KitchenAid KUIC15N Support Question
KitchenAid KUIC15N Support Question
Find answers below for this question about KitchenAid KUIC15N - 15 in. ARCHITECT Series II Ice Maker.Need a KitchenAid KUIC15N manual? We have 2 online manuals for this item!
Question posted by borvin on December 16th, 2015
Icemaker Not Making Ice, No Water Coming Into Reservoir, Changed Incoming Water
I can turn on clean cycle with a full reservoir (that I fill up ) and still do not get water to circulate, drain, or enter reservoir .what could be wrong with inlet valve
Current Answers
Answer #1: Posted by Odin on December 16th, 2015 5:10 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
See https://www.youtube.com/watch?v=BFh8aa7asvw. Good luck!
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related KitchenAid KUIC15N Manual Pages
Use and Care Manual - Page 2
...Unpack the Ice Maker 3 Location Requirements 3 Electrical Requirements 4 Water Supply Requirements 4 Leveling ...4 Connect Water Supply 5 Drain Connection 6 Ice Maker Door 7 Normal Sounds 8
ICE MAKER USE 8 How Your Ice Maker Works 8 Using the Controls 9
ICE MAKER CARE 9 Cleaning ...9 Vacation and Moving Care 11
TROUBLESHOOTING 12 Ice Maker Operation 12 Ice Production 12 Ice Quality...
Use and Care Manual - Page 3
... be pulled forward for servicing if necessary.
■ Installation of the ice maker requires a cold water supply inlet of ¹⁄₄" (6.35 mm) OD soft copper tubing with a shutoff valve and either a gravity-drain system or condensate pump to carry the water to work properly. Location Requirements
■ To ensure proper ventilation for electrical and plumbing...
Use and Care Manual - Page 4
... to lower that side of the ice maker.
■ Turn the leveling leg to the left to raise that have a drain pump installed.
■ The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the ice maker needs to your water pressure, call a licensed, qualified plumber. Move the ice maker to see whether the sediment...
Use and Care Manual - Page 5
... areas where temperatures will go. NOTE: Always drain the water line before making the final connection to the inlet of copper tubing to allow sufficient water flow to meet the water line inlet which reduces water flow and clogs more turns. Leave a coil of the water valve to ice maker B.
Tighten the nut by hand.
Turn shutoff valve ON.
10. Tighten any local codes and...
Use and Care Manual - Page 6
... can result in death, fire, or electrical shock.
1.
Failure to the drain inlet. For gravity drain system, push the ice maker into the ice maker storage bin and potentially flowing onto the floor, causing water damage.
■ Drain lines must have a minimum of 15.88 mm) inside diameter.
■ Drain lines must not have been made.
6 Style 2 - See "Leveling."
4. An Insulation...
Use and Care Manual - Page 7
... the brand badge to the opposite side's bottom corner, keeping the straight side of the end cap facing the front of the ice maker and tighten screws.
3.
Turn the top hinge upside down .
Keep the parts together and set them aside.
3. Move it diagonally to the opposite side's top corner, keeping the straight...
Use and Care Manual - Page 8
.... Fresh water enters the machine for each cycle. ■ Rattling noises may be filtered or treated. Failure to set aside.
2. IMPORTANT: ■ If the water supply to the ice maker is designed to make clear ice from the majority
of the door.
■ Water running continuously. Water is drained after each cycle ends, you may hear a gurgling sound due to the water reservoir may make...
Use and Care Manual - Page 9
... and gaskets with room temperature. For products with tap water and pour it is time to clean your ice maker. With hard water of solution into the water pan. Pour one bottle of 15 to 20 grains/gal. (4 to drain completely.
4.
Water pan thumb screws C. Drain cap
7. When the indicator light turns green (approximately 70 minutes), the cleaning cycle is low or empty.
Use and Care Manual - Page 10
... in the lower access panel and the two
screws from the water pan. Push the selector switch to ON to component failure.
Replace the drain cap securely on the water pan. After the cleaning cycle is loose, water will have either thin ice or no ice. Unplug ice maker or disconnect power. 2. Screws
6. Lift the cutter grid up and out...
Use and Care Manual - Page 11
... the two screws.
15. Gently wipe the control panel with a drain pump installed: ■ Plug in place. Plug in 1 gal. (3.8 L) warm water. After cleaning, make sure that all remaining ice from ice
bin. ■ Pour 1 qt (0.95 L) of the front panel support. Remove all parts and panels before servicing. Pull forward to water valve. Disconnect the inlet and outlet lines...
Use and Care Manual - Page 12
...°C) will empty from the water during the ice making cycle.
■ Is the water in the reservoir overflowing? Clean the drain tube. ■ Is there a kink in the drain tube? Dirt or lint may need cleaning. See "Interior Components" in the "Cleaning" section.
■ Is the drain cap securely in the ice maker? If there is still water in the bin, check to see...
Use and Care Manual - Page 13
..., and services companies. Clean your ice maker. See "Connect Water Supply." NOTE: Service technicians...Referrals to KitchenAid Canada with the ice scoop provided. Make sure that you still need to ...drain hose aligned over the drain? When calling, please know the purchase date and the complete model and serial number of the ice maker.
Ice Quality
Off taste, odor or gray color in the ice...
Use and Care Manual - Page 14
... more comprehensive warranty than the limited warranty that comes with original model/serial numbers that is inconsistent ...water filters. The cost of repair or replacement under this limited warranty. DISCLAIMER OF REPRESENTATIONS OUTSIDE OF WARRANTY
KitchenAid makes... area where service by calling KitchenAid. KITCHENAID® ICE MAKER WARRANTY
THREE YEAR LIMITED WARRANTY (PARTS AND LABOR)...
