LG WM1812CW Support Question
LG WM1812CW Support Question
Find answers below for this question about LG WM1812CW.Need a LG WM1812CW manual? We have 1 online manual for this item!
Question posted by Thienttran0501 on April 30th, 2013
Water Overfilling
im having problem with the washer overfilling with water, it does spinn but don't stop filling it up with water eventully water comes out off gasket I turn it if and no spinn to drain it out
Current Answers
Related LG WM1812CW Manual Pages
Owners Manual - Page 2
... Load Detection Automatically detects the load and optimizes the washing time.
Child Lock The Child lock prevents children from pressing any button to Use the Washer...14 Maintenance ...16 Troubleshooting Guide ...19 Warranty ...22
2
CONTENTS
Important Safety Information ...3 Specifications...4 Installation Instructions ...5 Preparation Before Washing...10 Using the Dispenser ...11 Cycles...
Owners Manual - Page 3
... from service or discarded, remove the door to the wash water. IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USE
! Close supervision of children is necessary when the washer is used for such a period, before using the washing machine, turn on or in the washer.
ENGLISH
IMPORTANT SAFETY INSTRUCTIONS
! WARNING: Improper connection of the equipment...
Owners Manual - Page 4
Permissible water pressure: 4.5 ~ 116 PSI (30 ~ 800 kPa)
Specifications subject to change by manufacturer.
Accessories
1) Per IEC 60456, washes the equivalent of a 3.42 cu. ft. (IEC: 3.42 cu. ft.)1)
Spin speed:
900 rpm max.
agitator washer. 4 SPECIFICATIONS
Name:
Front-loading Washing Machine
Power supply:
120V~ 60Hz
Size:
68.6 cm (W) X 76.3 cm (D) X 98.3 cm...
Owners Manual - Page 5
...4 locking bolts are installed. To reduce the risk of electric shock, do not install the washer in clean condition at all governing codes and ordinances. In countries where there are not removed,...future use.
• Whenever the appliance is installed on a carpeted floor.
Before operating the washer, remove the bolts.
• If they are areas which may cause severe vibration, noise, and...
Owners Manual - Page 6
...) on a platform or weakly supported structure. Power outlet • Must be large enough to reduce noise transfer. NOTE: It is recommended to fully open the washer door.
Minimum installation spacing for the minimum spacing allowed. INSTALLATION INSTRUCTIONS
Installation clearances
The location must be within 60 in. (1.5 m) of either side of the...
Owners Manual - Page 7
... be replaced by qualified personnel. Old hoses should be installed.
• Two Sealing washers are below freezing, store the washing machine at temperatures below freezing may cause injury or...machine must be impaired at room temperature for hot water is delivered in order to the correct water faucets. Repairs carried out by turning the tap completely on.
• Periodically check...
Owners Manual - Page 8
from the bottom of the washer.
• Properly securing the drain hose will protect the floor from children.
8 Turn off the power cable, and destroy the plug. Packaging material (e.g. There is not designed for maritime use or for mobile installations such as in . Disable the door lock to water leakage. Keep all packaging from damage...
Owners Manual - Page 9
...on a solid and level floor surface, preferably in that it is critical to level the washer. Install the appliance on the floor and then check that all . (Please, check both ...machine properly prevents excessive noise and vibration.
Run the washer with a load. Then, press POWER, RINSE+SPIN, and START/PAUSE, in a corner of laundry in adjustment. Then tighten the lock nuts to prevent...
Owners Manual - Page 10
... on other clothes.
• Pretreat dirt and stains by brushing a little detergent dissolved in water onto stains like collars and cuffs to be washed with lightly soiled ones.
Different fabrics need ...load. NOTE: Do not wash or spin water-proof clothes.
10 Wash separately as clips, matches, pens, coins, and keys can damage both your washer and your clothing.
• Close zippers,...
Owners Manual - Page 11
... will drain into the washer drum as it is recommended for main wash. Open the dispenser drawer. 2. Use the manufacturer's recommended amount.
Prewash Detergent Compartment
• Add detergent to be added at the appropriate time for water temperature, water hardness, size and soil level of the load. After loading the laundry additives into the appropriate...
Owners Manual - Page 12
..., or spill laundry products (soap, detergent, bleach, softener, etc.) on the wash load.
• The fabric softener will be used in stained clothes.
• Do not pour fabric softener directly on the top of fabric softener to the fill line.
• Do not exceed the maximum fill line. The bleach will drain into the...
Owners Manual - Page 14
... button to turn on the type of fabric and soil levels.
• Each cycle has a preset Water Temperature, Spin Speed, Soil Level, and Option (See page 13).
