KitchenAid KUDU03FTPA Support Question
KitchenAid KUDU03FTPA Support Question
Find answers below for this question about KitchenAid KUDU03FTPA - Accepts Custom Panels ARCHITECT II U Series 24.Need a KitchenAid KUDU03FTPA manual? We have 4 online manuals for this item!
Question posted by amyounce on September 19th, 2010
Where Do You Find The Custom Panels For This Dishwasher And Is There A Stainless
The person who posted this question about this KitchenAid product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by anyavnclv on September 19th, 2010 12:27 PM
anyavnclv
Member since:
July 11th, 2010 Points: 1,404,735
Member since:
July 11th, 2010 Points: 1,404,735
I would recommend calling Marcone. They are an appliance part distributor, and will be able to check for you and see if you can order the stainless panels for your appliances.
Order or Part Inquiry
Their phone number is:
You may also email them at the address below.
[email protected]
Order or Part Inquiry
I hope you are able to get the style you wanted!
It will help to have your model number already handy when you call them, but if you cannot locate it a representative will be able to give you suggestions as to where it is located on your appliance.
Good luck!
Related KitchenAid KUDU03FTPA Manual Pages
User Instructions - Page 2
...
WARNING
Tip Over Hazard Do not use .
■ Do not operate the dishwasher unless all enclosure panels are not likely to the washing compartment when removing an old dishwasher from each for electric current. IMPORTANT SAFETY INSTRUCTIONS
WARNING: When using the dishwasher, follow basic precautions, including the following:
■ Read all instructions before using...
User Instructions - Page 4
... well without rinse aid.
■ Rinse aid keeps water from forming droplets that can customize your dishes and dishwasher interior will give good results.
Replace the dispenser cap and
turn the dispenser cap
to ... START/RESUME to the level shown, if needed. ■ Depending on your dishwasher until the indicator level is at the sink nearest your water hardness, fill the...
User Instructions - Page 5
...1:39
2:09
3:30
soiled pots, pans, casseroles, repeatedly pause for several seconds.
You can customize your mind, press the option again to turn off the option, or select a different option....use detergent.
0:10
none
none
You can change your cycle by selecting an option. Your dishwasher may not have all the cycles and options described. and regular tableware.
If you change an...
User Instructions - Page 9
... vinegar rinse may remove white spots and film. Do not use liquid dishwasher detergent on the bottom rack.
Run the dishwasher through a complete washing cycle using an air-dry or an energy-saving dry option.
If your dishwasher has a stainless steel exterior, a stainless steel cleaner is left in the down interior. Vinegar is designed with...
User Instructions - Page 10
... suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of the access panel
Was too much detergent used?
Press down to release.
■ Dishwasher seems to see that detects water temperature, soil and detergent amount. Use a heated drying option for service. Is the right...
User Instructions - Page 12
...be provided by a KitchenAid designated service company.
LIFETIME LIMITED WARRANTY ON STAINLESS STEEL TUB AND INNER DOOR
For the lifetime of the product from ...Customer Interaction Centre 1901 Minnesota Court Mississauga, Ontario L5N 3A7
Please include a daytime phone number in your model and serial number on the label located near the door on the right-hand or left-hand side of the dishwasher...
Installation Instructions - Page 3
...• copper tubing (3/8" recommended) or flexible stainless steel braided fill line
• clamp connector or conduit connector to dishwasher against freezing. Corner locations require a 2" (5.1... parts are within the shaded area shown in dishwasher
• small level
• TORX® T15 screwdriver (if installing custom front panels)
• flashlight
• shallow pan
•...
Installation Instructions - Page 5
...the underside of the dishwasher.
• Connect...8226; A hot water line with dishwashers.
Neer C-500 7/8 inch strain ... water at dishwasher. • 3/8" O.D.
Kit contents include:
-
If connecting dishwasher with a ...If direct wiring dishwasher:
•...be connected to the dishwasher opening. Volex, Inc.,... relief method provided with your dishwasher. air gap
• Use...
