LG HS200 Support Question

LG HS200 Support Question

Find answers below for this question about LG HS200.
Need a LG HS200 manual? We have 1 online manual for this item!

Current Answers

Related LG HS200 Manual Pages

Owners Manual - Page 1

OWNER'S MANUAL DLP PROJECTOR Please read this manual carefully before operating your set and retain it for future reference. HS200 HS200G HS201 HS201G www.lg.com

Owners Manual - Page 3

...(HS200/HS200G only)........22 Installing Instructions (HS200/HS200G Only 23 What do I do if the FM receiving signal is not good? (HS200/HS200G Only 23 To listen through the FM receiver speaker (HS200/... screen 28 To make the power of the projector turn on the Projector 14 Turning off the Projector 14 Focus and Position of the Screen Image 14 Selecting input mode 14 Connection Connecting to ...

Owners Manual - Page 6

... shock hazard or damage to the remote control. 6 Always open the lens door or remove the lens cap when the projector lamp is in a room that an image does not appear on the projection lens. Contact your Service Agent. Only use cleanser (glass cleaner), automobile or industrial shiner, abrasive or wax, benzene, alcohol...

Owners Manual - Page 7

... does not always indicate a malfunction. POWER Button Turn ON/OFF the projector. Names of parts Names of parts Main Body * The projector is not displayed, adjusts volume with ＜/＞ Button ◉OK... menus. You may, however, see on the Projector screen tiny black points and/or bright points (red, blue, or green). When the OSD is manufactured using high-precision technology.

Owners Manual - Page 11

... where adequate temperature and humidity is available. (refer page 41) Don't place the projector where it to the projector. It may , however, see tiny black points and/or bright points (red, blue or green) that continuously appear on the projector Screen. This product should be covered with international standard products to a wall or ceiling...

Owners Manual - Page 12

... to the screen. projection distance based on a sturdy and horizontal surface with the PC or AV source. 2. Place the projector with the desired distance from the screen. The distance between the projector and the screen determines the actual size of the Projector 1. Installing and Composition Basic Operation of the image. 3. Position the projector so that the...

Owners Manual - Page 14

...POWER button on the remote control or the POWER button on the control panel when you turn on the projector, the lights for all buttons on the con- Make sure the power cord is in focus and fits... ring • To adjust the focus of the Screen Image When an image appears on . Focus and Position of the image, rotate the focus ring. Installing and Composition Turning on the remote control.

Owners Manual - Page 15

...image source to the projector. < How to connect > 1. Connect the VIDEO IN of the projector to the output jack of the video source with a video cable. 2. Connect the AUDIO IN of the projector to the output jack of the projector... that your PC exports to one supported by the projector. Refer to connect > 1. Connect the RGB IN of the projector and the computer output port with a computer cable....

Owners Manual - Page 16

... Player to the RGB to Component cable, connect it to RGB IN of the projector. * When connecting the component cable, match the jack colors with the component cable.(Y=green, PB=blue, PR =red) 2. Connect the AUDIO IN of the projector to the output jacks of the audio source with an audio cable. Audio Cable...

Owners Manual - Page 17

...image values differently for the best picture appearance. 1. Q-Menu Aspect Ratio 16:9 Picture Mode ꔗ Vivid ꔃ Sleep Timer Off Eject USB Eject Close ꔗ Vivid ꔃ ꔗ Standard ꔃ ꔗ Cinema ꔃ ꔗ Sport ꔃ ꔗ Expert2 ꔃ ꔗ Expert1 ꔃ • You can set the projector...from your projector. * This...

Owners Manual - Page 18

...;mC:moSnattaransdtard 50 High Bl•acBkriLgehvtenless 50 Medium Fil•mShMaordpeness 5 • Color 70 Co•loTrinSttandard 0 R Medium HigGh Co•loArdGvaanmcuetd Control Off Ed•gReeEsneht... the selected PICTURE function for Picture Mode to restore back to default factory set image values differently for each input and Picture Mode. • Execute Reset for ...

Owners Manual - Page 19

... parts darker. Edge Enhancer ꔈ Show clearer and distinctive yet natural corners of the screen gets brighter. Method : 2 Points - Pattern: Inner, Outer - Dynamic Color ꔈ Adjusts screen colors so that red, blue, green and white look more vivid. This function enables Expert 1/2. ꔈ This is -30 ~ +30. - The picture is enabled in RGB...

Owners Manual - Page 20

... or RETURN button to exit the menu screen. button of projection. 1. Press the KEYSTONE +, - button to the projector and the image is not at a right angle to adjust the screen condition... SCREEN with the ∧, ∨ buttons and then press the ◉OK button. • Select Rear when projecting from -40 to Aspect Ratio. 3. Then, move to 40. • You can 't get the best angle...

