
/what is the normal air gap between ignition unit and flywheel on the ek7301 chop saw
(Posted by smitty114 4 years ago)
Low Air Volume & Running Constantly
It Constantly runs & not enough air to drive framing guns. Only get enough for about five nails ...
It Constantly runs & not enough air to drive framing guns. Only get enough for about five nails ...
(Posted by Hblevinsh 6 years ago)
I Accidently Ran The Makita Compressor With Out Adding The Airfilter..
Hi; I ran the air compressure with out removing and adding the airfilter I ran it with and with out ...
Hi; I ran the air compressure with out removing and adding the airfilter I ran it with and with out ...
(Posted by dverkuyl 11 years ago)
How To Charge A Air Receiver With 6 Bar Air Line And What Will Be The Pressure I
(Posted by ramssaanthi 11 years ago)