Home » KitchenAid » Refrigerators » KitchenAid KUIC15NRTS

KitchenAid KUIC15NRTS Support Question

Find answers below for this question about KitchenAid KUIC15NRTS.
Need a KitchenAid KUIC15NRTS manual? We have 2 online manuals for this item!

KitchenAid Overview Questions Manuals Reviews Videos Research

Question posted by superbird1 on September 17th, 2012

Replacing A Control Panel And Changing Clear Tubing That Is Dirty.

I have ordered a control panel to replace in my icemaker but do not know how to pull the old one out. Also can the clear tubing be replaced?

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related KitchenAid KUIC15NRTS Manual Pages

Use and Care Guide - Page 2

... Requirements 4 Water Supply Requirements 4 Leveling 4 Connect Water Supply 5 Drain Connection 6 Ice Maker Door 6 Normal Sounds 8 ICE MAKER USE 8 How Your Ice Maker Works 8 Using the Controls 9 ICE MAKER CARE 9 Cleaning 9 Vacation and Moving Care 11 TROUBLESHOOTING 12 Ice Maker Operation 12 Ice Production 12 Ice Quality 13 Plumbing Problems 13 ASSISTANCE...

Use and Care Guide - Page 3

...be pulled ...soft copper tubing with ...order to move and install ice maker. The ice maker may be easily removed by changing... the height of the leveling legs. Place electrical and plumbing fixtures in the "Ice Maker Care" section. Do not use an extension cord. ■ Disconnect power before cleaning. ■ Disconnect power before servicing. ■ Replace... and panels before using...

Use and Care Guide - Page 4

... occur, resulting in Step 4 to change the height of the legs as possible... 3 prong wall receptacle installed by a switch or pull chain. NOTE: If this product is recommended. Place...1 gal. (3.8 L) of it is required to 5. Replace the filter if necessary. ■ Allow the storage tank ...licensed, qualified plumber. It is a built-in order to the final location. 2. Use a receptacle which...

Use and Care Guide - Page 5

... you begin. Be sure both ends of copper tubing to allow sufficient water flow to avoid possible water valve malfunction. 5. Line to clear line of the tubing into outlet end squarely as far as shown. ...or 4.76 mm) saddle valve which is recommended. Inlet water tube clamp E. NOTE: To avoid rattling, be pulled out of tubing into a container or sink, and turn shutoff valve or the...

Use and Care Guide - Page 6

...of drain should also be sure that it is level. Connecting the Drain After ensuring that the ice maker drain tube is positioned over the PVC drain reducer. Style 1 - Drain hose B. 1" (2.54 cm) air gap C....maker drain to the floor with or without the ³⁄₄" (1.91 cm) panel on the door. Plug into position so that the drain system is provided with the ...

Use and Care Guide - Page 7

...1. Keep the parts together and set aside. 2. Remove the door from the "old" bottom hinge and replace it diagonally to the opposite side's top corner, keeping the straight side of the ...on the top opposite side of the door. 7 Top Hinge A B C D A. Beginning Bottom Corner End Cap D. Replace the screws in the empty hinge holes. 2. Place the hinge on the door. B C A. Hex-head hinge screw...

Use and Care Guide - Page 8

... the ice maker shuts off , be sure to set the ice maker control to you, you might be concerned about 5 minutes. The amount of...a freezing plate. IMPORTANT: ■ If the water supply to the refrigerant flowing in your results are rejected. This produces a sheet of ice ...hear a buzzing sound when the water valve opens to make clear ice from the evaporator onto the cutter grid. ■ ...

Use and Care Guide - Page 9

... stainless steel surfaces. 1. The light will change from the bottom of approved ice maker cleaner.... Wait 5 to 10 minutes for service. Replace the drain cap securely on the cleaner bottle before... grains/liter), you it is . Using the Controls 1. This tells you may scratch the finish. ...you know when it is loose, water will have either thin ice or no ice. 5. To order, ...

Use and Care Guide - Page 10

...replace the drain cap securely on the water pan. Replace all parts and panels before cleaning. Pull the ice level sensor down to remove the lower access panel...Controls." Remove dirt and lint from the cutter grid. 7. Unplug ice maker or disconnect power. 2. Pull the bottom forward and then pull... hold the CLEAN button. Condenser A dirty or clogged condenser: ■ Obstructs proper...

Use and Care Guide - Page 11

...replacing the thumb screws. Failure to the valve. 6. Unplug ice maker or disconnect power. 2. Pull forward to water valve. Ice scoop holder 10. Replace water pan by removing the drain cap. 8. Replace...C. Drain cap 9. A B Electrical Shock Hazard Disconnect power before operating. Replace all parts and panels before servicing. To shut down with mild soap or detergent and warm water....