Installation Instructions - Page 10
...)
min. Grasp sides of the corner posts.
2. If using a 1/4" hex socket, nut driver or Phillips screwdriver. Tighten elbow until completely installed. Remove panels and set panels aside on top of dishwasher door frame and put dishwasher on its back, resting on a protective surface.
4. If the wheels are removed, protect the floor when moving the...
Installation Instructions - Page 11
... set screws in place on some models)
IMPORTANT: Do not scratch the front panel during this procedure. 1. Retain Allen wrench with a factory-supplied stainless or painted full front panel: 1.
This will hold the outer panel up to prevent their movement when the dishwasher is operated. NOTE: Shims must be securely attached to floor to proper...
Installation Instructions - Page 12
... wood panel accordingly. For dishwashers with the control panel shown below : (Models KUDC03IT, KUDK03IT and KUDL03IT)
2 screws
align top edges
1-3/8"screw
10. Not recommended for 4" (10.2 cm) toe kick. Tighten the two side screws reinstalled in the top corners, as shown.
If the installation needs a higher toe kick, adjust the height of "Install custom panel...
Installation Instructions - Page 13
....2 cm)
mark line
top edge
5. Drill 3/32" pilot holes 1/2" (13 mm) deep in customer-supplied custom panel. Attach the panel assembly to the door by reinstalling the three screws on a protective, non-scratching surface.
10. Install custom panel
Option 1: For models KUDS03FTPA and KUDU03FTPA
NOTE: The handle for the screws heads to be flush with the four...
Installation Instructions - Page 14
... six side screws reinstalled in customer-supplied custom panel.
6.
Lay the cutomer-supplied custom panel face down on both panels are for toe kicks greater than 14 pounds (6.3 kg) and must be made to side. Attach outer panel to attach custom panels. Not recommended for frameless custom panel models with the top of the customer-supplied custom panel with a 4-inch (10.2 cm) console...
Installation Instructions - Page 16
... front of the hole in position, you are secured.
16 Check that it does not touch dishwasher
motor or lower part of the door panel.
2. You need to adjust alignment to connect your cabinets.
Level the dishwasher
1. Place level against top front
opening . If you may have the correct electrical supply and recommended...
Installation Instructions - Page 19
... the floor, you will open to fit around the obstacle.
3. Check that grounding clip is attached to the lower panel. 2. Do not remove ground prong. Fold up behind the door and the dishwasher front legs, as it out of the plastic bag.
2. Make sure the vinyl pad is facing up into a grounded...
Parts Diagram - Page 1
W10312182 Rev. A No. FRONT PANEL PARTS
For Model: KUDD03STPA2
(Panel−Ready)
DRAWER DISHWASHER
Illus. Part No. DESCRIPTION
1
Literature Parts
W10155577 Instructions,
Installation
W10208033 Energy Guide
2
Control Panel
(Includes User
Interface)
W10117977 Black
3 W10117987 Intermediate Panel
4 W10117969 Harness, User
Interface
5 Y912620 Screw
1
Part No.
Parts Diagram - Page 3
... Pump 20 W10120019 Sensor, Turbidity 21 99002651 O−Ring, Turbidity
Sensor 22 99003773 Solenoid, Fine
Drain 23 99003727 H Bracket 24 99003701 Bracket,
Thermostat 25 99003624 Fuse, Thermal
Illus. No. Part No. DESCRIPTION
26 99003623 Thermostat, High Limit
27 99001979 ... Seal 37 W10143258 Leg, Leveling
3
W10312182 Part No. TUB PARTS
For Model: KUDD03STPA2
(Panel−Ready)
Illus.
Parts Diagram - Page 5
No. WASH SYSTEM PARTS
For Model: KUDD03STPA2 (Panel−Ready)
Illus. Part No. DESCRIPTION
1 W10118042 Wash Arm Assembly 2 99003697 Cap, Wash Arm 3 W10190556 Filter Flowplate
Assembly 4 Y6918536 Screw 5 99003720 ... O−Ring 20 99003683 Manifold, Upper
Assembly 21 99003771 Nut, Heater 22 99003704 Shield, Fine
Filter 23 596669 Clamp, Manifold 24 99003697 Pivot, Wash Arm
5
W10312182
Parts Catalog - Page 1
...
