LiftMaster CSW200UL Support Question
LiftMaster CSW200UL Support Question
Find answers below for this question about LiftMaster CSW200UL.Need a LiftMaster CSW200UL manual? We have 2 online manuals for this item!
Question posted by eb1aa on October 1st, 2015
Gates Remain Open
Gates will not close on command. "Strike Open" LED is lit and "Timer" and "Command Processed" LEDs are flashing.
Current Answers
Answer #1: Posted by TechSupport101 on October 1st, 2015 10:37 AM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,305
Member since:
May 24th, 2013 Points: 12,171,305
Hi. The garage door opener is equipped with two safety features that may prevent the door from closing and cause the lights to flash.
The Lock Button on the Door Control. The lock button on the door control may be activated. Press the button to turn this feature off. The light bulb will blink two times. This feature is designed to prompt you that the lock button is activated. When the lock button is ON the garage door opener will work from the door control but the remote controls are locked out.
The Safety Reversing Sensors. The most common reason for the lights to flash on the garage door opener and the door not closing is that the safety reversing sensors are misaligned or obstructed; this is a safety feature of the garage door opener.
When properly connected and aligned, the sensor will detect an obstacle in the path of its electronic beam. If an obstruction breaks the light beam while the door is closing, the door will stop and reverse to full open position, and the opener lights will flash 10 times.
Your garage door opener is equipped with a Self Diagnostic feature to help you determine what the issue is. Based on the model of your garage door opener, your garage door opener will flash an LED next to your learn button or flash the Up and Down arrows a number of times to indicate the issue.
Related LiftMaster CSW200UL Manual Pages
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 3
...(Non-Contact Sensors 26
adjustments
Set Gate Opening Direction 27 Limit Switch Adjustments 28 Clutch Adjustment 28 Radio Receiver Programming 29-30 Setting the Timer (On, Off 31 Adjusting Reversing...Layout 11 Compact Installation Layout 12 Uphill Driveway Post Mounting Plate Installation 13 Gate Arm Installation 14 Output Shaft Adjustment 14 Control Board Description 15 Surge Suppressor...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 4
... - 20 ft.
CSW200ULDM™ (Dual Motor)
Two-1/2 HP Motors, 120Vac, 4 Amp. Maximum Gate Weight - 800 lbs.
Maximum Gate Weight - 800 lbs. Maximum Gate Length - 22 ft. Maximum Gate Weight - 1000 lbs.
Single Motor Cover
Stainless Steel Cover
CSW200UL™ (Single Motor)
1/2 HP Motor, 120Vac, 4 Amp.
Maximum Pull - 125 lbs.
CSW200ULDCH™ (Single Motor)
1/2 HP Motor...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 5
... of motorized gate systems.
3
Class IV- That means that is installed on both the open and close directions of ... CSW200UL™ is intended for use in a commercial location or building such as a multi-family housing unit (five or more single family units) hotel, garage, retail store or other building servicing the general public. Residential vehicular gate operator A vehicular gate ...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 6
...Therefore, safety features must take into account the possible hazards associated with a separate access opening and closing to start.
10. The gate must be installed in the open into every design. For a gate operator utilizing a non-contact sensor:
a.
b. Install the gate operator only when:
a. Pedestrians must reduce public exposure to reduce the risk of...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 7
... bottom edges, with vertical bottom edged protrusions not exceeding 0.50 inches (12.7 mm) when other fixed object when the gate moves toward the fully open and fully closed positions. Specific Applications
2. Any non-automated gate that is to be automated shall be upgraded to conform to the provisions of this specification.
2.2 This specification shall...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 8
... vehicles 14 feet or longer. See Loop Wiring.
6
A center loop protects during a Close cycle of the gate. SUGG E S T E D E N T R A P M E N T P R O T E C T I O N D E V I C E L O C A T I O N S
To prevent SERIOUS INJURY or DEATH from a moving gate and RIGID objects, such as posts or walls. • A swinging gate shall NOT open into public access ways. If a vehicle is shorter, a center loop is...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 9
.... See Entrapment Protection Devices.
3 sided edge sensor for vehicles 14 feet or longer.
Suggested for open and close cycle. Edge sensor for open cycle. 7 Safety loops are obstructing the gate path. Contact Sensors (Edge Sensors)
Install edge sensors to stay open when vehicles are required when using a center loop. If a vehicle is shorter, a center loop...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 10
... never allow anyone who may come near the gate's path!
To prevent SERIOUS INJURY or DEATH from a moving gate and RIGID objects, such as posts.
• A swinging gate shall NOT open and close gate cycles.
• Locate entrapment protection devices to hang or ride on BOTH sides of a moving gate.
• Locate entrapment protection devices to protect...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 13
... arm is on TOP
of
bracket.
Drawing not to next page.)
For technical support: 1-800-528-2806 11 C) Close gate, place tape measure between 20 and 32 inches, "Compact Installation" is necessary. (Refer to scale
Gate Open 90° Helpful Layout Note: A) Long arm's final placement is between bracket and output shaft. E) Take measurements...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 14
... to protect against the entrapment that could occur with this type of installation. (See entrapment protection devices.)
Outside Property Inside Property
Gate Open
26.5"
20" Minimum Width
Outside Property Inside Property
Gate Closed
33"
Hinge Center
2" 9"
23" 25.5"
20" to 32"
Cut
Long Arm
Cut
10"
22"
4"
36"
Cut
Short Arm
4"
20"
24"
Follow...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 16
....