Use and Care Guide - Page 12

...ON? Replace all parts and panels before servicing.... See "Cleaning." Do not use an extension cord. The ice maker is receiving power but may sense cold room temperature and shut off even though the bin is set to clear...the drain tube? Ice Maker...control set to purge minerals that the control ...9632; Is the condenser dirty? If there was ... debris in order to avoid ...

Use and Care Guide - Page 13

...United States. For further assistance If you need further assistance, you can write to order replacement parts, we recommend that all the packaging materials removed? See "Ice Maker System" ...Failure to local dealers, repair parts distributors, and service companies. When calling, please know the purchase date and the complete model and serial number of installation. Our consultants ...

Use and Care Guide - Page 14

.... Service calls to refrigerator or freezer product failures. 6. Repairs when your major appliance, to replace or repair house fuses... condenser, dryer/ strainer, and connecting tubing. Any food loss due to repair or replace appliance light bulbs, air filters or...book and your major appliance, to instruct you need to know your authorized KitchenAid dealer to the appliance. 9. KITCHENAID&#...

Parts List - Page 2

...Right Side 25 2185756 Pad, Foam 26 2185691 Channel, Wiring 27 2185964 Grommet, Edge Guard (2) 28 2185989 Tube, Drain 29 585158 Scoop 30 3400884 Screw Illus. No. Part No. Part No. DESCRIPTION 31 3400237 Screw...W10320111 Top 45 2185690 Shield, Electrical 46 2217293 Gasket, Top Panel 47 2185571B Grill, Front 48 489474 Screw 49 Cabinet & Liner (NOT SERVICED) 2 W10327052 No. Part No...

Parts List - Page 4

... 2313604 Guide−Ice, Grid 17 2313603 Bracket, Rear W10136175 Bracket, Front 18 2313602 Bracket, Side Left and Right 19 2185681 Harness, Grid 20 W10218065 Tube 21 2310169 Wire Assembly (Valve) 26 3400886 Screw 28 2313637 Grid Assembly (Complete) 29 2174754 Wire, Grid Cutter 30 2185570 Cover, Grid 31 8281228 Thumbscrew...

Parts List - Page 6

...Transformer 3 2304122 Assembly, Switch (ALSO ORDER #4) 4 W10206463 Overlay 5 W10226156 Control Board 6 2149705 Switch, Plunger Grid/Light 7 2187585 Wire Assy−Active Overlay Jumper 9 745362 Bulb 12 2313633 Thermostat, Bin 13 2185825 Clamp 15 3400884 Screw 18 3400850 Screw 20 2313635 Thermister, Ice Control 6 W10327052 No. Part No. CONTROL PANEL PARTS For Model: KUIC15NRTS4 (Stainless Steel...

Parts List - Page 8

... A201441 Shim (4) 10 2185960 Clamp−Service Cord 11 Grommet (4) 2217318 Production 4387558 Service 12 2208415 Tube, Process 13 8281265 Screw 14 489472 Screw 15 W10206473 Coil, Solenoid 16 2313806 Hot Gas Valve 17 2187629...Screw 30 2217388 Base, Unit 31 8281196 Screw REFRIGERANT CHARGE 6.5 OZ. (R134A) 8 W10327052 Part No. UNIT PARTS For Model: KUIC15NRTS4 (Stainless Steel)...

Parts List - Page 9

DESCRIPTION Parts Not Illustrated and Optional Parts (Not Included) 8171307 Cleaner, Icemaker 503695 Sealer, Cork (1/4 Pound) 797403 Cement, Insulation (1 Oz.) 505587 Sealer, Mastic (1 Qt.) 212643 Sealer, Gum (22 Pcs. 3/16" x 7") 479976 Kit, Insulation (5 Pcs. 3" x 24" x 48") 8537055 ...

KitchenAid Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Replacing the light bulb - Bottom freezer/French door refrigerator
.... NOTE: Not all appliance bulbs will fit your refrigerator. Changing the refrigerator light bulb Unplug refrigerator or disconnect power. Slide the cover toward the back of the cover over the light assembly. Remove the cover and replace the burned-out bulb with one of the cover and pull down the cover. Side by inserting the tabs...
Changing the under-counter refrigerator light bulb
... tabs. Align the holes and insert the screw. Changing the under-counter refrigerator light bulb How do I change the light bulb: Unplug refrigerator or disconnect power. Not all appliance bulbs will fit your refrigerator. Plug in the outdoor under -counter refrigerator? Replace the bulb. Pull the light shield back to replace the bulb with one of the light shield...
Changing the beverage center light bulb
... the screw. Plug in my beverage center? Answers others found helpful Replacing the light bulb - Reinstall the light shield by inserting the tabs. Replace the bulb. Tighten the screw. Bottom freezer/French door refrigerator Moisture in the refrigerator compartment Changing the under-counter refrigerator light bulb Using a Phillips screwdriver, remove the screw located at the...