• The preset settings can be changed anytime before Start. Power
• Use this button to cycle through available options.
• To start /stop the washer.
14...
Owners Manual - Page 15
... TO USE THE WASHER
6. Adds 16 minutes prewash and drain. Use powdered for... use of the washer is on .
15
ENGLISH Rinse+Spin
• Use this option to 9 hours in one hour increments.
6. NOTE: If the water temperature or the ...that has been packed away.
3. CHILD LOCK
• Use this option to turn the Beeper On/Off. Quick Cycle
• The Quick cycle offers a quick...stop the washer.
Owners Manual - Page 16
... to remove objects.
The drain pump filter • The drain filter collects threads and small objects left .
3. At this time use a vessel to the left in the laundry. After cleaning, turn the
pump filter open to prevent water from the pump filter .
Close the lower cover cap .
3
1 2
16 MAINTENANCE
Before cleaning the washer interior, unplug the...
Owners Manual - Page 17
... drain into the tub.
ENGLISH
• Run warm water and...stops.
2 Press down the lock tab on the drawer and inserts to remove any excess laundry additives. • Clean the drawer opening other than water because it will eventually have been left in reverse order to replace the parts to their compartments. Remove the drawer.
3 Remove the softener and bleach inserts from the washer...
Owners Manual - Page 18
These areas should always be expelled. 6.
Disconnect hoses from water supply and drain water from the Dispenser. Plug electrical cord into a properly grounded electrical outlet. 4.
Remove the two-compartment container from hoses. 3. Interior
Dry around the washer door opening, flexible gasket and door glass. Add 1 gallon (3.8 ) nontoxic recreational vehicle (RV) antifreeze to ...
Owners Manual - Page 19
... service. Adjust the leveling feet.
Water does not enter washer or it enters slowly
• Water supply is not adequate in the spin cycle with automatic safety functions which detect and diagnose problems at Check and tighten hose connections. Water in the house. Clean and straighten the drain hose.
Water leaks
• Fill hose connection is loose at...
Owners Manual - Page 20
... cycle time delayed
• The washing time may vary by a qualified electrician.
• Water supply tap is firmly shut. The door must lock before the clothes washer begins to spin.
Turn on . Reset circuit breaker or replace fuse.
TROUBLESHOOTING GUIDE
Problem
Washer does not start
Possible Cause
• Electrical power cord may not be plugged...
Owners Manual - Page 21
.... Unplug the power plug. Call for service.
• The water overfills due to restart the spin cycle the machine will stop and the error code will be displayed. Fully open .
• Water inlet hose is bent. • The filter of the inlet hose
clogged. Clean the drain filter.
• Load is too small. • Load...
LG Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Water overshooting ice tray - LG Consumer Knowledge Base
...dumps and the tray fills again. When the bin is smaller to adjust these dip switches. 5. The cube selector accommodates for service. Water will overfill the tray if water pressure is 21~121...correct position, water will freeze in the proper position. The water will overshoot the tray when it is open. The recommended water pressure is higher than this, water comes out of the... -
Leaking inside freezer - LG Consumer Knowledge Base
...3. Reduce the size of water overfilling or overshooting the ice tray. the water pressure may have leaked prior... -> Top Mount Side by the fill tube being in Crisper drawer Refrigerator: Water has a bad taste Refrigerator Configurations ...water pressure regulator. Make sure that the ice tray is properly installed correctly and the ice cube selection is coming from the icemaker, water coming... -
LG Front Load Washer: General FAQ - LG Consumer Knowledge Base
... periodically to suit your hot and cold inlet hoses, and drain hose, for the matching dryer can escape from the dealer where you have chosen the cold setting, the washer will turn off automatically. After a wash cycle has been run a cycle only using the "water plus option will add approximately 2 - 4 extra gallons of estimated...
Similar Questions
Drain Hose Will Not Get Water Out Of The Filter Drain
Only a little water comes out of the drain hose, so a lot comes out when the filter is removed
Only a little water comes out of the drain hose, so a lot comes out when the filter is removed
(Posted by genecliett 10 years ago)
Lg Wm1812cw
water leaking from bottom of washer rust on one of the cold water solenoids
water leaking from bottom of washer rust on one of the cold water solenoids
(Posted by kmccracken 10 years ago)
My Washer Is Full Of Water And Wont Turn On All The Power Is Working And Wont
how can i fix this ihave the wt 5101 hv model i turned it off for 12 hours and still wont turn on ...
how can i fix this ihave the wt 5101 hv model i turned it off for 12 hours and still wont turn on ...
(Posted by slammer442 12 years ago)