3 Tighten the handle.
4 Pull the short arm away from the gate. NO slippage should occur.
If it does, go back and tighten the nut.
5 Replace cover and star knob. 14 Gate Open
Correct Installation
Once the gate arm measurements are calculated: Arm is on the gate.
Gate Closed
Weld the bracket on TOP of bracket. G A T E A R M I N S T A LL A T I O N
Incorrect...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 17
Timed close. Gate Locked LED - Radio Receiver LED - Center loop detector activated when ON. Strike Open LED - Successful command executed. Limited Adjustment. System On LED - Operator power OK when ON. Close, Stop, Open commands. Open Left, Open Right. Safety Loop LED - Exit Loop LED - J3 Motor, Limit Switch, Maglock/Solenoid Connection DC2000™ Back-Up Power or Reset ...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 21
...
Use a 20 amp dedicated power circuit for
M/S link. Shield wire MUST be opened with a remote control and the exit gate with a free exit loop. Connect Master M/S Link B to Second M/S Link ...gates at the same time. 1. NOTE: Disconnect the second radio receiver when using a master/second setup.
Master Board Master/Second control boards are interchangeable. NOTE: To adjust timers...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 23
... gate due to a power failure (auto mode), any manual command such as the OmniControl™ board setting. After such cancellation, the DC2000™ will be used. f a c tory in s ta l l e d d c 2 0 0 0 ™ c onne c tion
DC 2 0 0 0 ™ S t a r t u p
Plug in "manual mode" until 110Vac power is restored. Make sure the "System ON" and "Charge OK" LEDs are lit...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 24
... SAFETY EXIT
ALARM SENSOR
DC-BACKUP
SYSTEM ON SENSORS
REVERSE SENSOR
TIMER
60
3
OFF OPEN LEFT
ON OPEN RIGHT
COMMAND PROCESSED
FIRE DEPT. DO NOT FOR USE FOR A EMERGENCY FIRE/POLICE KEY ACCESS.
STRIKE OPEN
RADIO RECEIVER
GATE LOCKED
EXIT LOOP
SAFETY LOOP
CENTER LOOP
RESET MOTOR
CLOSE STOP OPEN
POWER OVERLOAD
MADE IN USA
1234567
+12Vdc Ground
DC-BACKUP...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 28
... is cleared. Entrapment Non-Contact Sensor
NOTE: If the photoelectric sensor gets blocked while the gate is closing, it will remain open and close gate cycles.
• Locate entrapment protection devices to test photoelectric sensors monthly. The gate will stop ALL gate operation. Contact your local dealer for this safety option.
ENTRAPMENT PROTECTION DEVICES Non-Contact Sensors...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 30
... adjustment, use the allen screw. While the gate is closing, instantly an "open position. Gate smoothly reverses direction with the other limit cam. Tighten cam. c l u t c h a d j u s tment
The adjustment is for a gate that is given an "Open" command before completing a normal close-cycle.
Gate in Closed Position
Adjust the clutch with a wrench
Gate is over 300 pounds and 12 feet...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 33
... before reversing during the close command, the timer should be connected by M/S LINK. Turn BOTH timers OFF.
2. Turn Second Timer to be put in the "ON" position. Second Board
NOTE: Push button once to open gate, push button again to 60 seconds. Set timer 3 to close gate.
31
with Timers ON
Second Board
1. Push button once to open gate, push button again to...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 46
...2. Alarm sensor is extra sensitive. Timer LED Blinking, Command Processed
LED Blinking and
Reverse Sensor LED ON
1. Gate has reopened because it encountered an obstruction while closing.
Check inputs for obstructions.
1. Any re-new command will resume normal operation. Command Processed LED ON
1. There is faulty (Rapid Flashing). Audio Alarm ON
1. Gate has encountered two consecutive...
CSW200UL W/ SURGE SUPPRESSION & RADIO RECEIVER Manual - Page 54
...-paid and insured, to state.
52 Warranty Policy
7 YEAR RESIDENTIAL / 5 YEAR COMMERCIAL CSW200UL™ LIMITED WARRANTY
The Chamberlain Group, Inc. ("Seller") warrants to the first purchaser of...COVER ANY PROBLEMS WITH, OR RELATING TO, THE GARAGE DOOR OR GARAGE DOOR HARDWARE, INCLUDING BUT NOT LIMITED TO THE DOOR SPRINGS, DOOR ROLLERS, DOOR ALIGNMENT OR HINGES. UNDER NO CIRCUMSTANCES SHALL SELLER ...
Similar Questions
Strike Open Light Is On And Magnet Doesn't Work To Hold Gate Close
Strike Open Light Is On And Magnet Doesn't Work To Hold Gate Close, What Is The Problem?
Strike Open Light Is On And Magnet Doesn't Work To Hold Gate Close, What Is The Problem?
(Posted by Anonymous-173407 1 year ago)
Gate Opens From The Motor But Will Not Close From The Motor Or The Remotes.
(Posted by kdmcfall 4 years ago)
Problem With Elite Series Garage Door Model 3850 Won't Close
(Posted by acerseerki 9 years ago)
Error Code 41 Garage Door Liftmaster 8550 Won't Close
(Posted by jonkrzyc 10 years ago)