Owners Manual - Page 22

...Wireless Audio? (HS200/HS200G only) FM Wireless Audio is a function to send out audio signals from FM receiver normally. Audio Signal 88.1 MHz - 107.9 MHz < The recommended use range of Projector and FM receiver ...the antenna length and direction are good. The frequency of FM receiver > Install projector and FM receiver without any abstacles as shown on the figure below. FM Receiver Receiving range Within ...

Owners Manual - Page 23

... FM receiver. • Please check if there is any metallic hardware or electronic product near by the projector and FM receiver. - What do I do if the FM receiving signal is not good? (HS200/HS200G Only) • Please adjust the antenna of FM receiver or move the location of FM receiver. • If...

Owners Manual - Page 24

...installation locations. • FM frequency can use the FM receiver or audio signals from the projector, Off should be selected. • When power is changed to Off status. •...88.1 MHz ~ 107.9 MHz. • If you don't use this function through the FM receiver speaker (HS200/HS200G Only) 1. Press the MENU button. Adjusting Volume Press the VOLUME +, - AUDIO ꔂMove ꔉ...

Owners Manual - Page 26

...8226; Press the MENU or RETURN button to exit the menu screen. 26 OPTION Menu Language Blank Image Screen Capture LED Mode Auto Power Keypad LED Demo Mode Initial Setting : English : Black ꔂ...; 120 Min. ꔃ ꔗ 90 Min. ꔃ Auto Off Function * This function turns the projector off at the preset time. 1. Press the Q.MENU button on the remote control. 2. Press the ∧...

Owners Manual - Page 27

... cause a fire. Press any objects when the projector is an input signal. • It takes ... during presentations, meetings or briefings. 1. OPTION Menu Language Blank Image Screen Capture LED Mode Auto Power Keypad LED Demo Mode Initial Setting...not block the projection lens with any button to cancel the blank function. • To temporarily turn off to a background color. •...

Owners Manual - Page 28

...On : Off : Home Use To set the button light 1. Press the MENU button. OPTION Menu Language Blank Image Screen Capture LED Mode Auto Power Keypad LED Demo Mode Initial Setting : English : Black ꔂMove ꔉ...to On and press the ◉OK button. • On: Connecting DC cable to the projector turns on automatically when power is pressed, it lights for 5 seconds before turning off. &#...

Owners Manual - Page 29

...8226; Press the MENU or RETURN button to exit the menu screen. OPTION Menu Language Blank Image Screen Capture LED Mode Auto Power Keypad LED Demo Mode Initial Setting : English : Black &#...On : Off : Home Use INFORMATION Menu Options To See The Projector Information 1. Press the MENU button. INFORMATION Model Name Input Resolution Fh/Fv : HS200-JE : Video : NTSC M : 15.7KHz/60.0Hz 29 ...

LG Knowledge Base Results

• LCD Panel - LG Consumer Knowledge Base
  ...of a liquid crystal panel's operation. The key to pass through . The two polarizers are used in a blurred image. The liquid crystals are mounted at a 90 degree angle with respect to surrounding cells resulting in the past that ... for channels? 3D Requirements & Each sub-pixel or cell (a red, green, and blue sub-pixel equals one pixel) is the polarizers. FAQs Terminology
• TV:Video Connections:480i - LG Consumer Knowledge Base
  ... as an input on some HDTV monitors and projectors. are labeled Y, PB, and PR with RCA jacks. The term RGB+H/V stands for their component video outputs. You can 't really hurt anything if you will be two different types of the three primary colors (blue and red) - The VGA-graphics-standard 15-pin D-Sub...
• Plasma Display Panel (PDP) - LG Consumer Knowledge Base
  ...a sizable chunk of televisions have a slightly colored glow. These televisions have wide screens, comparable to forman image. That is to illuminate tiny colored fluorescent lights to the largest CRT sets, ...sometimes give the picture a slight tint depending on both sides of three fluorescent lights -- a red light, a green light and a blue light. It has a net positive charge, making it...

Similar Questions

When Lg Hs200g Is Red Blinking?

(Posted by rioqhrjwehfu 7 years ago)

LG HS200G

Answers

The Picture Is Giving A Bleeding Red Line On Sides Of All Images.
The picture is giving a bleeding red line on sides of all images.My lamp is not even used for 300 ho...

(Posted by aghosal2001 8 years ago)

LG BX401C

Answers

Red Blinking Screen (lg Hs200g Projector)
lg Hs200g Projector its Working With An Issue Of Red Blinking Screen May Be Need New Bulb Or Somthi...

(Posted by naveedgill79 11 years ago)

LG HS200G

Answers

I Am Getting Mirror Image(reverse Image) Through My Projector??? Pls Help

(Posted by smskite356 11 years ago)

LG BS275

Answers

What Is Ded In The Projector? , How Much It Cost? Hs 200-je, Lg
WHAT IS DED in  HS 200-JE, LG projector? , WHERE IS IT AVAILABLE, how much it cost?

(Posted by shahsheriff 11 years ago)

LG HS200

Answers