LiftMaster Miracle-One Support Question
LiftMaster Miracle-One Support Question
Find answers below for this question about LiftMaster Miracle-One.Need a LiftMaster Miracle-One manual? We have 1 online manual for this item!
Question posted by atietjen on March 13th, 2012
Operator Arm Is Not Level
Just had Elite Miracl 1 installed and arm is not level. It is higher by 1 inch on side attached to the swing gate. Will this be a problem with how long the operator lasts and the mfg warranty?
Current Answers
Related LiftMaster Miracle-One Manual Pages
MIRACLE ONE Manual - Page 2
... Maglock / Solenoid Relay "Gate Opening Outside" Installation of the publisher.
The performances indicated in this manual may be reproduced in any means without notice.
For Toll Free Technical Support: 1-888-ELITE-10
Release 4 01/04
1 No part of this handbook are an Authorized Service
Technician!
© 1998-2004 by -Step Operator Mounting Instructions Removing the...
MIRACLE ONE Manual - Page 3
... directions prior to prevent unauthorized use. Pedestrians must be used for exposed rollers. B) The operator is supplied between the gate and adjacent structures when opening .
D) The gate must be installed. Swinging gates shall not open into public access areas.
The operator is installed.
2
F) All warning signs and placards must be visible to reduce the risk of the...
MIRACLE ONE Manual - Page 4
... by a moving . 3. Additionally, if the bottom edge of a swing gate is greater than 6 inches (152 mm) above the ground at any point in its wiring arranged so that transmits radio frequency (RF) signals to the gate operator for each type of a swing gate. ETL LISTINGS AND INSTRUCTIONS
G) For a gate operator utilizing a non-contact sensor such as an edge sensor...
MIRACLE ONE Manual - Page 7
...features for the owners to insure that this testing is in the open position. • Install the gate operator according to the manufacturer's installation instructions. • Adjust the operator clutch or load-sensing device to the minimum force setting that allows reliable gate operation. • Install operator inside fence line (DO NOT install operator on public side of fence line) •...
MIRACLE ONE Manual - Page 8
... rollers or openings large enough to allow a sphere of 2 1/4 inches to pass through a gate or the adjacent fence area. • Never allow children to operate gate. • Keep portable controls out of reach of children. • Never allow anyone to install an operating control within reach of the gate. • Never allow anyone to install a horizontal slide gate with a scissoring...
MIRACLE ONE Manual - Page 9
...! READ AND FOLLOW ALL INSTRUCTIONS. 2. Elite Access Systems, Inc. is to comply with gate controls. DO NOT install on a few pickets, they will cause the wires to gate hardware. 5. DO NOT over-bend the cord from children. 3. IMPORTANT SAFETY INSTRUCTIONS WARNING - To reduce the risk of the gate operator.
KEEP GATES PROPERLY MAINTAINED. WARNINGS AND PRECAUTIONS
Warning...
MIRACLE ONE Manual - Page 10
... Steel Bracket
(Not Supplied)
(Reinforce if
necessary)
Heavy
Gate Hinge Typical Masonry Column Setup
Steel Top View Plate Post Setup
Gate Hinge Typical Steel
8.5"
25.75"
Post Setup
Out
Gate in Closed Position
7.75"
6"
In
Miracle 1 in Closed Position
90° / 105°
Gate in Open Position Miracle 1 in Open Position
Indexing on central hole in the back...
MIRACLE ONE Manual - Page 11
... necessary)
Typical Masonry Column Setup
Gate Hinge
Heavy Steel Top View
Plate
Post Setup
Gate Hinge
Typical Steel Post Setup
6"
Indexing on mounting hole in the front steel bracket. 6"
90° / 105°
Gate in Open Position Miracle 1 in Open Position
8.5" This Plate Not Supplied 7.75"
Out
Gate in Closed Position
In
Miracle 1 in
the back steel bracket...
MIRACLE ONE Manual - Page 12
... the crossbar on the closed gate, where desired. Important:
Tack weld the front steel bracket at the top of the gate frame.
Step 3: Position the Miracle 1 horizontally level on a few pickets, or they will not hit the crossbar when in position. PROCEDURE FOR INSTALLATION
Mounting Instructions
Step 1: Remove the 4 screws and lift the
operator cover off.
MIRACLE ONE Manual - Page 13
...
Important:
Washer Must be placed between traveler carriage and TOP of the operator. Caution: Welding the brackets with the nut and bolt (See Below). Secure operator with the operator attached to the gate may damage the operator. Make sure the operator is finished, remove the operator! Step 6: Remove the nut, bolt and bushing from the traveler carriage at...
MIRACLE ONE Manual - Page 14
... connections, continue to step 11 to complete the final adjustments on the gate until you hear the key release click into place.
The gate should not move after the operator has been locked. An off-level installation may
cause the gate or operator to the gate. Push or Pull
Click! After completing
all electrical connections to the vertical...
MIRACLE ONE Manual - Page 17
...wire to eventually break.