For Model: KUDU03FTPA0
(Panel Ready)
UNDERCOUNTER DISHWASHER
Illus. No. DESCRIPTION
1
Literature Parts
W10078153 Instructions,
Installation
W10111124 Energy Guide
8574093 Guide, Use & Care
W10077824 Guide, Consumer
Reference
W10082651 Tech Sheet
2
Arm, Hinge
8534854 Left
8534853 Right
3 8564886 Stiffener, Door
4 8535133 Panel, Front
5
Access Panel
8573255 Black
6 8269016...
Parts Catalog - Page 16
... 8171656 White 8171657 Black 8171658 Biscuit 8171659 Stainless Steel
Custom Panel & Trim Kit 8212489 Black
Towel Bar Handle Kit W10188988 Stainless Steel W10188990 Black W10188991 White
Drain Hose 3385556 12 Ft.
Part No. Hardware)
ANTI−...
PAINT, BULK (1 qt.)
799344 White (Uncut) 4392900 Biscuit
Illus. OPTIONAL PARTS (NOT INCLUDED)
For Model: KUDU03FTPA0 (Panel Ready)
Illus. No.
KitchenAid Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Removing or replacing my refrigerator handles - French door refrigerators
... - Style 2 - See Plastic Handle graphics 1 and 2. Custom panel installation for removing and replacing the handles. Rotate the handle so that the mounting clips are... on each end of stainless steels. See picture below for French-door refrigerator (Model KFCO22EVBL) Purchasing replacement parts or accessories KFCO22EVBL panel size Different types of ... -
Custom panel installation for French-door refrigerator (Model KFCO22EVBL)
... to flush with all French Door custom panels. Control Panels on the French-door refrigerator trim model (Model KFCO22EVBL)? How are panels installed on the KUDA03CT, KUDB03CT, KUDS03CT, KUDW03CT, KUDS03FT, KUDS03FTPA, and KUDS03ST Purchasing replacement parts or accessories See Use and Care Guide for opposite side of stainless steels. Lift upper locking trim... -
KFCO22EVBL panel size
...size are the panels for the KFCO22EVBL? Decorator panel dimensions Weight Requirements For Panel Inserts Individual refrigerator door panels should not exceed 15 lbs. (7 kg.) Freezer drawer panel should not exceed 15 lbs. (7kg.) *For ease of installation cut backer panel corners at 45 degree - 1" x 1". Suggested panel assembly methods Click here to view Custom Panel Installation Instructions...
Similar Questions
Custom Door Panel Size
If the kitchen cabinets are frameless with a 4 1/4" toekick. Would my Dishwasher Panel for the KDTM3...
If the kitchen cabinets are frameless with a 4 1/4" toekick. Would my Dishwasher Panel for the KDTM3...
(Posted by Shannonmoody 3 years ago)
Horsepower On This Dishwasher
What is the horsepower on this dishwasher? Can stainless steelpanels be purchased for this dishwashe...
What is the horsepower on this dishwasher? Can stainless steelpanels be purchased for this dishwashe...
(Posted by luvmyyorkiealot 6 years ago)
How Do I Reset The Control Panel?
how do i reset the control panel?
how do i reset the control panel?
(Posted by Anonymous-150376 9 years ago)
Need Template For Installing Custom Door Panel On New Kitchenaid Dishwasher
just purchased the KitchenAid W10579129A dishwasher and can not find the template for installing a c...
just purchased the KitchenAid W10579129A dishwasher and can not find the template for installing a c...
(Posted by rpgibson6 9 years ago)
My Dishwasher Stainless Steel Front Has Rust Pit Marks?
(Posted by ajmaceach 12 years ago)