KitchenAid KUDS30FXSS Support Question
KitchenAid KUDS30FXSS Support Question
Find answers below for this question about KitchenAid KUDS30FXSS.Need a KitchenAid KUDS30FXSS manual? We have 4 online manuals for this item!
Question posted by petecPothea on April 4th, 2014
How To Reset Kuds30fxss
The person who posted this question about this KitchenAid product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related KitchenAid KUDS30FXSS Manual Pages
Dimension Guide - Page 1
...specifications without notice.
(1.9
cm) A
Page 1 of
the counter, or be connected
to the dishwasher opening.
A timedelay fuse or circuit breaker and separate circuit is 24" (60 cm) not ...trap in accordance with your home and local codes and ordinances.
If direct wiring dishwasher: Use flexible, armored or nonmetallic, sheathed copper wire with product. Make sure...
Dimension Guide - Page 2
Measured from narrowest point of opening.
(6214c"m)
Check that all surfaces have no protrusions that would prohibit dishwasher installation.
(61E2c4m" )
(86m.344icn"m)
D
(10.42"cm) (7.63"cm)
(17.2 cm) (4.4 cm)
(6.4 cm)
(26.7 cm) (15.9 cm)
CAlreeaar
(4.4 cm)
(5.12"cm)
Because Whirlpool Corporation policy ...
Installation Guide - Page 2
... Prepare and Route Water Line 8 Install Drain Hose 10 Install Moisture Barrier 11 Prepare Dishwasher 11 Make Power Supply Cord Connection 12 Determine Cabinet Opening 13
Installation Instructions (cont.) ... 14 Custom Panel Dimensions 14 Install Custom Panel 15 Choose Attachment Option 17 Move Dishwasher Into Cabinet Opening 17 Connect to Water Supply 19 Connect to :
• Slowly...
Installation Guide - Page 3
... tape is a registered trademark of Saturn Fasteners, Inc.
counter
custom
(1 large and
head
mounting tape
1 small)
screws (2) brackets (top)
Parts needed :
Additional parts supplied with
dishwasher
MSailkveersuGrreeaelnl these parts are included in plumbing supply stores. If parts are used for only ³⁄₄" thick wooden panel. INSTALLATION REQUIREMENTS
Tools and...
Installation Guide - Page 4
...wires and drain hose are within the shaded area shown in the dishwasher opening ). Do not run drain lines, water lines or electrical wiring where they can interfere ...(example: Flooring extends only partway into opening is not level with or contact dishwasher motor or legs. NOTE: To avoid shifting during dishwasher operation, shims must provide:
• easy access to water, electricity and drain...
Installation Guide - Page 5
... the lowest point on all models)
3 "-4 " (8.8 cm -10.6 cm)
3" (9.4 cm)
(532.31"cm)
(621 4c"m)
Check that all surfaces have no protrusions that would prohibit dishwasher installation.
(61E2c4m" )
NOTE: Shaded areas of opening.
(10.42"cm) (7.63"cm)
(17.2 cm) (4.4 cm)
(6.4 cm)
(26.7 cm) (15.9 cm)
CAlreeaar
(4.4 cm)
(5.12"cm)
5 Minimum...
Installation Guide - Page 6
...If required, the air gap, should be needed to connect to an air gap. If connecting dishwasher with direct wiring: • Use flexible, armored or nonmetallic sheathed, copper wire with grounding ... pressure can be verified by a licensed plumber.
• 120°F (49°C) water at dishwasher O.D. Drain Requirements
• A new drain hose is supplied with your home and local codes and...
Installation Guide - Page 7
... a 1¹⁄₂" (3.8 cm) hole in death or electrical shock.
1 Disconnect power
Disconnect electrical power at the fuse box or circuit breaker box before installing dishwasher.
2
3 Do you use? Power Supply Cord: Follow Option A instructions
Direct Wire: Follow Option B instructions
Option A, Power Supply Cord: NOTE: A grounded 3 prong outlet is required inside...
Installation Guide - Page 8
... the cable into cabinet opening ).
This will prohibit cable from moving when dishwasher is in area shown.
not provided).
8
Hot water line
Measure overall ... with grommet (Part Number 302797 -
Option B, Direct Wire:
Helpful Tip: Wiring the dishwasher will make water connection easier.
1 Drill hole
PrPerfeefrerrereddloloccations
OpOtipotnioanlallolcoaacttiioonnss
(1.3 cm)
Drill a &#...
Installation Guide - Page 9
...far enough into the cabinet opening to connect it does not touch the dishwasher base, frame or motor.
6 Add 90° elbow fitting to the
water supply line
Slowly... operation, route the water supply line so that the ³⁄₄" connection is a registered trademark of the dishwasher.
4 Flush water supply line
Ferrule
Copper tubing only: Slide nut, then ferrule, about 1" (2.5 cm) onto ...
Installation Guide - Page 10
... in cabinet to the front center of the hose, keep the hose away from moving when dishwasher is required.