Doing this will cause the
wires to the Miracle 1 Control Board Box.
Shield must be used, Install a dedicated water tight conduit for the blue and green lines. BLACK...run , you MUST use Shielded Wire for 6 wires.
MIRACLE SURGE PROTECTION
®
WIRING 1 OPERATOR TO BOARD
LAKE FOREST, CALIFORNIA www.eliteaccess.com
Caution: Do Not over-bend the cord...
MIRACLE ONE Manual - Page 18
...OPERATORS MASTER / SECOND
MIRACLE SURGE PROTECTION
MIRACLE SURGE PROTECTION
®
LAKE FOREST, CALIFORNIA www.eliteaccess.com
6 Wires, 16 AWG from operator in same conduit!
DO NOT let wire insulation interfere with connection.
Water Tight J-Box Kit Elite...inside removable terminal connectors. Important:
Install the Conduit (supplied) to secure the Master Operator to 200 Ft. DO NOT run...
MIRACLE ONE Manual - Page 22
MIRACLE SURGE PROTECTION
Important:
Wiring at the bottom of the control board box. To automatically Close the gate after an open the gate. The Third command will stop the gate. BLACK WHITE RED ...and #24 will open cycle, the control board timer must be recognized as a Three Push Button command. Works as "3 Push Button" control
123
456
789
HELP
0
REV A
Elite Entry Phone
Card ...
MIRACLE ONE Manual - Page 23
... space between loops and gates to prevent false detection. Caution: Distance "E" must have enough separation between loop and gate when opened or closed.
For toll free technical support: 1-888-ELITE-10
22 If driveway is smaller than 18 ft, then D must be 4.5 ft If driveway is for a typical single Miracle 1 loop installation.
Individual circumstances may alter...
MIRACLE ONE Manual - Page 30
... DESCRIPTION
MIRACLE SURGE ...Operator (Limits)
Single or Master Operator Only
6 Green Wire from Operator (Limits)
7 Black Wire from Operator (Power)
8 White Wire from Operator (Power)
9 Red Wire from Operator (Brake) 10 Brown Wire from Operator (Brake) 11 Blue Wire from Operator (Limits)
Second Operator Only
12 Green Wire from Operator (Limits)
13 Burglar Alarm Input (Normally Open...
MIRACLE ONE Manual - Page 37
... RELEASE
Step 1: To move the gate during an emergency or
power failure, insert key and turn counterclockwise to the full open position 90°. Unlock
Key Provided
Step 2: Move the gate manually to Unlock the Miracle 1 from the gate. The operator can resume normal operation as soon as power is restored. Full Open Position 90 Degrees
Push or...
MIRACLE ONE Manual - Page 41
... LIMITS
7 8 9 10 11 12
13 14 15 16
17 18 19 20 21 22 23 24 25 26 27
DC Power Adapter fits inside the Miracle-One electronic box
DC Power Adapter
Elite Part # A SOLAR ADP
Contact your local dealer for the Miracle 1 single and double arm operators. Contact your local dealer for the...
MIRACLE ONE Manual - Page 44
... Battery Rack) Q230 - UL Audio Alarm
MAINTENANCE
This swing gate operator is designed to be performed by an authorized service technician.
43 Steel Bracket Mounting Plates (2) Q231 - Harness-Motor (Operator Cord) Q300 - Miracle M/S Surge Protection Q404 - Plastic Rack and 2 Batteries A POW3 - Arm Cover Set (Top and Bottom,
Aluminum) Q302 - Arm End Caps (Set) Q303 - Control Board (Master...
MIRACLE ONE Manual - Page 49
... suggest the following items manufactured by Chamberlain Professional Products for high traffic use. WARNING SIGNS Use a warning sign on gate to prevent injury to 1300 pounds of holding force and an attached junction box.
POWER HINGES Heavy duty industrial swing gate hinges for better and safer operations.
MG-1300 MAGNETIC LOCKS
Offering up to children.
Similar Questions
I Have Installed A Chamberlan Garage Door Opener And The Remote I Was Using Is
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
(Posted by donweera42 8 months ago)
If The Reverse Sensor Adjustment Is Broken Is It Replaceable?
I have an Elite Miracle One gate opener from 2001 with upgraded board from 2013. The gate will move ...
I have an Elite Miracle One gate opener from 2001 with upgraded board from 2013. The gate will move ...
(Posted by wwcody1 9 months ago)
Garage Door Opens After Shutting.
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
(Posted by BONNIECA92 2 years ago)
Elite Miracle One Gate Operator Problem
After a rain of one or two days the slave gate responds very slowly to the open position and does no...
After a rain of one or two days the slave gate responds very slowly to the open position and does no...
(Posted by charleskoselke 7 years ago)
Miracle One - Central Control Light And Timer Light Constantly Flash Rapidly
I just bought a property that has an Elite Miracle One swing gate, and it would not operate. I was s...
I just bought a property that has an Elite Miracle One swing gate, and it would not operate. I was s...
(Posted by me71716 11 years ago)