Parts Diagram - Page 1
CABINET LINER AND DOOR PARTS
For Model: KUIC15NLXS0 (Stainless Steel)
ICE CUBE MAKER
11−10 Litho in I.S.A. (mjb)(bay)
1
Part No. W10356342 Rev.A
Parts Diagram - Page 2
...
25 2185756 Pad, Foam
26 2185691 Channel, Wiring
27 2185964 Grommet,
Edge Guard (2)
28 2185989 Tube, Drain
29 585158 Scoop
Illus. DESCRIPTION
1
Literature Parts
W10206423 Use & Care Guide
W10206442 Service &
Wiring Sheet
... Wrap, Door 13 2217367 Gasket, Bottom 14 489503 Clamp 15 2217294 Gasket, Door
Illus. No. No. Part No. CABINET LINER AND DOOR PARTS
For Model: KUIC15NLXS0...
Parts Diagram - Page 3
EVAPORATOR, ICE CUTTER GRID AND WATER PARTS
For Model: KUIC15NLXS0 (Stainless Steel)
W10356342
3
Parts Diagram - Page 4
...
1 W10163596 Valve, Complete Water
2 2217286 Tube, Plastic 3 488208 Screw 4 2185523 Dispenser, Water 5 W10218037 Evaporator 6 2313705 Pump, Drain 7 2313851 Tube, Reservoir
Pump 8 W10122016 Tube, Water Fill 9 488660 Nut, Speed 10 836667 Spacer 11 2208539 Fastener,
Pushnut 12 489443 Screw 13 2185625 Reservoir,
Water Slide 14 2185626 Tube 15 2313890 Hose, Overflow 16 2313604 Guide−Ice, Grid 17...
Parts Diagram - Page 5
Part No. DESCRIPTION
1 2313628 Pump−Recirculating 2 3400884 Screw 8−18 X 5/8 3 2185677 Cover, Pump 4 2313844 Bracket, Connector
Assembly 5 2313627 Bracket−Pump 6 2313643 Sensor−Water Level 8 2310092 Wiring Harness
Main To Pump 9 2313702 Pump Assembly
5 No. PUMP PARTS
For Model: KUIC15NLXS0 (Stainless Steel)
W10356342
Illus.
Parts Diagram - Page 6
..., Switch
(ALSO ORDER #4) 4 W10282108 Overlay 5 W10226156 Control Board 6 2149705 Switch, Plunger
Grid/Light 7 2187585 Wire Assy 9 745362 Bulb 12 2313633 Thermostat, Bin 13 2185825 Clamp 15 3400884 Screw 18 3400850 Screw 20 2313635 Thermister...
Parts Diagram - Page 9
...
Illus. DESCRIPTION
Parts Not Illustrated and Optional Parts (Not Included)
8171307 Cleaner, Icemaker 503695 Sealer, Cork (1/4 Pound) 797403 Cement, Insulation (1 Oz.) 505587 Sealer,...
978025 Valve, Access (1/4")
978026 Valve, Access (5/16")
978027 Valve, Access (3/8")
978028 Valve, Access (1/2")
978029 Valve, Access (5/8")
978030 Valve, Access (3/4")
ACCESSORIES
Previous Architect Series Handle ...
KitchenAid Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Changing the oven light bulb - Superba built-in and microwave combination ovens
..., both upper and lower lights will come on or off and cool. Architect Series II - Replacing oven light bulbs - Changing the oven light bulb - Built-in oven Changing the oven light bulb - Superba built-in and microwave combination ovens How do I change the oven light bulb? To replace: Before replacing a bulb, make sure the oven is opened... -
Replacing oven light bulbs - Built-in ovens
... Setting the clock Changing the beverage center light bulb How can I replace a bulb(s) if it back into the wall. To replace oven light bulbs: Before replacing any bulbs, make sure the oven is opened . Replace the bulb, using tissue or wearing cotton gloves to the touch. Architect Series II - Superba built-in oven come on when... -
Hidden Options - Built-in oven
... automatically ending at 8. Less than one year 1 to : change the oven temperature between Fahrenheit and Celsius, turn the audible signals and prompts on my built-in ovens Temperature calibration ...- You can make this page Recipient Email * Required Your Email Your Name Hidden Options - Rate answer 1 of 3 Rate answer 2 of 3 Rate answer 3 of options. Architect Series II Sabbath Mode <...
Similar Questions
Icemaker Will Not Stop Making Ice
I have checked the ice sensor and confirmed sensor is clean and clear and made sure machine is indee...
I have checked the ice sensor and confirmed sensor is clean and clear and made sure machine is indee...
(Posted by macbecca5 3 years ago)
Kuic15nlts2 Undercounter Ice Machine.
water outlet and resevoir freez. what is causing the problem. i have replaced the control board and ...
water outlet and resevoir freez. what is causing the problem. i have replaced the control board and ...
(Posted by jlritz58 11 years ago)
Kitchen Aid Kuic15nrts0
Unit keeps making ice and overflowing, suspect Bin Thermostat. Please assist
Unit keeps making ice and overflowing, suspect Bin Thermostat. Please assist
(Posted by gpollinger 11 years ago)
Undercounter Icemaker And Now Is Making Noise And Not Making Ice #kuic18nntsi
(Posted by vijehfundamerica 12 years ago)
Ice Overflow
The machine will not stop making ice when machine is full, it keeps filling with ice and when you op...
The machine will not stop making ice when machine is full, it keeps filling with ice and when you op...
(Posted by gwilliams10 13 years ago)