1 Drill hole
Option A, Waste disposer - Helpful Tip: To reduce vibration of...be made before the drain trap and at least 20" (50.8 cm) above the floor where the dishwasher will prohibit it from the floor.
2
2. no air gap
SLcarregwe-tsyilpveer drainchlaomsep clamp Waste tee
Drain hose...
Installation Guide - Page 11
...silver drain hose clamp (provided). Attach drain hose to do so can result in back or other injury.
1 Put dishwasher on open and
move into position. Use a rubber hose (not provided) with air gap
Waste disposer - Excessive ...gap and cut if needed . (Do not cut , use dishwasher until completely installed. Use pliers to 5 cm) screw-type clamp (not provided).
5. Connect black end ...
Installation Guide - Page 12
...
Using a ¹⁄₄" hex head socket, nut driver or Phillips screwdriver, remove terminal box cover.
Strain relief is provided with a towel to connect your dishwasher. Power Supply Cord: Follow Option A instructions
Direct Wire: Follow Option B instructions
NOTE: If using Option B, proceed to "Determine Cabinet Opening," to continue with power supply...
Installation Guide - Page 13
... into outlet until instructed to secure cover. Measure height of cabinet opening
NOTE: Twist on strain relief
Electrical Shock Hazard Electrically ground dishwasher. Failure to floor where dishwasher will need to "Dishwasher Height Adjustment Chart" for animated representation of the green ground wire.
Insert tabs on the underside of turns needed , see website...
Installation Guide - Page 14
...Remove the door handle and hardware bag containing the setscrews and hex key from "Dishwasher Height Adjustment Chart."
3 Built-up Floors-Add
shims as needed
(140."1 cm)
(52c"m)
(7... of handle)
Hex key
IMPORTANT: Do not scratch the front panel during this procedure. Dishwasher Height Adjustment Chart
Minimum
Wheel Number of turns Perforation
cutout height position on front leg on...
Installation Guide - Page 15
...panel inside dotted line. Excessive Weight Hazard
Use two or more people, stand the dishwasher up.
Not recommended for the screws heads to be flush with control panel on the... provided attached it is attached from drilling through panel. Failure to avoid damage from moisture.
Dishwashers with the panel. Make sure that a cabinetmaker cut the customer panel because of the panel...
Installation Guide - Page 17
... Opening
Excessive Weight Hazard Use two or more people to move and install dishwasher. Use 2 or more people to move and install dishwasher.
Choose Attachment Option
Excessive Weight Hazard
Use two or more people to move and install dishwasher. Option 2, Dishwasher side attachment: NOTES: • Remove the brackets from falling into slot on the...
Installation Guide - Page 18
...to prohibit them from tipping, open -
Reattach door spring to rear leg. Tilt dishwasher backward on wheels and move dishwasher close the door a few times. NOTE: Do not push on the front of..., unhook the spring from the tensioner. Increase spring tension
When door is near the center of dishwasher should be adjusted.
4 Closes too quickly- If the door closes by itself , move the ...
Installation Guide - Page 19
... Do not kink or pinch water line, drain hose, power supply cord or direct wire between dishwasher and cabinet. Do not remove insulation blanket - Close and latch the door, and place level ...Damage to -side. Check that leveling legs are firmly against the front panel.
Slowly move dishwasher completely into cabinet
opening . NOTES: • It is properly seated in the opening
Insulation...
Use & Care Guide - Page 10
... will not start or resume a wash cycle
To reset any control selections made.
A series of bars will be blue if the dishwasher is interrupted, the START/RESUME indicator flashes. Press CANCEL/DRAIN twice to Step 2).
2.
See "Canceling A Cycle After Dishwasher Is Started" and "Changing a Cycle After Dishwasher is blinking, see "Troubleshooting" section.
The light...
KitchenAid Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
The lights in my under-counter refrigerator do not work
... control to not work What can cause the light bulb in my under -counter refrigerator, click here Reconnect the refrigerator to the electrical supply and reset the refrigerator control. -
Compactor drawer won't open
...): Turn the key-knob (key-switch) to your model number. Is the Solid cycle engaged? For additional information, refer to Start and release. If you reset by entering your Use and Care Guide, find it on models with push button controls: Press Off, and then press On. To raise the ram... -
Washer will not fill - Front-load washer
... a normal pause in this is on water and check for proper fill. Is the washer door firmly shut? Are the shipping bolts removed? If so, reset the circuit breaker or Ground Fault Circuit Interrupter. Check the household faucets to occur, call an electrician. Remove any accumulated film or particles. The door...
Similar Questions
How To Reset Control On Kitchenaid Dishwasher Kuds30fxss
(Posted by ameBelv 9 years ago)
How To Reset Kitchenaid Dishwasher Kudl15fxss 2
(Posted by littdocroc 9 years ago)
How To Reset Kitchenaid Kuds30fxss After Power Outage
(Posted by bawvilif 10 years ago)